arXiv subjects

Matthew J. Kramer

Publications and source records attributed to Matthew J. Kramer.

27 records · Page 2Linked to original sources

arXiv2018

Single Crystal Permanent Magnet: Extraordinary Magnetic Behavior in the ta, Cu and Fe Substituted CeCo5 System

To reduce material and processing costs of commercial permanent magnets and to attempt to fill the empty niche of energy products, 10 - 20 MGOe, between low-flux (ferrites, alnico) and high-flux (Nd2Fe14B- and SmCo5-type) magnets, we report synthesis, structure, magnetic properties and modeling of Ta, Cu and Fe substituted CeCo5. Using a self-flux technique, we grew single crystals of I - Ce15.1Ta1.0Co74.4Cu9.5, II - Ce16.3Ta0.6Co68.9Cu14.2, III - Ce15.7Ta0.6Co67.8Cu15.9, IV - Ce16.3Ta0.3Co61.7Cu21.7 and V - Ce14.3Ta1.0Co62.0Fe12.3Cu10.4. X-ray diffraction analysis (XRD) showed that these materials retain a CaCu5 substructure and incorporate small amounts of Ta in the form of \dumb-bells", filling the 2e crystallographic sites within the 1D hexagonal channel with the 1a Ce site, whereas Co, Cu and Fe are statistically distributed among the 2c and 3g crystallographic sites. Scanning electron microscopy, energy dispersive X-ray spectroscopy (SEM-EDS) and scanning transmission electron microscopy (STEM) examinations provided strong evidence of the single-phase nature of the as-grown crystals, even though they readily exhibited significant magnetic coercivitie of ~1.6 - ~1.8 kOe caused by Co-enriched, nano-sized, structural defects and faults that can serve as pinning sites. Formation of the "composite crystal" during the heat treatment creates a 3D array of extended defects within a primarily single grain single crystal, which greatly improves its magnetic characteristics. Possible causes of the formation of the "composite crystal" may be associated with Ta atoms leaving matrix interstices at lower temperatures and/or matrix degradation induced by decreased miscibility at lower temperatures. Fe strongly improves both the Curie temperature and magnetization of the system resulting in (BH)max:~13 MGOe at room temperature.

cond-mat.mtrl-sci↗

arXiv2018

Magnetic properties of single crystalline itinerant ferromagnet AlFe2B2

Single crystals of AlFe$_{2}$B$_{2}$ have been grown using the self flux growth method and then measured the structural properties, temperature and field dependent magnetization, and temperature dependent electrical resistivity at ambient as well as high pressure. The Curie temperature of AlFe$_{2}$B$_{2}$ is determined to be $274$~K. The measured saturation magnetization and the effective moment for paramagnetic Fe-ion indicate the itinerant nature of the magnetism with a Rhode-Wohlfarth ratio $ \frac{M_{C}}{M_{sat}}\approx 1.14$. Temperature dependent resistivity measurements under hydrostatic pressure shows that transition temperature \textit{T$_C$} is suppressed down to 255 K for $p = 2.24$~GPa pressure with a suppression rate of $\sim -8.9$~K/GPa. The anisotropy fields and magnetocrystalline anisotropy constants are in reasonable agreement with density functional theory calculations.

cond-mat.mtrl-sci↗

arXiv2018

Spatially-correlated Site Occupancy in the Nonstoichiometric Meta-stable ε-Al60Sm11 Phase during Devitrification of Al-10.2 at.% Sm Glasses

A metastable ε-Al60Sm11 phase appears during the initial devitrification of as-quenched Al-10.2 at.% Sm glasses. The ε phase is nonstoichiometric in nature since Al occupation is observed on the 16f Sm lattice sites. Scanning transmission electron microscopic images reveal profound spatial correlation of Sm content on these sites, which cannot be explained by the "average crystal" description from Rietveld analysis of diffraction data. Thermodynamically favorable configurations, established by Monte Carlo (MC) simulations based on a cluster-expansion model, also give qualitatively different correlation functions from experimental observations. On the other hand, molecular dynamics simulations of the growth of ε-Al60Sm11 in undercooled liquid show that when the diffusion range of Sm is limited to ~ 4 Å, the correlation function of the as-grown crystal structure agrees well with that of the STEM images. Our results show that kinetic effects, especially the limited diffusivity of Sm atoms plays the fundamental role in determining the nonstoichiometric site occupancies of the ε-Al60Sm11 phase during the crystallization process.

cond-mat.mtrl-sci↗

arXiv2017

Microstructural and magnetic property evolution with different heat-treatment conditions in an alnico alloy

Further property enhancement of alnico, an attractive near-term, non-rare-earth permanent magnet alloy system, primarily composed of Al, Ni, Co, and Fe, relies on improved morphology control and size refinement of its complex spinodally decomposed nanostructure that forms during heat-treatment. Using a combination of transmission electron microscopy and atom probe tomography techniques, this study evaluates the magnetic properties and microstructures of an isotropic 32.4Fe-38.1Co-12.9Ni-7.3Al-6.4Ti-3.0Cu (wt.$\%$) alloy in terms of processing parameters such as annealing temperature, annealing time, application of an external magnetic field, as well as low-temperature "draw" annealing. Optimal spinodal morphology and spacing is formed within a narrow temperature and time range ($\sim 840 \unicode{x2103}$ and 10 min during thermal-magnetic annealing (MA). The ideal morphology is a mosaic structure consisting of periodically arrayed $\sim 40$ nm diameter (Fe-Co)-rich rods ($α_1$ phase) embedded in an (Al-Ni)-rich ($α_2$ phase) matrix. A Cu-enriched phase with a size of $\sim$ 3-5 nm is located at the corners of two adjacent $\{110\}$ facets of the $α_1$ phase. The MA process significantly increased remanence ($B_\text{r}$) ($\sim$ 40-70 $\%$) of the alloy due to biased elongation of the $α_1$ phase along the $\langle100\rangle$ crystallographic direction, which is closest in orientation to the applied magnetic field. The optimum magnetic properties of the alloy with an intrinsic coercivity ($H_\text{cj}$) of 1845 Oe and a maximum energy product ($BH_\text{max}$) of 5.9 MGOe were attributed to the uniformity of the mosaic structure.

cond-mat.mtrl-sci↗

arXiv2017

Simulation of alnico coercivity

Micromagnetic simulations of alnico show substantial deviations from Stoner-Wohlfarth behavior due to the unique size and spatial distribution of the rod-like Fe-Co phase formed during spinodal decomposition in an external magnetic field. The maximum coercivity is limited by single-rod effects, especially deviations from ellipsoidal shape, and by interactions between the rods. Both the exchange interaction between connected rods and magnetostatic interaction between rods are considered, and the results of our calculations show good agreement with recent experiments. Unlike systems dominated by magnetocrystalline anisotropy, coercivity in alnico is highly dependent on size, shape, and geometric distribution of the Fe-Co phase, all factors that can be tuned with appropriate chemistry and thermal-magnetic annealing.

cond-mat.mtrl-sci↗

arXiv2017

Electronic structure and magnetic properties in $T_2\text{AlB}_2$ ($T$ = Fe, Mn, Cr, Co, and Ni) and their alloys

The electronic structure and intrinsic magnetic properties of $\text{Fe}_2\text{AlB}_2$-related compounds and their alloys have been investigated using density functional theory. For $\text{Fe}_2\text{AlB}_2$, the crystallographic $a$ axis is the easiest axis, which agrees with experiments. The magnetic ground state of $\text{Mn}_2\text{AlB}_2$ is found to be ferromagnetic in the basal $ab$ plane, but antiferromagnetic along the $c$ axis. All $3d$ dopings considered decrease the magnetization and Curie temperature in $\text{Fe}_2\text{AlB}_2$. Electron doping with Co or Ni has a stronger effect on the decreasing of Curie temperature in $\text{Fe}_2\text{AlB}_2$ than hole doping with Mn or Cr. However, a larger amount of Mn doping on $\text{Fe}_2\text{AlB}_2$ promotes the ferromagnetic to antiferromagnetic transition. A very anisotropic magnetoelastic effect is found in $\text{Fe}_2\text{AlB}_2$: the magnetization has a much stronger dependence on the lattice parameter $c$ than on $a$ or $b$, which is explained by electronic-structure features near the Fermi level. Dopings of other elements on B and Al sites are also discussed.

cond-mat.mtrl-sci↗

arXiv2017

Highly responsive ground state of PbTaSe$_2$: structural phase transition and evolution of superconductivity under pressure

Transport and magnetic studies of PbTaSe$_2$ under pressure suggest existence of two superconducting phases with the low temperature phase boundary at $\sim 0.25$ GPa that is defined by a very sharp, first order, phase transition. The first order phase transition line can be followed via pressure dependent resistivity measurements, and is found to be near 0.12 GPa near room temperature. Transmission electron microscopy and x-ray diffraction at elevated temperatures confirm that this first order phase transition is structural and occurs at ambient pressure near $\sim 425$ K. The new, high temperature / high pressure phase has a similar crystal structure and slightly lower unit cell volume relative to the ambient pressure, room temperature structure. Based on first-principles calculations this structure is suggested to be obtained by shifting the Pb atoms from the $1a$ to $1e$ Wyckoff position without changing the positions of Ta and Se atoms. PbTaSe$_2$ has an exceptionally pressure sensitive, structural phase transition with $ΔT_s/ΔP \approx - 1700$ K/GPa near 4 K, this first order transition causes an $\sim 1$ K ($\sim 25 \%$) step - like decrease in $T_c$ as pressure is increased through 0.25 GPa.

cond-mat.supr-con↗

arXiv2015

Structural and ferromagnetic properties of an orthorhombic phase of MnBi stabilized with Rh additions

The article addresses the possibility of alloy elements in MnBi which may modify the thermodynamic stability of the NiAs-type structure without significantly degrading the magnetic properties. The addition of small amounts of Rh and Mn provides an improvement in the thermal stability with some degradation of the magnetic properties. The small amounts of Rh and Mn additions in MnBi stabilize an orthorhombic phase whose structural and magnetic properties are closely related to the ones of the previously reported high-temperature phase of MnBi (HT~MnBi). To date, the properties of the HT~MnBi, which is stable between $613$ and $719$~K, have not been studied in detail because of its transformation to the stable low-temperature MnBi (LT~MnBi), making measurements near and below its Curie temperature difficult. The Rh-stabilized MnBi with chemical formula Mn$_{1.0625-x}$Rh$_{x}$Bi [$x=0.02(1)$] adopts a new superstructure of the NiAs/Ni$_2$In structure family. It is ferromagnetic below a Curie temperature of $416$~K. The critical exponents of the ferromagnetic transition are not of the mean-field type but are closer to those associated with the Ising model in three dimensions. The magnetic anisotropy is uniaxial; the anisotropy energy is rather large, and it does not increase when raising the temperature, contrary to what happens in LT~MnBi. The saturation magnetization is approximately $3$~$μ_B$/f.u. at low temperatures. While this exact composition may not be application ready, it does show that alloying is a viable route to modifying the stability of this class of rare-earth-free magnet alloys.

cond-mat.mtrl-sci↗

arXiv2015

Unconventional phase selection in high-driven systems: A complex metastable structure prevails over simple stable phases

Phase selection in deeply undercooled liquids and devitrified glasses during heating involves complex interplay between the barriers to nucleation and the ability for these nuclei to grow. During the devitrification of glassy alloys, complicated metastable structures often precipitate instead of simpler, more stable compounds. Here, we access this unconventional type of phase selections by investigating an Al-10%Sm system, where a complicated cubic structure first precipitates with a large lattice parameter of 1.4 nm. We not only solve the structure of this "big cubic" phase containing ~140 atoms but establish an explicit interconnection between the structural orderings of the amorphous alloy and the cubic phase, which provides a low-barrier nucleation pathway at low temperatures. The surprising rapid growth of the crystal is attributed to its high tolerance to point defects, which minimize the short-scale atomic rearrangements to form the crystal. Our study suggests a new scenario of devitrification, where phase transformation proceeds initially without partitioning through a complex intermediate crystal phase.

cond-mat.mtrl-sci↗