arXiv subjects

Michael Holynski

Publications and source records attributed to Michael Holynski.

11 recordsLinked to original sources

arXiv2026

Technical Proposal for the Atom Interferometer CERN Experiment (AICE) Facility

We present the technical proposal for the Atom Interferometer CERN Experiment (AICE), a $\mathcal{O}(100)$ m vertical atom interferometer to be installed against the wall of the PX46 access shaft to the LHC. AICE is conceived as a versatile and flexible long-baseline atom-interferometry facility whose primary scientific goal is probing for bosonic ultralight dark matter (ULDM) in a mass range inaccessible to other experiments, with a secondary goal of pioneering the exploration of gravitational waves (GWs) with frequencies in the range ${\sim}$0.03-3 Hz as a pathfinder for future longer-baseline detectors. The initial configuration employs ultracold $^{87}$Sr atoms in a single-photon 698-nm interferometer with three shaft-based atom sources in a multi-source gradiometer geometry, supported by one surface reference source for laser stabilisation and diagnostics, to target scalar ULDM. Operation with $^{88}$Sr will give sensitivity to axion-like particles (ALPs), vector ULDM with $B-L$ couplings and violation of the principle of equivalence, while a $^{171}$Yb upgrade will improve the sensitivity to $B-L$ couplings and equivalence violations. Probing the Einstein equivalence principle (EP) and measuring $\alpha$ will proceed in parallel with the ULDM searches. A conceptual feasibility study and a detailed technical implementation study have established that PX46 is a uniquely mature and implementation-ready site, with no technical showstoppers. Completing site preparation works during LS3 would enable the subsequent installation and operation of AICE without impacting HL-LHC operations. The detector design builds on the VLBAI and MAGIS experiments and the AION-10 Technical Design Report, scaling the strontium gradiometer architecture to the $\sim$100 m baseline. AICE is endorsed by the TVLBAI Proto-Collaboration, comprising 57 institutions in 22 countries.

hep-ex↗

arXiv2025

Letter of Intent: AICE -- 100m Atom Interferometer Experiment at CERN

We propose an O(100)m Atom Interferometer (AI) experiment -- AICE -- to be installed against a wall of the PX46 access shaft to the LHC. This experiment would probe unexplored ranges of the possible couplings of bosonic ultralight dark matter (ULDM) to atomic constituents and undertake a pioneering search for gravitational waves (GWs) at frequencies intermediate between those to which existing and planned experiments are sensitive, among other fundamental physics studies. A conceptual feasibility study showed that this AI experiment could be isolated from the LHC by installing a shielding wall in the TX46 gallery, and surveyed issues related to the proximity of the LHC machine, finding no technical obstacles. A detailed technical implementation study has shown that the preparatory civil-engineering work, installation of bespoke radiation shielding, deployment of access-control systems and safety alarms, and installation of an elevator platform could be carried out during LS3, allowing installation and operation of the AICE detector to proceed during Run 4 without impacting HL-LHC operation. These studies have established that PX46 is a uniquely promising location for an AI experiment. We foresee that, if the CERN management encourages this Letter of Intent, a significant fraction of the Terrestrial Very Long Baseline Atom Interferometer (TVLBAI) Proto-Collaboration may wish to contribute to AICE.

hep-ex↗

arXiv2025

Integration of a high-fidelity model of quantum sensors with a map-matching filter for quantum-enhanced navigation

Harnessing the potential of quantum sensors to assist in navigation requires enabling their operation in complex, dynamic environments and integrating them within existing navigation systems. While cross-couplings from platform dynamics generally degrade quantum measurements in a complex manner, navigation filters would need to be designed to handle such complex quantum sensor data. In this work, we report on the realization of a high-fidelity model of an atom-interferometry-based gravity gradiometer and demonstrate its integration with a map-matching navigation filter. Relying on the ability of our model to simulate the sensor behaviour across various dynamic platform environments, we show that aiding navigation via map matching using quantum gravity gradiometry results in stable trajectories, and highlight the importance of non-Gaussian errors arising from platform dynamics as a key challenge to map-matching navigation. We derive requirements for mitigating these errors, such as maintaining sensor tilt below 3.3 degrees, to inform future sensor development priorities. This work demonstrates the value of an end-to-end approach that could support future optimization of the overall navigation system. Beyond navigation, our atom interferometer modelling framework could be relevant to current research and innovation endeavours with quantum gravimeters, gradiometers and inertial sensors.

quant-ph↗

arXiv2022

Magneto-optical trapping in a near-surface borehole

Borehole gravity sensing can be used in a number of applications to measure features around a well including rock-type change mapping and determination of reservoir porosity. Quantum technology gravity sensors based on atom interferometry have the ability to offer increased survey speeds and reduced need for calibration. While surface sensors have been demonstrated in real world environments, significant improvements in robustness and reductions to radial size, weight, and power consumption are required for such devices to be deployed in boreholes. To realise the first step towards the deployment of cold atom-based sensors down boreholes, we demonstrate a borehole-deployable magneto-optical trap, the core package of many cold atom-based systems. The enclosure containing the magneto-optical trap itself had an outer radius of ($60\pm0.1$) mm at its widest point and a length of ($890\pm5$) mm. This system was used to generate atom clouds at 1 m intervals in a 14 cm wide, 50 m deep borehole, to simulate an in-borehole gravity surveys are performed. During the survey the system generated on average clouds of (3.0 $\pm 0.1) \times 10^{5}$ $^{87}$Rb atoms with the standard deviation in atom number across the survey observed to be as low as $9 \times 10^{4}$.

physics.atom-ph↗

arXiv2020

Doppler Compensated Cavity For Atom Interferometry

We propose and demonstrate a scheme to enable Doppler compensation within optical cavities for atom interferometry at significantly increased mode diameters. This has the potential to overcome the primary limitations in cavity enhancement for atom interferometry, circumventing the cavity linewidth limit and enabling mode filtering, power enhancement, and a large beam diameter simultaneously. This approach combines a magnified linear cavity with an intracavity Pockels cell. The Pockels cell introduces a voltage tunable birefringence allowing the cavity mode frequencies to track the Raman lasers as they scan to compensate for gravitationally induced Doppler shifts, removing the dominant limitation of current cavity enhanced systems. A cavity is built to this geometry and shown to simultaneously realize the capability required for Doppler compensation, with a 5.04~mm $1/e^{2}$ diameter beam waist and an enhancement factor of $>$5x at a finesse of 35. Furthermore, this has a tunable Gouy phase, allowing the suppression of higher order spatial modes and the avoidance of regions of instability. This approach can therefore enable enhanced contrast and longer atom interferometry times while also enabling the key features of cavity enhanced atom interferometry, power enhancement and the reduction of aberrations. This is relevant to future reductions in the optical power requirement of quantum technology, or in providing enhanced performance for atom interferometers targeting fundamental science.

physics.atom-ph↗

arXiv2020

A Dielectric Metasurface Optical Chip for the Generation of Cold Atoms

Compact and robust cold atom sources are increasingly important for quantum research, especially for transferring cutting-edge quantum science into practical applications. In this letter, we report on a novel scheme that utilizes a metasurface optical chip to replace the conventional bulky optical elements used to produce a cold atomic ensemble with a single incident laser beam, which is split by the metasurface into multiple beams of the desired polarization states. Atom numbers $~10^7$ and temperatures (about 35 $μ$K) of relevance to quantum sensing are achieved in a compact and robust fashion. Our work highlights the substantial progress towards fully integrated cold atom quantum devices by exploiting metasurface optical chips, which may have great potential in quantum sensing, quantum computing and other areas.

physics.optics↗

arXiv2020

Performance of an optical single-sideband laser system for atom interferometry

This paper reports on a detailed performance characterization of a recently developed optical single-sideband (OSSB) laser system based on an IQ modulator and second-harmonic generation for rubidium atom interferometry experiments. The measured performance is used to evaluate the noise contributions of this OSSB laser system when it is applied to drive stimulated Raman transitions in $^{87}$Rb for precision measurements of gravitational acceleration. The laser system suppresses unwanted sideband components, but additional phase shift compensation needs to be applied when performing frequency chirps with such an OSSB laser system. The total phase noise contribution of the OSSB laser system in the current experiment is 72 mrad for a single atom-interferometry sequence with interrogation times of $T=120$ ms, which corresponds to a relative precision of 32 n$g$ per shot. The dominant noise sources are found in the relative intensity fluctuations between sideband and carrier components and the phase noise of the microwave source.

physics.atom-ph↗

arXiv2018

Application of optical single-sideband laser in Raman atom interferometry

A frequency doubled I/Q modulator based optical single-sideband (OSSB) laser system is demonstrated for atomic physics research, specifically for atom interferometry where the presence of additional sidebands causes parasitic transitions. The performance of the OSSB technique and the spectrum after second harmonic generation are measured and analyzed. The additional sidebands are removed with better than 20 dB suppression, and the influence of parasitic transitions upon stimulated Raman transitions at varying spatial positions is shown to be removed beneath experimental noise. This technique will facilitate the development of compact atom interferometry based sensors with improved accuracy and reduced complexity.

physics.atom-ph↗

arXiv2018

Additive manufacturing of magnetic shielding and ultra-high vacuum flange for cold atom sensors

Recent advances in the understanding and control of quantum technologies, such as those based on cold atoms, have resulted in devices with extraordinary metrological sensitivities. To realise this potential outside of a lab environment the size, weight and power consumption need to be reduced. Here we demonstrate the use of laser powder bed fusion, an additive manufacturing technique, as a production technique for the components that make up quantum sensors. As a demonstration we have constructed two key components using additive manufacturing, namely magnetic shielding and vacuum chambers. The initial prototypes for magnetic shields show shielding factors within a factor of 3 of conventional approaches. The vacuum demonstrator device shows that 3D-printed titanium structures are suitable for use as vacuum chambers, with the test system reaching base pressures of $5 \pm 0.5 \times 10^{-10}$ mbar. These demonstrations show considerable promise for the use of additive manufacturing for cold atom based quantum technologies, in future enabling improved integrated structures, allowing for the reduction in size, weight and assembly complexity.

physics.app-ph↗

arXiv2016

Collective strong coupling of cold potassium atoms in a ring cavity

We present experiments on ensemble cavity quantum electrodynamics with cold potassium atoms in a high-finesse ring cavity. Potassium-39 atoms are cooled in a two-dimensional magneto-optical trap and transferred to a three-dimensional trap which intersects the cavity mode. The apparatus is described in detail and the first observations of strong coupling with potassium atoms are presented. Collective strong coupling of atoms and light is demonstrated via the splitting of the cavity transmission spectrum and the avoided crossing of the normal modes.

physics.atom-ph↗

arXiv2013

One-dimensional photonic band gaps in optical lattices

The phenomenon of photonic band gaps in one-dimensional optical lattices is reviewed using a microscopic approach. Formally equivalent to the transfer matrix approach in the thermodynamic limit, a microscopic model is required to study finite-size effects, such as deviations from the Bragg condition. Microscopic models describing both scalar and vectorial light are proposed, as well as for two- and three-level atoms. Several analytical results are compared to experimental data, showing a good agreement.

physics.atom-ph↗