arXiv subjects

Matthias Brauns

Publications and source records attributed to Matthias Brauns.

9 recordsLinked to original sources

arXiv2021

Nontopological zero-bias peaks in full-shell nanowires induced by flux tunable Andreev states

A semiconducting nanowire fully wrapped by a superconducting shell has been proposed as a platform for obtaining Majorana modes at small magnetic fields. In this study, we demonstrate that the appearance of subgap states in such structures is actually governed by the junction region in tunneling spectroscopy measurements, and not the full-shell nanowire itself. Short tunneling regions never show subgap states, whereas longer junctions always do. This can be understood in terms of quantum dots forming in the junction and hosting Andreev levels in the Yu-Shiba-Rusinov regime. The intricate magnetic field dependence of the Andreev levels, through both the Zeeman and Little-Parks effects, may result in robust zero-bias peaks, features that could be easily misinterpreted as originating from Majorana zero modes, but are unrelated to topological superconductivity.

cond-mat.mes-hall↗

arXiv2019

Hard superconducting gap and diffusion-induced superconductors in Ge-Si nanowires

We show a hard induced superconducting gap in a Ge-Si nanowire Josephson transistor up to in-plane magnetic fields of $250$ mT, an important step towards creating and detecting Majorana zero modes in this system. A hard induced gap requires a highly homogeneous tunneling heterointerface between the superconducting contacts and the semiconducting nanowire. This is realized by annealing devices at $180$ $^\circ$C during which aluminium inter-diffuses and replaces the germanium in a section of the nanowire. Next to Al, we find a superconductor with lower critical temperature ($T_\mathrm{C}=0.9$ K) and a higher critical field ($B_\mathrm{C}=0.9-1.2$ T). We can therefore selectively switch either superconductor to the normal state by tuning the temperature and the magnetic field and observe that the additional superconductor induces a proximity supercurrent in the semiconducting part of the nanowire even when the Al is in the normal state. In another device where the diffusion of Al rendered the nanowire completely metallic, a superconductor with a much higher critical temperature ($T_\mathrm{C}=2.9$ K) and critical field ($B_\mathrm{C}=3.4$ T) is found. The small size of diffusion-induced superconductors inside nanowires may be of special interest for applications requiring high magnetic fields in arbitrary direction.

cond-mat.mes-hall↗

arXiv2019

Multiple Andreev reflections and Shapiro steps in a Ge-Si nanowire Josephson junction

We present a Josephson junction based on a Ge-Si core-shell nanowire with transparent superconducting Al contacts, a building block which could be of considerable interest for investigating Majorana bound states, superconducting qubits and Andreev (spin) qubits. We demonstrate the dc Josephson effect in the form of a finite supercurrent through the junction, and establish the ac Josephson effect by showing up to 23 Shapiro steps. We observe multiple Andreev reflections up to the sixth order, indicating that charges can scatter elastically many times inside our junction, and that our interfaces between superconductor and semiconductor are transparent and have low disorder.

cond-mat.mes-hall↗

arXiv2018

Josephson effect in a few-hole quantum dot

We use a Ge-Si core-shell nanowire to realise a Josephson field-effect transistor with highly transparent contacts to superconducting leads. By changing the electric field we gain access to two distinct regimes not combined before in a single device: In the accumulation mode the device is highly transparent and the supercurrent is carried by multiple subbands, while near depletion supercurrent is carried by single-particle levels of a strongly coupled quantum dot operating in the few-hole regime. These results establish Ge-Si nanowires as an important platform for hybrid superconductor-semiconductor physics and Majorana fermions.

cond-mat.mes-hall↗

arXiv2018

Palladium gates for reproducible quantum dots in silicon

We replace the established aluminium gates for the formation of quantum dots in silicon with gates made from palladium. We study the morphology of both aluminium and palladium gates with transmission electron microscopy. The native aluminium oxide is found to be formed all around the aluminium gates, which could lead to the formation of unintentional dots. Therefore, we report on a novel fabrication route that replaces aluminium and its native oxide by palladium with atomic-layer-deposition-grown aluminium oxide. Using this approach, we show the formation of low-disorder gate-defined quantum dots, which are reproducibly fabricated. Furthermore, palladium enables us to further shrink the gate design, allowing us to perform electron transport measurements in the few-electron regime in devices comprising only two gate layers, a major technological advancement. It remains to be seen, whether the introduction of palladium gates can improve the excellent results on electron and nuclear spin qubits defined with an aluminium gate stack.

cond-mat.mes-hall↗

arXiv2016

Highly tuneable hole quantum dots in Ge-Si core-shell nanowires

We define single quantum dots of lengths varying from 60 nm up to nearly half a micron in Ge-Si core-shell nanowires. The charging energies scale inversely with the quantum dot length between 18 and 4 meV. Subsequently, we split up a long dot into a double quantum dot with a separate control over the tunnel couplings and the electrochemical potential of each dot. Both single and double quantum dot configurations prove to be very stable and show excellent control over the electrostatic environment of the dots, making this system a highly versatile platform for spin-based quantum computing.

cond-mat.mes-hall↗

arXiv2016

Anisotropic Pauli spin blockade in hole quantum dots

We present measurements on gate-defined double quantum dots in Ge-Si core-shell nanowires, which we tune to a regime with visible shell filling in both dots. We observe a Pauli spin blockade and can assign the measured leakage current at low magnetic fields to spin-flip cotunneling, for which we measure a strong anisotropy related to an anisotropic g-factor. At higher magnetic fields we see signatures for leakage current caused by spin-orbit coupling between (1,1)-singlet and (2,0)-triplet states. Taking into account these anisotropic spin-flip mechanisms, we can choose the magnetic field direction with the longest spin lifetime for improved spin-orbit qubits.

cond-mat.mes-hall↗

arXiv2016

Electric-field dependent g-factor anisotropy in Ge-Si core-shell nanowire quantum dots

We present angle-dependent measurements of the effective g-factor g* in a Ge-Si core-shell nanowire quantum dot. g* is found to be maximum when the magnetic field is pointing perpendicular to both the nanowire and the electric field induced by local gates. Alignment of the magnetic field with the electric field reduces g* significantly. g* is almost completely quenched when the magnetic field is aligned with the nanowire axis. These findings confirm recent calculations, where the obtained anisotropy is attributed to a Rashba-type spin-orbit interaction induced by heavy-hole light-hole mixing. In principle, this facilitates manipulation of spin-orbit qubits by means of a continuous high-frequency electric field.

cond-mat.mes-hall↗

arXiv2013

Printed Circuit Board Metal Powder Filters for Low Electron Temperatures

We report the characterisation of printed circuit boards (PCB) metal powder filters and their influence on the effective electron temperature which is as low as 22 mK for a quantum dot in a silicon MOSFET structure in a dilution refrigerator. We investigate the attenuation behaviour (10 MHz- 20 GHz) of filter made of four metal powders with a grain size below 50 um. The room-temperature attenuation of a stainless steel powder filter is more than 80 dB at frequencies above 1.5 GHz. In all metal powder filters the attenuation increases with temperature. Compared to classical powder filters, the design presented here is much less laborious to fabricate and specifically the copper powder PCB-filters deliver an equal or even better performance than their classical counterparts.

cond-mat.mes-hall↗