Dynamic response of ferrofluidic deformable mirrors using elastomer membrane and overdrive techniques
Here are presented the experimental results obtained with a ferrofluidic deformable mirror controlled by electro-magnet actuators. Using a step input through a single actuator we obtain a steady-state settling time of 100ms; however, different combinations of overdrive inputs can be used to decrease it to 25ms. Also, a new technique which consists in laying down an elastomer membrane, coated with an aluminum film, on the ferrofluid is discussed. By adding the membrane on the ferrofluid, it further decreases the time response by a factor of 2. Furthermore, the thin aluminum layer improves the reflectivity of the mirror. Finally, using the membrane and the overdrive techniques combined, the time response is improved by a factor of 20. Numerical simulations show that ferrofluidic mirrors using membranes and improved electronics should reach settling times of the order of a millisecond. Presumably even lower settling times could be possible.