SearcharxivSearch

arXiv subjects

Masayuki Shirane

Publications and source records attributed to Masayuki Shirane.

9 recordsLinked to original sources

Spin Model for Quantum Annealing with Kerr Parametric Oscillators

Coherent states offer a promising path for near-term quantum computing due to their inherent protection against bit-flip noise. However, their large photon numbers can be challenging for numerical simulation. This paper introduces an effective model, representing coherent-state quantum annealing using spin-1/2 degrees of freedom. We demonstrate that this model yields accurate predictions for realistic experimental settings and can therefore serve as a practical tool for optimizing future quantum hardware.

quant-ph

Change in bit-flip times of Kerr parametric oscillators caused by their interactions

We experimentally investigate how interactions between Kerr parametric oscillators (KPOs) degrade their bit-flip times, where a bit flip is defined as a transition between the two degenerate ground states of a KPO. Interactions between KPOs cause quantum states of KPOs to leak outside the computational subspace, leading to bit flips. Bit flips degrade fidelity and pose a significant problem for KPO-based quantum information processing. We performed an experiment in which a weak microwave signal is injected into one KPO to emulate photon injection from another KPO, and find that the bit-flip time decreases by an order of magnitude due to induced excitations, depending on the frequency and power of the injected signal. Methods to mitigate the decrease in bit-flip times caused by interactions between KPOs are discussed, including adjusting the pump frequencies, coherent-state amplitudes, and couplings between KPOs. These findings provide valuable insights for scaling up KPO-based quantum computers.

quant-ph

Four-body interactions in Kerr parametric oscillator circuits

We theoretically present new unit circuits of Kerr parametric oscillators (KPOs) with four-body interactions, which enable the scalable embedding of all-to-all connected logical Ising spins using the Lechner-Hauke-Zoller (LHZ) scheme. These unit circuits enable four-body interactions using linear couplers, making the circuit fabrication and characterization much simpler than those of conventional unit circuits with nonlinear couplers. Numerical calculations indicate that the magnitudes of the coupling constants can be comparable to those in conventional circuits. On the basis of this theory, we designed a four-KPO circuit and experimentally confirmed the four-body correlation by measuring the pump-phase dependence of the parity of the four-KPO states. We show that the choice of the pump frequencies are important not only to enable the four-body interaction, but to cancel the effects of other unwanted interactions. Using the circuit, we demonstrated the quantum annealing based on the LHZ scheme, where the strength of the interaction between the logical Ising spins is mapped to the local field and controlled by a coherent drive applied to each KPO.

quant-ph

Resonance fluorescence spectra of a driven Kerr nonlinear resonator

Resonance fluorescence spectra of a driven Kerr nonlinear resonator is investigated both theoretically and experimentally. When the Kerr nonlinear resonator is driven strongly such that the induced Rabi frequency is comparable to or larger than the Kerr nonlinearity, the system cannot be approximated as a two-level system. We theoretically derive characteristic features in the fluorescence spectra such as the decrease of the center-peak intensity and the asymmetric sideband peaks in the presence of finite dephasing. Those features are consistently explained by the population of the initial dressed state and its transition matrix element to the final dressed state of the transition corresponding to each peak. Finally, we experimentally measure the resonance fluorescence spectra of a driven superconducting Kerr nonlinear resonator and find a quantitative agreement with our theory.

quant-ph

Spectroscopy of flux-driven Kerr parametric oscillators by reflection coefficient measurement

We report the spectroscopic characterization of a Kerr parametric oscillator (KPO) based on the measurement of its reflection coefficient under a two-photon drive induced by flux modulation. The measured reflection spectra show good agreement with numerical simulations in term of their dependence on the two-photon drive amplitude. The spectra can be interpreted as changes in system's eigenenergies, transition matrix elements, and the population of the eigenstates, although the linewidth of the resonance structure is not fully explained. We also show that the drive-amplitude dependence of the spectra can be explained analytically by using the concepts of Rabi splitting and the Stark shift. By comparing the experimentally obtained spectra with theory, we show that the two-photon drive amplitude at the device can be precisely determined, which is important for the application of KPOs in quantum information processing.

quant-ph

Investigation of the spectral triplet in strongly coupled quantum dot-nanocavity system

We experimentally investigated the excitation power dependence of a strongly coupled quantum dot (QD)-photonic crystal nanocavity system by photoluminescence (PL) measurements. At a low-excitation power regime, we observed vacuum Rabi doublet emission at QD-cavity resonance condition. With increasing excitation power, in addition to the doublet, a third emission peak appeared. This observed spectral change is unexpected from conventional atomic cavity quantum electrodynamics. The observations can be attributed to featured pumping processes in the semiconductor QD-cavity system.

cond-mat.other

Mode identification of high-quality-factor single-defect nanocavities in quantum dot-embedded photonic crystals

We investigate the quality (Q) factor and the mode dispersion of single-defect nanocavities based on a triangular-lattice GaAs photonic-crystal (PC) membrane, which contain InAs quantum dots (QDs) as a broadband emitter. To obtain a high Q factor for the dipole mode, we modulate the radii and positions of the air holes surrounding the nanocavity while keeping six-fold symmetry. A maximum Q of 17,000 is experimentally demonstrated with a mode volume of V=0.39(lambda/n)^3. We obtain a Q/V of 44,000(n/lambda)^3, one of the highest values ever reported with QD-embedded PC nanocavities. We also observe ten cavity modes within the first photonic bandgap for the modulated structure. Their dispersion and polarization properties agree well with the numerical results.

cond-mat.mtrl-sci

Immittance Matching for Multi-dimensional Open-system Photonic Crystals

An electromagnetic (EM) Bloch wave propagating in a photonic crystal (PC) is characterized by the immittance (impedance and admittance) of the wave. The immittance is used to investigate transmission and reflection at a surface or an interface of the PC. In particular, the general properties of immittance are useful for clarifying the wave propagation characteristics. We give a general proof that the immittance of EM Bloch waves on a plane in infinite one- and two-dimensional (2D) PCs is real when the plane is a reflection plane of the PC and the Bloch wavevector is perpendicular to the plane. We also show that the pure-real feature of immittance on a reflection plane for an infinite three-dimensional PC is good approximation based on the numerical calculations. The analytical proof indicates that the method used for immittance matching is extremely simplified since only the real part of the immittance function is needed for analysis without numerical verification. As an application of the proof, we describe a method based on immittance matching for qualitatively evaluating the reflection at the surface of a semi-infinite 2D PC, at the interface between a semi-infinite slab waveguide (WG) and a semi-infinite 2D PC line-defect WG, and at the interface between a semi-infinite channel WG and a semi-infinite 2D PC slab line-defect WG.

cond-mat.mtrl-sci

Systematic Design of Antireflection Coating for Semi-infinite One-dimensional Photonic Crystals Using Bloch Wave Expansion

We present a systematic method for designing a perfect antireflection coating (ARC) for a semi-infinite one-dimensional (1D) photonic crystal (PC) with an arbitrary unit cell. We use Bloch wave expansion and time reversal symmetry, which leads exactly to analytic formulas of structural parameters for the ARC and renormalized Fresnel coefficients of the PC. Surface immittance (admittance and impedance) matching plays an essential role in designing the ARC of 1D PC's, which is shown together with a practical example.

cond-mat.mtrl-sci