arXiv subjects
Publications and source records attributed to Matthew J. Basso.
In order to stimulate new engagement and trigger some concrete studies in areas where further work would be beneficial towards fully understanding the physics potential of an $e^+e^-$ Higgs / Top / Electroweak factory, we propose to define a set of focus topics. The general reasoning and the proposed topics are described in this document.
This paper describes a preliminary study of a gaseous Ring Imaging Cherenkov (RICH) system capable of discriminating between kaons and pions at high momenta -- up to 50 GeV/c -- and thus enhancing particle identification at future colliders. The system possesses a compact design, facilitating easy integration into existing detector concepts. A study of the key contributions to the Cherenkov angle resolution is also presented.
This paper describes a novel algorithm for tagging jets originating from the hadronisation of strange quarks (strange-tagging) with the future International Large Detector (ILD) at the International Linear Collider (ILC). It also presents the first application of such a strange-tagger to a Higgs to strange ($h \rightarrow s\bar{s}$) analysis with the $P(e^-,e^+) = (-80\%,+30\%)$ polarisation scenario, corresponding to 900 fb$^{-1}$ of the initial proposed 2000 fb$^{-1}$ of data which will be collected by ILD during its first 10 years of data taking at $\sqrt{s} = 250$ GeV. Upper limits on the Standard Model Higgs-strange coupling strength modifier, $κ_s$, are derived at the 95% confidence level to be 7.14. The paper includes as well a preliminary study of a Ring Imaging Cherenkov (RICH) system capable of discriminating between kaons and pions at high momenta (up to 25 GeV), and thus enhancing strange-tagging performance at future Higgs factory detectors.
For the Phase-II Upgrade of the ATLAS Detector, its Inner Detector, consisting of silicon pixel, silicon strip and transition radiation sub-detectors, will be replaced with an all new 100 % silicon tracker, composed of a pixel tracker at inner radii and a strip tracker at outer radii. The future ATLAS strip tracker will include 11,000 silicon sensor modules in the central region (barrel) and 7,000 modules in the forward region (end-caps), which are foreseen to be constructed over a period of 3.5 years. The construction of each module consists of a series of assembly and quality control steps, which were engineered to be identical for all production sites. In order to develop the tooling and procedures for assembly and testing of these modules, two series of major prototyping programs were conducted: an early program using readout chips designed using a 250 nm fabrication process (ABCN-25) and a subsequent program using a follow-up chip set made using 130 nm processing (ABC130 and HCC130 chips). This second generation of readout chips was used for an extensive prototyping program that produced around 100 barrel-type modules and contributed significantly to the development of the final module layout. This paper gives an overview of the components used in ABC130 barrel modules, their assembly procedure and findings resulting from their tests.
Passive shims are often used to reduce the size and cost of room-temperature magnetic dipoles. In this paper we revisit an analytic approach to the problem of optimum shim design, and we extend it by taking into consideration the effect of magnetic saturation. We derive an abacus curve to determine optimum shim dimensions as a function of the desired dipole nominal field. We show that, for nominal fields below 1.2 T, a pole with such shims can be made at least one half gap height narrower than a pole without. We discuss the range of validity of this approach and verify its predictions using 2 and 3-dimensional finite-element calculations.