Searcharxiv⌕ Search

arXiv subjects

Massimiliano Fiorini

Publications and source records attributed to Massimiliano Fiorini.

6 recordsLinked to original sources

Development and characterization of hybrid MCP-PMT with embedded Timepix4 ASIC used as pixelated anode

We present a novel single-photon detector based on a vacuum tube incorporating a photocathode, a microchannel plate (MCP), and a Timepix4 CMOS ASIC functioning as a pixelated anode. Designed to handle photon rates up to 1 billion per second across a 7 cm$^2$ active area, the detector achieves outstanding spatial and temporal resolutions of 5-10 $μ$m and below 50 ps r.m.s., respectively. The Timepix4 ASIC comprises approximately 230,000 pixels, each integrating analog and digital front-end electronics. This enables data-driven acquisition and supports data transmission rates up to 160 Gb/s. External FPGA-based electronics manage both configuration and readout. In order to test the timing performance of the Timepix4 ASIC we performed preliminary characterization of an assembly bonded to a 100 $μ$m thick n-on-p silicon sensor using a pulsed infrared laser, which demonstrated a per-pixel timing resolution of 110 ps, with cluster-based averaging methods improving to below 50 ps. Six prototype detectors incorporating different MCP stack configurations and end-spoiling depths were produced by Hamamatsu Photonics. We report on their characterization, including dark count rates, gain, and spatial and timing resolutions, assessed both in laboratory conditions and during a test-beam campaign at CERN's SPS facility.

physics.ins-det↗

A response matrix determined with a coincidence-based acquisition for correction of charge sharing spectral distortions in energy-resolved photon counting detectors

A model-independent method is proposed to characterize and correct charge sharing spectral distortions in energy-resolved X-ray acquisitions with pixellated photon-counting detectors. The technique is based on the determination of a coincidence-based response matrix (CBRM) through a preliminary calibration with a uniform irradiation and an arbitrary polychromatic spectrum. The calibration requires the collection of the number of coincidences between a reference pixel and its neighbours for different combinations of energy bins, in order to calculate a set of charge sharing probabilities which are independent of the input spectrum. A detector response matrix is determined, which can afterwards be applied to correct other spectra acquired with the same detector and a conventional multi-comparator electronics, without introducing penalties in terms of processing time. The technique was validated with Geant4 simulations of a 1 mm thick CdTe detector and with data collected with a pixel hybrid detector made of a 300 um thick silicon sensor coupled to a Timepix4 ASIC chip. The differences between the reconstructed spectra and reference distributions of an ideal detector or a 3x3 offline clustering algorithm were evaluated in terms of mean absolute percentage errors. It is demonstrated that the response matrix can restore the spectral information with a performance close to standard clustering algorithms and is less affected by noise artifacts than analog charge summing techniques.

physics.ins-det↗

Luminosity measurement with the LHCb RICH detectors in Run 3

The LHCb Ring-Imaging Cherenkov detectors are built to provide charged hadron identification over a large range of momentum. The upgraded detectors are also capable of providing an independent measurement of the luminosity for the LHCb experiment during LHC Run 3. The modelling of the opto-electronics chain, the application of the powering strategy during operations, the calibration procedures and the proof of principle of a novel technique for luminosity determination are presented. In addition, the preliminary precision achieved during the 2023 data-taking year for real-time and offline luminosity measurements is reported.

hep-ex↗

DataPix4: A C++ framework for Timepix4 configuration and read-out

DataPix4 (Data Acquisition for Timepix4 Applications) is a new C++ framework for the management of Timepix4 ASIC, a multi-purpose hybrid pixel detector designed at CERN. Timepix4 consists of a matrix of 448x512 pixels that can be connected to several types of sensors, to obtain a pixelated detector suitable for different applications. DataPix4 can be used both for the full configuration of Timepix4 and its control board, and for the data read-out via slow control or fast links. Furthermore, it has a flexible architecture that allows for changes in the hardware, making it easy to adjust the framework to custom setups and exploit all classes with minimal modification.

physics.ins-det↗

Timing resolution performance of Timepix4 bump-bonded assemblies

The timing performance of the Timepix4 application-specific integrated circuit (ASIC) bump-bonded to a $100\;μ\textrm{m}$ thick n-on-p silicon sensor is presented. A picosecond pulsed infrared laser was used to generate electron-hole pairs in the silicon bulk in a repeatable fashion, controlling the amount, position and time of the stimulated charge signal. The timing resolution for a single pixel has been measured to $107\;\textrm{ps}$ r.m.s. for laser-stimulated signals in the silicon sensor bulk. Considering multi-pixel clusters, the measured timing resolution reached $33\;\textrm{ps}$ r.m.s. exploiting oversampling of the timing information over several pixels.

physics.ins-det↗

Investigation of the burst phenomenon in SiPMs at liquid nitrogen temperature

Burst effect of Silicon Photomultiplier (SiPM) at cryogenic temperatures have been discovered few years ago looking at the dark count rate of SiPMs at liquid nitrogen temperatures. Bursts are trains of single signals that happen randomly and are clearly distinguishable from the primary DCR and correlated noise because of their particular time distribution. In this article we describe a detailed study related to both the external causes that triggers bursts and to the phenomenon, internal to the sensor, that produces this dark signals. We related the burst occurrence to the luminescence produced by some trapping centers in the SiPMs when they are excited by ionizing radiation that impinges on the sensor.

hep-ex↗