arXiv subjects

Michael Winklhofer

Publications and source records attributed to Michael Winklhofer.

11 recordsLinked to original sources

arXiv2026

Broad presence of ferromagnetism in bees and relationship to phylogeny, natural history, and sociality

Scientists have long been fascinated by magnetoreception, the innate capacity of many animals to sense and use the Earth's magnetic field for navigation. In eusocial insects like honey bees, magnetoreception has been linked to communication and foraging. However, little is known about magnetoreception's phylogenetic patterns and relationship to species traits and natural history. Here, we demonstrate that putative magnetoreception based on ferromagnetic particles is widespread across a diversity of bee species (72 out of 96 species tested), with no phylogenetic signal. We also detected such putative magnetoreception in non-bee outgroups, suggesting this magnetic capacity predates the evolution of the Anthophila. While magnetic signals were found across a diversity of life history traits, the strength of the magnetic signal varied within and between species, and increased with body size and social behavior.

q-bio.PE↗

arXiv2021

Full-Spin-Wave-Scaled Finite Element Stochastic Micromagnetism: Mesh-Independent FUSSS LLG Simulations of Ferromagnetic Resonance and Reversal

In this paper, we address the problem that standard stochastic Landau-Lifshitz-Gilbert (sLLG) simulations typically produce results that show unphysical mesh-size dependence. The root cause of this problem is that the effects of spin wave fluctuations are ignored in sLLG. We propose to represent the effect of these fluctuations by a "FUll-Spinwave-Scaled Stochastic LLG", or FUSSS LLG method. In FUSSS LLG, the intrinsic parameters of the sLLG simulations are first scaled by scaling factors that integrate out the spin wave fluctuations up to the mesh size, and the sLLG simulation is then performed with these scaled parameters. We developed FUSSS LLG by studying the Ferromagnetic Resonance (FMR) in Nd$_2$Fe$_{14}$B cubes. The nominal scaling greatly reduced the mesh size dependence relative to sLLG. We further discovered that adjusting one scaling exponent by less than 10% delivered fully mesh-size-independent results for the FMR peak. We then performed three tests and validations of our FUSSS LLG with this modified scaling. 1) We studied the same FMR but with magnetostatic fields included. 2) We simulated the total magnetization of the Nd$_2$Fe$_{14}$B cube. 3) We studied the effective, temperature- and sweeping rate-dependent coercive field of the cubes. In all three cases we found that FUSSS LLG delivered essentially mesh-size-independent results, which tracked the theoretical expectations better than unscaled sLLG. Motivated by these successful validations, we propose that FUSSS LLG provides marked, qualitative progress towards accurate, high precision modeling of micromagnetics in hard, permanent magnets.

physics.comp-ph↗

arXiv2020

Specific Heat of Spin Excitations Measured by FerromagneticResonance

Using ferromagnetic-resonance spectroscopy (FMR), we investigate the anisotropic properties of epitaxial 3 nmPt/2 nmAg/10 nmFe/10 nmAg/GaAs(001) films in fully saturated meta-stable states at temperatures ranging from 70 K to 280 K. By comparison to spin-wave theory calculations, we identify the role of thermal fluctuation of magnons in overcoming the energy barrier associated with these meta-stable states. We show that the energy associated with the size of the barrier that bounds the meta-stable regime is proportional to the heat stored in the magnonic bath. Our findings offer the possibility to measure the magnonic contribution to the heat capacity by FMR, independent of other contributions at temperatures ranging from 0 K to ambient temperature and above. The only requirement being that the selected sample exhibits magnetic anisotropy, here, magnetocrystalline anisotropy.

cond-mat.mtrl-sci↗

arXiv2018

Probability distribution of substituted Titanium in RT12 (R = Nd, Sm, T = Fe, Co) structures

We investigated the atomic fill site probability distributions across supercell structures of RT12-xTi (R=Nd, Sm, T=Fe, Co). We use a combined molecular dynamics and Boltzmann distribution approach to extrapolate the probability distributions for Ti substitution from lower to higher temperatures with an equilibrium condition to assess how temperature affects the predictability of the structures fill path. It was found that the Nd and Sm based Fe systems have the highest filling probability path at lower temperatures but the cohesive energy change due to Ti substitution in Sm and Nd based crystals indicates that a more stable system could be achieved with a combination Co and Fe in the transition metal site.

cond-mat.mtrl-sci↗

arXiv2017

A unified description of collective magnetic excitations

In this work, we define a set of analytic tools to describe the dynamic response of the magnetization to small perturbations, which can be used on its own or in combination with micromagnetic simulations and does not require saturation. We present a general analytic description of the ferromagnetic high frequency susceptibility tensor to describe angular as well as frequency dependent ferromagnetic resonance spectra and account for asymmetries in the line shape. Furthermore, we expand this model to reciprocal space and show how it describes the magnon dispersion. Finally we suggest a trajectory dependent solving tool to describe the equilibrium states of the magnetization.

cond-mat.other↗

arXiv2016

Magnetic Yoking and Tunable Interactions in FePt-Based Hard/Soft Bilayers

Assessing and controlling magnetic interactions in magnetic nanostructures are critical to nanomagnetic and spintronic explorations, such as magnetic recording media, permanent magnets, magnetic memory and logic devices, etc. Here we demonstrate an extremely sensitive magnetic yoking effect and tunable interactions in FePt based hard/soft bilayers mediated by the soft layer. Below the exchange length, a thin soft layer strongly exchange couples to the perpendicular moments of the hard layer; above the exchange length, just a few nanometers thicker, the soft layer moments turn in-plane and act to yoke the dipolar fields from the adjacent hard layer perpendicular domains. The evolution from exchange to dipolar-dominated interactions is experimentally captured by first-order reversal curves, the delta-M method, and polarized neutron reflectometry, and confirmed by micromagnetic simulations. These findings demonstrate an effective yoking approach to design and control magnetic interactions in wide varieties of magnetic nanostructures and devices.

cond-mat.mtrl-sci↗

arXiv2016

Influence of defect thickness on the angular dependence of coercivity in rare-earth permanent magnets

The coercive field and angular dependence of the coercive field of single-grain Nd$_{2}$Fe$_{14}$B permanent magnets are computed using finite element micromagnetics. It is shown that the thickness of surface defects plays a critical role in determining the reversal process. For small defect thicknesses reversal is heavily driven by nucleation, whereas with increasing defect thickness domain wall de-pinning becomes more important. This change results in an observable shift between two well-known behavioral models. A similar trend is observed in experimental measurements of bulk samples, where a Nd-Cu infiltration process has been used to enhance coercivity by modifying the grain boundaries. When account is taken of the imperfect grain alignment of real magnets, the single-grain computed results appears to closely match experimental behaviour.

cond-mat.mtrl-sci↗

arXiv2016

Grain-size dependent demagnetizing factors in permanent magnets

The coercive field of permanent magnets decreases with increasing grain size. The grain size dependence of coercivity is explained by a size dependent demagnetizing factor. In Dy free Nd$_2$Fe$_{14}$B magnets the size dependent demagnetizing factor ranges from 0.2 for a grain size of 55 nm to 1.22 for a grain size of 8300 nm. The comparison of experimental data with micromagnetic simulations suggests that the grain size dependence of the coercive field in hard magnets is due to the non-uniform magnetostatic field in polyhedral grains.

cond-mat.mtrl-sci↗

arXiv2014

Quantitative Decoding of Interactions in Tunable Nanomagnet Arrays Using First Order Reversal Curves

To develop a full understanding of interactions in nanomagnet arrays is a persistent challenge, critically impacting their technological acceptance. This paper reports the experimental, numerical and analytical investigation of interactions in arrays of Co nanoellipses using the first-order reversal curve (FORC) technique. A mean-field analysis has revealed the physical mechanisms giving rise to all of the observed features: a shift of the non-interacting FORC-ridge at the low-H$_c$ end off the local coercivity H$_c$ axis; a stretch of the FORC-ridge at the high-H$_c$ end without shifting it off the H$_c$ axis; and a formation of a tilted edge connected to the ridge at the low-H$_c$ end. Changing from flat to Gaussian coercivity distribution produces a negative feature, bends the ridge, and broadens the edge. Finally, nearest neighbor interactions segment the FORC-ridge. These results demonstrate that the FORC approach provides a comprehensive framework to qualitatively and quantitatively decode interactions in nanomagnet arrays.

cond-mat.mtrl-sci↗

arXiv2008

Does avian magnetoreception rely on both magnetite and maghemite?

Recently, a putative magnetoreceptor in the upper-beak skin of homing pigeons was chemically characterized using X-ray flourescence and absorbtion studies [Fleissner et al., 2007. A novel concept of Fe-mineral based magnetoreception: histological and physiochemical data from the upper beak of homing pigeons. Naturwissenschaften 94 (8), 631-642]. In this short communication we point out that the novel concept propagated is based on conclusions that are not supported by data and, in fact, stand in contradiction to previously published crystallographic and magnetic data.

physics.bio-ph↗

arXiv2005

Extracting the intrinsic switching field distribution in perpendicular media: a comparative analysis

We introduce a new method based on the first-order-reversal-curve (FORC) diagram to extract the intrinsic (microscopic) switching-field distribution (SFD) of perpendicular recording media (PRM). To demonstrate the viability of the method, we micromagnetically simulated FORCs for PRM with known SFD and compare the extracted SFD with the SFD obtained by means of two different methods that are based on recoil loops, too, which however rely on mean-field approximations and assumptions on the shape of the SFD. The FORC method turns out to be the most accurate algorithm over a broad range of dipolar interaction strengths, where the other methods overestimate the width of the SFD.

cond-mat.mtrl-sci↗