Searcharxiv⌕ Search

arXiv subjects

Michael P. Whitmore

Publications and source records attributed to Michael P. Whitmore.

3 recordsLinked to original sources

Predicting the onset of airfoil stall in transitional and turbulent flows with a pressure-gradient-based separation model for RANS simulations

We propose an improved version of the $k$-$ω$ shear-stress transport Reynolds-averaged Navier-Stokes model that supersedes our prior work (Griffin et al. 2024 J. Turb.) with an updated pressure-gradient sensor that generalizes well across geometries and to laminar, transitional, and turbulent flows alike. The model is based on a composite pressure gradient criterion that uses the solution of an intermittency transport equation to synthesize the separation criteria of the Falkner-Skan theory for laminar flows and the continuously critical theory for turbulent flows. The proposed model is applied to various airfoils including the thick airfoils representative of wind turbine applications (DU00-w-212, S809 and S814) and thinner airfoils used in aerospace applications [NACA23012 and NLF(1)-0416]. For all airfoils, the proposed model is found to preserve or improve the predictions of the baseline model for both fully turbulent and transitional airfoils as demonstrated with results for the lift and drag coefficients. The model is also found to improve the prediction of separation on the NREL Phase VI rotor in a preliminary study, suggesting that the model will generalize to other complex three-dimensional flows.

physics.flu-dyn↗

Multi-agent reinforcement learning for wall modeling in LES of flow over periodic hills

We develop a wall model for large-eddy simulation (LES) that takes into account various pressure-gradient effects using multi-agent reinforcement learning (MARL). The model is trained using low-Reynolds-number flow over periodic hills with agents distributed on the wall along the computational grid points. The model utilizes a wall eddy-viscosity formulation as the boundary condition, which is shown to provide better predictions of the mean velocity field, rather than the typical wall-shear stress formulation. Each agent receives states based on local instantaneous flow quantities at an off-wall location, computes a reward based on the estimated wall-shear stress, and provides an action to update the wall eddy viscosity at each time step. The trained wall model is validated in wall-modeled LES (WMLES) of flow over periodic hills at higher Reynolds numbers, and the results show the effectiveness of the model on flow with pressure gradients. The analysis of the trained model indicates that the model is capable of distinguishing between the various pressure gradient regimes present in the flow.

physics.flu-dyn↗

Non-Boussinesq subgrid-scale model with dynamic tensorial coefficients

A major drawback of Boussinesq-type subgrid-scale stress models used in large-eddy simulations is the inherent assumption of alignment between large-scale strain rates and filtered subgrid-stresses. A priori analyses using direct numerical simulation (DNS) data has shown that this assumption is invalid locally as subgrid-scale stresses are poorly correlated with the large-scale strain rates [Bardina et al., AIAA 1980; Meneveau and Liu, Ann. Rev. Fluid Mech. 2002]. In the present work, a new, non-Boussinesq subgrid-scale model is presented where the model coefficients are computed dynamically. Some previous non-Boussinesq models have observed issues in providing adequate dissipation of turbulent kinetic energy [e.g.: Bardina et al., AIAA 1980; Clark et al. J. Fluid Mech., 1979; Stolz and Adams, Phys. of Fluids, 1999]; however, the present model is shown to provide sufficient dissipation using dynamic coefficients. Modeled subgrid-scale Reynolds stresses satisfy the consistency requirements of the governing equations for LES, vanish in laminar flow and at solid boundaries, and have the correct asymptotic behavior in the near-wall region of a turbulent boundary layer. The new model, referred to as the dynamic tensor-coefficient Smagorinsky model (DTCSM), has been tested in simulations of canonical flows: decaying and forced homogeneous isotropic turbulence (HIT), and wall-modeled turbulent channel flow at high Reynolds numbers; the results show favorable agreement with DNS data. In order to assess the performance of DTCSM in more complex flows, wall-modeled simulations of high Reynolds number flow over a Gaussian bump exhibiting smooth-body flow separation are performed. Predictions of surface pressure and skin friction, compared against DNS and experimental data, show improved accuracy from DTCSM in comparison to the existing static coefficient (Vreman) and dynamic Smagorinsky model.

physics.flu-dyn↗