Michele Arturo Caponero

arXiv2026

A Nearable Soft Mat Based on Distributed Optical Fiber Sensing for Physiological Monitoring

Distributed optical fiber sensing (DOFS) combines the advantages of fiber optic sensors, including flexibility, small size, immunity to electromagnetic interference, and high metrological performance, with the capability to transform a single optical fiber into a continuous sensing element for spatially resolved mechanical measurements. Optical frequency domain reflectometry (OFDR), based on Rayleigh backscattering, enables high spatial resolution DOFS measurements, broadening the range of potential sensing applications. However, OFDR based DOFS remains largely unexplored for biomedical applications, despite the need for sensitive, spatially resolved, and conformable sensing interfaces. This study presents a soft DOFS based mat as a large-area interface for physiological monitoring. A single-mode optical fiber was embedded in a flexible silicone matrix and arranged in a serpentine layout to distribute sensing over the mat surface. With a gage pitch of 2.6 mm, the system provided 2250 sensing sites across the active area at a sampling frequency of 50 Hz. The mat was assessed on six healthy volunteers in a seated nearable configuration on the backrest of a standard office chair. The distributed output enabled two dimensional mapping of the mat response, reflecting back mat mechanical coupling and cardiorespiratory induced perturbations. Respiratory rate and heart rate were therefore estimated and compared with a reference wearable system. The maps revealed physiologically coherent spatial and temporal patterns, while the estimated rates showed good agreement with the reference measurements. These results demonstrate the feasibility of combining large area distributed sensing, spatial mapping, and quantitative cardiorespiratory monitoring within a DOFS based soft nearable interface.

cs.CV↗

arXiv2021

Identification of low energy nuclear recoils in a gas TPC with optical readout

The search for a novel technology able to detect and reconstruct nuclear recoil events in the keV energy range has become more and more important as long as vast regions of high mass WIMP-like Dark Matter candidate have been excluded. Gaseous Time Projection Chambers (TPC) with optical readout are very promising candidate combining the complete event information provided by the TPC technique to the high sensitivity and granularity of last generation scientific light sensors. A TPC with an amplification at the anode obtained with Gas Electron Multipliers (GEM) was tested at the Laboratori Nazionali di Frascati. Photons and neutrons from radioactive sources were employed to induce recoiling nuclei and electrons with kinetic energy in the range [1-100] keV. A He-CF4 (60/40) gas mixture was used at atmospheric pressure and the light produced during the multiplication in the GEM channels was acquired by a high position resolution and low noise scientific CMOS camera and a photomultiplier. A multi-stage pattern recognition algorithm based on an advanced clustering technique is presented here. A number of cluster shape observables are used to identify nuclear recoils induced by neutrons originated from a AmBe source against X-ray 55Fe photo-electrons. An efficiency of 18% to detect nuclear recoils with an energy of about 6 keV is reached obtaining at the same time a 96% 55Fe photo-electrons suppression. This makes this optically readout gas TPC a very promising candidate for future investigations of ultra-rare events as directional direct Dark Matter searches.

physics.ins-det↗