arXiv subjects
Publications and source records attributed to Michael Eiselt.
We review three solutions for low-cost data center interconnects with a target reach of up to 80 km. Directly detected DMT, PAM-4 and multi-band CAP are promising modulation schemes, enabling 400 Gbit/s by combining eight channels of 56 Gbit/s.
Enabled by channel adaptive bit and power loading, we experimentally demonstrate discrete multitone transmission at 56Gb/s with simple intensity modulation and direct detection and achieve 50 km reach in the 1.55um window.
The novel 3-dimensional modulation format 3D-Simplex offers potentially 1.2 dB higher OSNR tolerance than DP-DPSK while exhibiting the same spectral occupancy, modulating two bits per symbol. We verify this benefit experimen-tally and evaluate the transmission performance in a non-linear environment. All experimental results are confirmed by simulations. The benefit of 3D-Simplex is not maintained in the highly non-linear regime, but the performance is still comparable to that of DP-DPSK.
We experimentally evaluate a flexible DMT system using 4 to 8 50-GHz-grid C-band channels to transmit 448 Gb/s over up to 240 km SSMF. VSB filtering enabled by detuned lasers significantly reduces the impact of chromatic dispersion.
We demonstrate 64 GBd signal generation up to bipolar-8-ASK utilizing a single MZM, monolithically integrated with segmented drivers in SiGe. Using polarization multiplexing, 300-Gb/s net data rate transmission over 120 km SSMF is shown.
We experimentally demonstrate a novel 3-dimensional modulation format with 1.2-dB OSNR tolerance improvement potential compared to DP-BPSK, as verified for the linear case. The non-linearity tolerance is evaluated in single-span transmission over 300km SSMF.
Using a Correlation-OTDR we measured the latency of fibers in a deployed cable and calculated the time coefficient of the fiber temperature changes. Annual temperature variations of 25K were estimated for the deployed fiber.
This paper presents an experimental investigation of 8% pilot tone modulation depth is a system transmitting NRZ, PAM4 and Duobinary. The penalty from the pilot tone increases with signal amplitude levels and reaches a received power penalty of 3 dB.
Correlation OTDR with a bit rate of 10 Gbit/s is used to measure fiber latency with an accuracy of a few picoseconds. The concept is demonstrated measuring the chromatic dispersion of a 2.2-km fiber section.
Current trends in Data Center Interconnectivity are considered in the light of increasing traffic and under the constraint of limited cost and power consumption.
For a future 5G Ethernet-based fronthaul architecture, 100G trunk lines of a transmission distance up to 10 km standard single mode fiber (SSMF) in combination with cheap grey optics to daisy chain cell site network interfaces are a promising cost- and power-efficient solution. For such a scenario, different intensity modulation and direct detect (IMDD) Formats at a data rate of 112 Gb/s, namely Nyquist four-level pulse amplitude modulation (PAM4), discrete multi-tone Transmission (DMT) and partial-response (PR) PAM4 are experimentally investigated, using a low-cost electro-absorption modulated laser (EML), a 25G driver and current state-of-the-art high Speed 84 GS/s CMOS digital-to-analog converter (DAC) and analog-to-digital converter (ADC) test chips. Each modulation Format is optimized independently for the desired scenario and their digital signal processing (DSP) requirements are investigated. The performance of Nyquist PAM4 and PR PAM4 depend very much on the efficiency of pre- and post-equalization. We show the necessity for at least 11 FFE-taps for pre-emphasis and up to 41 FFE coefficients at the receiver side. In addition, PR PAM4 requires an MLSE with four states to decode the signal back to a PAM4 signal. On the contrary, bit- and power-loading (BL, PL) is crucial for DMT and an FFT length of at least 512 is necessary. With optimized parameters, all Modulation formats result in a very similar performances, demonstrating a transmission distance of up to 10 km over SSMF with bit error rates (BERs) below a FEC threshold of 4.4E-3, allowing error free transmission.