arXiv subjects

Mathieu Féchant

Publications and source records attributed to Mathieu Féchant.

9 recordsLinked to original sources

arXiv2026

Probing the memory of a superconducting qubit environment

Achieving fault tolerance with superconducting quantum processors requires qubits to operate within the regime of threshold theorems based on the Born-Markov approximation. This approximation, which models dissipation as constant energy decay into a memoryless environment, breaks down when qubits couple to long-lived two-level systems (TLSs) that become polarized during operation and retain memory of past qubit states. Here, we show that non-Poissonian quantum jump traces carry the information required to distinguish long-lived TLSs from the standard Markovian bath. By fitting the Solomon equations to measured quantum jumps dynamics arising naturally due to thermal fluctuations, we can disentangle the coupling of the qubit to the two environments. Sweeping the qubit frequency reveals distinct peaks, each associated with a TLS that outlives the qubit, providing a handle to understand their microscopic origin.

quant-ph↗

arXiv2026

Offset Charge Dependence of Measurement-Induced Transitions in Transmons

A key challenge in achieving scalable fault tolerance in superconducting quantum processors is readout fidelity, which lags behind one- and two-qubit gate fidelity. A major limitation in improving qubit readout is measurement-induced transitions, also referred to as qubit ionization, caused by multiphoton qubit-resonator excitation occurring at specific photon numbers. Since ionization can involve highly excited states, it has been predicted that in transmons -- the most widely used superconducting qubit -- the photon number at which measurement-induced transitions occur is gate charge dependent. This dependence is expected to persist deep in the transmon regime where the qubit frequency is gate charge insensitive. We experimentally confirm this prediction by characterizing measurement-induced transitions with increasing resonator photon population while actively stabilizing the transmon's gate charge. Furthermore, because highly excited states are involved, achieving quantitative agreement between theory and experiment requires accounting for higher-order harmonics in the transmon Hamiltonian.

quant-ph↗

arXiv2025

On-chip stencil lithography for superconducting qubits

Improvements in circuit design and more recently in materials and surface cleaning have contributed to a rapid development of coherent superconducting qubits. However, organic resists commonly used for shadow evaporation of Josephson junctions (JJs) pose limitations due to residual contamination, poor thermal stability and compatibility under typical surface-cleaning conditions. To provide an alternative, we developed an inorganic SiO$_2$/Si$_3$N$_4$ on-chip stencil lithography mask for JJ fabrication. The stencil mask is resilient to aggressive cleaning agents and it withstands high temperatures up to 1200°C, thereby opening new avenues for JJ material exploration and interface optimization. To validate the concept, we performed shadow evaporation of Al-based transmon qubits followed by stencil mask lift-off using vapor hydrofluoric acid, which selectively etches SiO$_2$. We demonstrate average $T_1 \approx 75 \pm 11 μ$s over a 200 MHz frequency range in multiple cool-downs for one device, and $T_1 \approx 44\pm 8 μ$s for a second device. These results confirm the compatibility of stencil lithography with state-of-the-art superconducting quantum devices and motivate further investigations into materials engineering, film deposition and surface cleaning techniques.

quant-ph↗

arXiv2025

Simultaneous sweet-spot locking of gradiometric fluxonium qubits

Efforts to scale up superconducting processors that employ flux-qubits face numerous challenges, among which is the crosstalk created by neighboring flux lines, which are necessary to bias the qubits at the zero-field and $Φ_0/2$ sweet spots. A solution to this problem is to use symmetric gradiometric loops, which incorporate a flux locking mechanism that, once a fluxon is trapped during cooldown, holds the device at the sweet spot and limits the need for active biasing. We demonstrate this technique by simultaneously locking multiple gradiometric fluxonium qubits in which an aluminum loop retains the trapped fluxon indefinitely. By compensating the inductive asymmetry between the two loops of the design, we are able to lock the effective flux-bias within $Φ_{eff} = -3 \times 10^{-4} Φ_0$ from the target, corresponding to only 15 % degradation in $T_{2,E}$ when operated in zero external field. The design strategy demonstrated here reduces integration complexity for flux qubits by minimizing cross-talk and potentially eliminating the need for local flux bias.

quant-ph↗

arXiv2022

Quantum bath engineering of a high impedance microwave mode through quasiparticle tunneling

We demonstrate a new approach to dissipation engineering in microwave quantum optics. For a single mode, dissipation usually corresponds to quantum jumps, where photons are lost one by one. Here, we are able to tune the minimal number of lost photons per jump to be two (or more) with a simple dc voltage. As a consequence, different quantum states experience different dissipation. Causality implies that the states must also experience different energy shifts. Our measurements of these Lamb shifts are in good agreement with the predictions of the Kramers-Kronig relations for single quantum states in a regime of highly non-linear bath coupling. This work opens new possibilities for quantum state manipulation in circuit QED, without relying on the Josephson effect.

quant-ph↗

arXiv2021

Observation of topological valley Hall edge states in honeycomb lattices of superconducting microwave resonators

We have designed honeycomb lattices for microwave photons with a frequency imbalance between the two sites in the unit cell. This imbalance is the equivalent of a mass term that breaks the lattice inversion symmetry. At the interface between two lattices with opposite imbalance, we observe topological valley edge states. By imaging the spatial dependence of the modes along the interface, we obtain their dispersion relation that we compare to the predictions of an ab initio tight-binding model describing our microwave photonic lattices.

physics.app-ph↗

arXiv2021

Bulk properties of honeycomb lattices of superconducting microwave resonators

We have realized different honeycomb lattices for microwave photons in the 4 to 8 GHz band using superconducting spiral resonators. Each lattice comprises a few hundred sites. Two designs have been studied, one leading to two bands touching at the Dirac points and one where a gap opens at the Dirac points. Using a scanning laser technique to image the eigenmodes of this new type of photonic lattices, we are able to reconstruct their band structure. The measured bands are in excellent agreement with ab initio models that combine numerical simulations of the electromagnetic properties of the spiral resonator and analytical calculations.

physics.app-ph↗

arXiv2019

High Kinetic Inductance Microwave Resonators Made by He-Beam Assisted Deposition of Tungsten Nanowires

We evaluate the performance of hybrid microwave resonators made by combining sputtered Nb thin films with Tungsten nanowires grown with a He-beam induced deposition technique. Depending on growth conditions the nanowires have a typical width $w\in[35-75]$~nm and thickness $t\in[5-40]$~nm. We observe a high normal state resistance $R_{sq}\in [65-150]$ $Ω/sq$ which together with a critical temperature $T_c\in[4-6]~K$ ensure a high kinetic inductance making the resonator strongly nonlinear. Both lumped and coplanar waveguide resonators were fabricated and measured at low temperature exhibiting internal quality factors up to $3990$ at $4.5$~GHz in the few photon regime. Analyzing the wire length, temperature and microwave power dependence we extracted a kinetic inductance for the W nanowire of $L_K\approx15$ pH/sq, which is 250 times higher than the geometrical inductance, and a Kerr non-linearity as high as $K_{W,He}/2π=200 \pm 120$~Hz/photon at $4.5$~GHz. The nanowires made with the helium focused ion beam are thus versatile objects to engineer compact, high impedance, superconducting environments with a mask and resist free direct write process.

cond-mat.mes-hall↗

arXiv2018

Observation of the Unconventional Photon Blockade in the Microwave Domain

We have observed the unconventional photon blockade effect for microwave photons using two coupled superconducting resonators. As opposed to the conventional blockade, only weakly nonlinear resonators are required. The blockade is revealed through measurements of the second order correlation function $g^{(2)}(t)$ of the microwave field inside one of the two resonators. The lowest measured value of $g^{(2)}(0)$ is 0.4 for a resonator population of approximately $10^{-2}$ photons. The time evolution of $g^{(2)}(t)$ exhibits an oscillatory behavior, which is characteristic of the unconventional photon blockade.

quant-ph↗