Surface Finishing and Coatings for Accelerator Vacuum Applications
The main applications and techniques of thin film coating and plating on vacuum components for particle accelerators are reviewed through significative examples.
physics.acc-ph↗
arXiv subjects
Mauro Taborelli
Publications and source records attributed to Mauro Taborelli.
Study of selected mild steels for application in vacuum systems of future gravitational wave detectors
Next-generation gravitational wave detectors (GWDs) like the Cosmic Explorer and Einstein Telescope require extensive vacuum tubing, necessitating cost-effective materials. This study explores the viability of mild steel as an alternative to austenitic stainless steel for UHV beampipes, focusing on outgassing rates and surface chemistry after low-temperature bakeouts. Mild steels exhibit significantly lower hydrogen outgassing rates, below 10$^{-14}$ mbar l s$^{-1}$ cm$^{-2}$ after bakeouts at 80{\deg}C for 48 hours. While water vapor is the primary residual gas after such low-temperature bakeouts, repeated treatments reduce its outgassing rate and modify surface conditions so that such benefit is preserved after at least six months of exposure to laboratory air. These findings position mild steel as an economical and efficient material for future GWD beampipes.
physics.acc-ph↗
Cleaning and Surface Properties
Principles of the precision cleaning dedicated to ultra-high vacuum applications are reviewed together with the techniques for the evaluation of surface cleanliness. Methods to verify the effectiveness of cleaning procedures are addressed. Examples are presented to illustrate the influence of packaging and storage on the recontamination of the surface after cleaning. Finally, the effect of contamination on some relevant surface properties, such as secondary electron emission and wettability, is presented. This article is an updated and shortened version of the one previously published for the CAS school on the vacuum of accelerators 2006.
physics.ins-det↗