arXiv subjects

Melanie Ast

Publications and source records attributed to Melanie Ast.

5 recordsLinked to original sources

arXiv2025

Demonstrating sub-picometer non-reciprocity levels in the Three-Backlink Experiment for LISA

The current planned space-based gravitational-wave detectors require a bidirectional optical connection, referred to as Backlink, between two adjacent optical benches to provide a mutual phase reference for the local interferometric measurements. However, if the Backlink shows asymmetry between the two propagation directions, the effective optical pathlengths of the counter-propagating beams can introduce a differential phase noise, called non-reciprocity, into the main interferometric measurement that will limit the achievable accuracy in time-delay interferometry (TDI) post-processing. Hence, it is important to understand the properties of the Backlink to ensure that it will not compromise the interferometric detection. The Three-Backlink Experiment (3BL), which consists of an optical test facility with two rotatable benches, was designed under the Laser Interferometer Space Antenna (LISA) framework to study the performance of three Backlink configurations: two fiber-based and one free-beam scheme. In this paper, we report recent experimental results from the 3BL. We describe the commissioning and the subsequent noise mitigation. We achieve a setup noise floor below $1\text{ pm}\sqrt{\text{Hz}}$ across most of the LISA measurement band, and provide an understanding of the current technical limitations. With this low-noise baseline, we measured the performance of the three Backlink implementations under non-rotational conditions. We show that all three Backlinks reach sub-picometer non-reciprocity levels across most of the frequency band, with the remaining part dominated by the mentioned testbed noise. This enabled us to conduct a preliminary study of the Backlink inherent noise, where we emphasized on the backscatter noise intrinsic to a straightforward fiber-based Backlink, as this is the current baseline for LISA.

physics.optics↗

arXiv2025

Construction techniques and commissioning of the Three-Backlink Experiment for the LISA mission

Designed to detect gravitational waves in the lower-frequency band, the space mission LISA will open a new window to astronomy after its launch in the 2030s. Each LISA spacecraft houses two optical benches that require the exchange of a phase reference between them via an optical connection, called a Backlink. Here we present the construction and commissioning of an ultra-stable quasi-monolithic optical testbed to investigate different Backlink implementations: a direct fiber, a frequency-separated fiber, and a free-beam link, compared in the Three-Backlink Experiment. Dedicated alignment techniques crucial for the construction of these optical benches are presented together with the development of a high-precision beam alignment and measurement tool - a Calibrated Quadrant Photodiode Singleton. An upper limit for the performance of all three investigated Backlink schemes, as determined by initial experiments, can be set at a $15\text{pm}/\sqrt{\text{Hz}}$-equivalent level within the LISA band, spanning 0.1mHz to 1Hz. Our measurements were able to verify the successful construction and commissioning of this very complex interferometer as an interferometric laboratory testbed for LISA. We find no limitations due to the construction on the here reported performance levels. Our results can support the construction of high-precision metrology testbeds for space-based laser interferometry for future gravitational wave or geodesy missions.

physics.optics↗

arXiv2025

Tunable coherence laser interferometry: demonstrating 40dB of straylight suppression and compatibility with resonant optical cavities

A major limitation of laser interferometers using continuous wave lasers are parasitic light fields, such as ghost beams, scattered or stray light, which can cause non-linear noise. This is especially relevant for laser interferometric ground-based gravitational wave detectors. Increasing their sensitivity, particularly at frequencies below 10 Hz, is threatened by the influence of parasitic photons. These can up-convert low-frequency disturbances into phase and amplitude noise inside the relevant measurement band. By artificially tuning the coherence of the lasers, using pseudo-random-noise (PRN) phase modulations, this influence of parasitic fields can be suppressed. As it relies on these fields traveling different paths, it does not sacrifice the coherence for the intentional interference. We demonstrate the feasibility of this technique experimentally, achieving noise suppression levels of 40 dB in a Michelson interferometer with an artificial coherence length below 30 cm. We probe how the suppression depends on the delay mismatch and length of the PRN sequence. We also prove that optical resonators can be operated in the presence of PRN modulation by measuring the behavior of a linear cavity with and without such a modulation. By matching the resonators round-trip length and the PRN sequence repetition length, the classic response is recovered.

physics.optics↗

arXiv2016

Gaussian entanglement distribution with gigahertz bandwidth

The distribution of entanglement with Gaussian statistic can be used to generate a mathematically-proven secure key for quantum cryptography. The distributed secret key rate is limited by the {entanglement strength, the entanglement bandwidth and the bandwidth of the photo-electric detectors}. The development of a source for strongly, bi-partite entangled light with high bandwidth promises an increased measurement speed and a linear boost in the secure data rate. Here, we present the experimental realization of a Gaussian entanglement source with a bandwidth of more than 1.25\,GHz. The entanglement spectrum was measured with balanced homodyne detectors and was quantified via the inseparability criterion introduced by Duan and coworkers with a critical value of 4 below which entanglement is certified. Our measurements yielded an inseparability value of about 1.8 at a frequency of 300\,MHz to about 2.8 at 1.2\,GHz extending further to about 3.1 at 1.48\,GHz. In the experiment we used two 2.6\,mm long monolithic periodically poled potassium titanyl phosphate (PPKTP) resonators to generate two squeezed fields at the telecommunication wavelength of 1550\,nm. Our result proves the possibility of generating and detecting strong continuous-variable entanglement with high speed.

quant-ph↗

arXiv2016

Reduction of Classical Measurement Noise via Quantum-Dense Metrology

Quantum-dense metrology (QDM) constitutes a special case of quantum metrology in which two orthogonal phase space projections of a signal are simultaneously sensed beyond the shot noise limit. Previously it was shown that the additional sensing channel that is provided by QDM contains information that can be used to identify and to discard corrupted segments from the measurement data. Here, we demonstrate a proof-of-principle experiment in which this information is used for improving the sensitivity without discarding any measurement segments. Our measurement reached sub-shot-noise performance although initially strong classical noise polluted the data.

quant-ph↗