arXiv subjects

Maximilian P. Böhme

Publications and source records attributed to Maximilian P. Böhme.

12 recordsLinked to original sources

arXiv2026

Reconciling chemical models of X-ray Thomson Scattering with the Bethe $f$-sum rule

X-ray Thomson scattering (XRTS) is a key diagnostic for high-energy-density plasmas, which can exhibit significant quantum effects even at elevated temperatures. XRTS experiments are commonly interpreted using the Chihara decomposition, that was derived in the chemical picture and, thus, separates contributions from bound and free electrons. Despite being the de-facto standard for analysing measurements, a well-known shortcoming is that the standard bound-state treatment in the form of the impulse approximation fails to satisfy fundamental theoretical constraints, most notably the Bethe $f$-sum rule (BFSR). The problem arises due to the usage of plane waves in the impulse approximation as well as non-negligible contributions from bound-bound transitions. In this work, we present a minimal analytical extension of the Chihara decomposition of the dynamic structure factor for matter in the ground state, using hydrogenic bound-free and bound-bound transitions. We demonstrate that compliance with the BFSR is only achieved when both bound-bound transitions are explicitly included and an exact treatment of the bound-free contribution is applied. Finally, detector ray-tracing simulations for atomic hydrogen demonstrate experimentally detectable deviations from the standard Chihara model. The model will be made available in the open source XRTS library xDAVE [Bellenbaum et al., Phys. Plasmas (in print), arxiv:2604.27237].

physics.plasm-ph↗

arXiv2026

X-Ray Diagnostics Analysis Verification and Exploration (xDAVE) Code for the Prediction and Interpretation of X-Ray Thomson Scattering Experiments

X-ray Thomson scattering (XRTS) is a common diagnostic used in the warm dense matter (WDM) regime to estimate plasma parameters like density, temperature and charge state. Experimental analysis typically relies on a forward model to obtain estimates for these parameters, as the measured spectrum is a convolution of the dynamic structure factor (DSF) and the source-instrument function. The Chihara decomposition, where the spectrum is separated into contributions from bound and free electrons, is commonly used to estimate DSFs in the WDM regime, as it allows for the fast calculation of DSFs and therefore can easily be applied in a large-scale parameter optimization. Due to the limited availability of XRTS codes, in this work we present the ``\textbf{X}-ray \textbf{D}iagnostics, \textbf{A}nalysis, \textbf{V}erification and \textbf{E}xploration`` (\texttt{xDAVE}) code, designed to quickly estimate DSFs using the Chihara decomposition and analyse experimental spectra. The code is validated by re-analysing an experiment with isochorically heated beryllium at the OMEGA Laser Facility. In addition, we demonstrate the applicability of the code to plan experiments and predict scattering spectra through the coupling to a ray-tracing code. Lastly, the importance of accounting for the energy-dependence of spectrometer instrument functions is demonstrated by comparing ray-tracing simulations to the standard convolution for strongly compressed Beryllium shots at the National Ignition Facility similar to previously published results.

physics.plasm-ph↗

arXiv2026

Temperature dependence of the dynamic structure factor of the electron liquid via analytic continuation

We present new analytic continuation results for the dynamic structure factor $S(\mathbf{q},ω)$ of the uniform electron liquid based on quasi-exact \emph{ab initio} path integral Monte Carlo (PIMC) data for the imaginary-time density--density correlation function $F(\mathbf{q},τ)$ across a broad range of temperatures. For this purpose, we employ both a traditional maximum entropy method solver, and a pre-optimized sparse Gaussian kernel representation as it has been implemented in the recent \texttt{PyLIT} package [Benedix Robles \textit{et al.}, \textit{Comp.~Phys.~Comm.}~\textbf{319}, 109904 (2026)], and we identify potential advantages and disadvantages in both. We expect our results to be interesting for a broad range of topics, including the interpretation of x-ray Thomson scattering experiments with extreme states of matter and the construction of improved exchange--correlation kernels for linear-response time-dependent density functional theory.

physics.comp-ph↗

arXiv2026

Roadmap for warm dense matter physics

This roadmap presents the state-of-the-art, current challenges and near future developments anticipated in the thriving field of warm dense matter physics. Originating from strongly coupled plasma physics, high pressure physics and high energy density science, the warm dense matter physics community has recently taken a giant leap forward. This is due to spectacular developments in laser technology, diagnostic capabilities, and computer simulation techniques. Only in the last decade has it become possible to perform accurate enough simulations \& experiments to truly verify theoretical results as well as to reliably design experiments based on predictions. Consequently, this roadmap discusses recent developments and contemporary challenges that are faced by theoretical methods, and experimental techniques needed to create and diagnose warm dense matter. A large part of this roadmap is dedicated to specific warm dense matter systems and applications in astrophysics, inertial confinement fusion and novel material synthesis.

physics.plasm-ph↗

arXiv2025

Model-free Rayleigh weight from x-ray Thomson scattering measurements

X-ray Thomson scattering (XRTS) has emerged as a powerful tool for the diagnostics of matter under extreme conditions. In principle, it gives one access to important system parameters such as the temperature, density, and ionization state, but the interpretation of the measured XRTS intensity usually relies on theoretical models and approximations. In this work, we show that it is possible to extract the Rayleigh weight -- a key property that describes the electronic localization around the ions -- directly from the experimental data without the need for any model calculations or simulations. As a practical application, we consider an experimental measurement of strongly compressed Be at the National Ignition Facility (NIF) [Döppner \emph{et al.}, \textit{Nature} \textbf{618}, 270-275 (2023)]. In addition to being interesting in their own right, our results will open up new avenues for diagnostics from \emph{ab initio} simulations, help to further constrain existing chemical models, and constitute a rigorous benchmark for theory and simulations.

physics.plasm-ph↗

arXiv2025

Estimating ionization states and continuum lowering from ab initio path integral Monte Carlo simulations for warm dense hydrogen

Warm dense matter (WDM) is an active field of research, with applications ranging from astrophysics to inertial confinement fusion. Ionization degree and continuum lowering are important quantities to understand how materials behave under these conditions, but can be difficult to diagnose since experimental campaigns are limited and often require model-dependent analysis. This is especially true for hydrogen, which has a comparably low scattering cross section, making high quality data particularly difficult to obtain. Consequently, building equation of state tables often relies on exact simulations in combination with untested approximations to extract properties from experiments. Here, we investigate an approach for extracting the ionization potential depression and ionization degree -- quantities which are otherwise not directly accessible from the physical model -- from exact ab initio path integral Monte Carlo (PIMC) simulations utilizing a chemical model. In contrast to experimental measurements, where noise and non-equilibrium effects add to the uncertainty of the inferred parameters, PIMC simulations provide a clean signal with well-defined thermodynamic conditions. Comparisons against commonly used models show a qualitative agreement, but we find deviations primarily for the high density and high temperature cases. We also demonstrate the decreasing sensitivity of the dynamic structure factor with respect to both ionization and continuum lowering for increasing scattering angles in x-ray Thomson scattering experiments. Our work has important implications for the design of future experiments, but also offers qualitative understanding of structure factors and the imaginary-time correlation function obtained from exact quantum Monte Carlo simulations.

physics.chem-ph↗

arXiv2024

Towards Model-free Temperature Diagnostics of Warm Dense Matter from Multiple Scattering Angles

Warm dense matter (WDM) plays an important role in astrophysical objects and technological applications, but the rigorous diagnostics of corresponding experiments is notoriously difficult. In this work, we present a model-free analysis of x-ray Thomson scattering (XRTS) measurements at multiple scattering angles. Specifically, we analyze scattering data that have been collected for isochorically heated graphite at the Linac Coherent Light Source (LCLS). Overall, we find good consistency in the extracted temperature between small and large scattering angles, whereas possible signatures of non-equilibrium may be hidden by the source function, and by the available dynamic spectral range. The present proof-of-principle study directly points to improved experimental set-ups for equation-of-state measurements and for the model-free study of relaxation times.

physics.plasm-ph↗

arXiv2024

Green's function perspective on the nonlinear density response of quantum many-body systems

We derive equations of motion for higher order density response functions using the theory of thermodynamic Green's functions. We also derive expressions for the higher order generalized dielectric functions and polarization functions. Moreover, we relate higher order response functions and higher order collision integrals within the Martin-Schwinger hierarchy. We expect our results to be highly relevant to the study of a variety of quantum many-body systems such as matter under extreme temperatures, densities, and pressures.

cond-mat.str-el↗

arXiv2024

X-ray Thomson scattering absolute intensity from the f-sum rule in the imaginary-time domain

We present a formally exact and simulation-free approach for the normalization of X-ray Thomson scattering (XRTS) spectra based on the f-sum rule of the imaginary-time correlation function (ITCF). Our method works for any degree of collectivity, over a broad range of temperatures, and is applicable even in nonequilibrium situations. In addition to giving us model-free access to electronic correlations, this new approach opens up the intriguing possibility to extract a plethora of physical properties from the ITCF based on XRTS experiments.

physics.plasm-ph↗

arXiv2023

Evidence of free-bound transitions in warm dense matter and their impact on equation-of-state measurements

Warm dense matter (WDM) is now routinely created and probed in laboratories around the world, providing unprecedented insights into conditions achieved in stellar atmospheres, planetary interiors, and inertial confinement fusion experiments. However, the interpretation of these experiments is often filtered through models with systematic errors that are difficult to quantify. Due to the simultaneous presence of quantum degeneracy and thermal excitation, processes in which free electrons are de-excited into thermally unoccupied bound states transferring momentum and energy to a scattered x-ray photon become viable. Here we show that such free-bound transitions are a particular feature of WDM and vanish in the limits of cold and hot temperatures. The inclusion of these processes into the analysis of recent X-ray Thomson Scattering experiments on WDM at the National Ignition Facility and the Linac Coherent Light Source significantly improves model fits, indicating that free-bound transitions have been observed without previously being identified. This interpretation is corroborated by agreement with a recently developed model-free thermometry technique and presents an important step for precisely characterizing and understanding the complex WDM state of matter.

physics.plasm-ph↗

arXiv2023

Revealing Non-equilibrium and Relaxation in Warm Dense Matter

Experiments creating extreme states of matter almost invariably create non-equilibrium states. These are very interesting in their own right but need to be understood even if the ultimate goal is to probe high-pressure or high-temperature equilibrium properties like the equation of state. Here, we report on the capabilities of the newly developed imaginary time correlation function (ITCF) technique [1] to detect and quantify non-equilibrium in pump-probe experiments fielding time resolved x-ray scattering diagnostics. We find a high sensitivity of the ITCF even to a small fraction of non-equilibrium electrons in the Wigner distribution. The behavior of the ITCF technique is such that modern lasers and detectors should be able to trace the non-equilibrium relaxation from tens of femto-seconds to several 10s of picoseconds without the need for a model.

physics.plasm-ph↗

arXiv2022

Electronic Density Response of Warm Dense Matter

Matter at extreme temperatures and pressures -- commonly known as warm dense matter (WDM) in the literature -- is ubiquitous throughout our Universe and occurs in a number of astrophysical objects such as giant planet interiors and brown dwarfs. Moreover, WDM is very important for technological applications such as inertial confinement fusion, and is realized in the laboratory using different techniques. A particularly important property for the understanding of WDM is given by its electronic density response to an external perturbation. Such response properties are routinely probed in x-ray Thomson scattering (XRTS) experiments, and, in addition, are central for the theoretical description of WDM. In this work, we give an overview of a number of recent developments in this field. To this end, we summarize the relevant theoretical background, covering the regime of linear-response theory as well as nonlinear effects, the fully dynamic response and its static, time-independent limit, and the connection between density response properties and imaginary-time correlation functions (ITCF). In addition, we introduce the most important numerical simulation techniques including ab initio path integral Monte Carlo (PIMC) simulations and different thermal density functional theory (DFT) approaches. From a practical perspective, we present a variety of simulation results for different density response properties, covering the archetypal model of the uniform electron gas and realistic WDM systems such as hydrogen. Moreover, we show how the concept of ITCFs can be used to infer the temperature from XRTS measurements of arbitrarily complex systems without the need for any models or approximations. Finally, we outline a strategy for future developments based on the close interplay between simulations and experiments.

physics.plasm-ph↗