arXiv subjects

Meng Li

Publications and source records attributed to Meng Li.

383 records · Page 22Linked to original sources

arXiv2015

Experimental demonstration of PT-symmetric stripe lasers

Recently, the coexistence of parity-time (PT) symmetric laser and absorber has gained tremendous research attention. While the PT symmetric absorber has been observed in microwave metamaterials, the experimental demonstration of PT symmetric laser is still absent. Here we experimentally study PT-symmetric laser absorber in stripe waveguide. Using the concept of PT symmetry to exploit the light amplification and absorption, PT-symmetric laser absorbers have been successfully obtained. Different from the single-mode PT symmetric lasers, the PT-symmetric stripe lasers have been experimentally confirmed by comparing the relative wavelength positions and mode spacing under different pumping conditions. When the waveguide is half pumped, the mode spacing is doubled and the lasing wavelengths shift to the center of every two initial lasing modes. All these observations are consistent with the theoretical predictions and confirm the PT-symmetry breaking well.

physics.optics↗

arXiv2015

Inversed Vernier effect based single-mode laser emission in coupled microdisks

Recently, on-chip single-mode laser emission has attracted considerable research attention due to its wide applications. While most of single-mode lasers in coupled microdisks or microrings have been qualitatively explained by either Vernier effect or inversed Vernier effect, none of them have been experimentally confirmed. Here, we studied the mechanism for single-mode operation in coupled microdisks. We found that the mode numbers had been significantly reduced to nearly single-mode within a large pumping power range from threshold to gain saturation. The detail laser spectra showed that the largest gain and the first lasing peak were mainly generated by one disk and the laser intensity was proportional to the frequency detuning. The corresponding theoretical analysis showed that the experimental observations were dominated by internal coupling within one cavity, which was similar to the recently explored inversed Vernier effect in two coupled microrings. We believe our finding will be important for understanding the previous experimental findings and the development of on-chip single-mode laser.

physics.optics↗

arXiv2014

Ferroelectric field effect of the bulk heterojunction in polymer solar cells

A ferroelectric field effect in the bulk heterojunction was found when an external electric field (EEF) was applied on the active layer of polymer solar cells (PSCs) during the annealing process of the active layer spin-coated with poly (3-hexylthiophene):[6,6]-phenyl-C61 butyric acid methyl ester (P3HT:PCBM). For one direction field, the short circuit current density of PSCs was improved from 7.2 to 8.0 mA/cm2, the power conversion efficiency increased from 2.4 to 2.8%, and the incident photon-to-current conversion efficiency increased from 42 to 49% corresponding to the different EEF magnitude. For an opposite direction field, the applied EEF brought a minus effect on the performance mentioned above. EEF treatment can orientate molecular ordering of the polymer, and change the morphology of the active layer. The authors suggest a explanation that the ferroelectric field has been built in the active layer, and therefore it plays a key role in PSCs system. A needle-like surface morphology of the active film was also discussed.

cond-mat.mtrl-sci↗

arXiv2013

Effect of electrode geometry on photovoltaic performance of polymer solar cells

This paper investigates the impact of electrode geometry on the performance of polymer solar cells (PSCs). Four types of negative electrodes with equal area (0.09 cm2) but different shape (round, oval, square, and triangular) are evaluated with respect to short-circuit current density, open-circuit voltage, fill factor, and power conversion efficiency of PSCs. The results show that the device with round electrodes gives the best photovoltaic performance; in contrast, the device with triangular electrodes reveals the worst properties. Maximum almost twice increase in PCE with round electrode is obtained in the devices compared with that of the triangular electrode. As a conclusion, the electrode boundary curvature has a strong influence on the performance of PSCs. The larger curvature, i.e. the sharper electrodes edge, maybe is a negative effector on exciton separation and carrier transport in PSC system.

cond-mat.mtrl-sci↗

arXiv2011

Behavior of ZnO-coated alumina dielectric barrier discharge in atmospheric pressure air

A complete investigation of the discharge behavior of dielectric barrier discharge device using ZnO-coated dielectric layer in atmospheric pressure is made. Highly conductive ZnO film was deposited on the dielectric surface. Discharge characteristic of the dielectric barrier discharge are examined in different aspects. Experimental result shows that discharge uniformity is improved definitely in the case of ZnO-coated dielectric barrier discharge. And relevant theoretical models and explanation are presented to describing its discharge physics.

physics.plasm-ph↗