arXiv subjects

Minghwei Hong

Publications and source records attributed to Minghwei Hong.

5 recordsLinked to original sources

arXiv2026

Near-single-domain superconducting aluminum films on GaAs(111)A with exceptional crystalline quality for scalable quantum circuits

We have reproducibly grown near-single-domain superconducting aluminum (Al) films on GaAs(111)A wafers using molecular beam epitaxy. Synchrotron X-ray diffraction revealed twin-domain ratios of 0.00005 and 0.0003 for 19.4-nm- and 9.6-nm-thick films, respectively-the lowest reported for Al on any substrate and long considered unattainable for practical device platforms. Azimuthal scans across off-normal Al{$11\bar{1}$} reflections exhibit narrow full width at half maximum (FWHM) values down to $0.55^\circ$, unmatched by epi-Al grown by any other method. Normal scans showed a well-defined (111) orientation with pronounced Pendell\"osung fringes, and $\theta$-rocking-curve FWHM values down to $0.018^\circ$; the former indicates abrupt film-substrate and oxide-film interfaces. Electron backscatter diffraction mapping confirms macroscopic in-plane uniformity and the absence of $\Sigma$3 twin domains. Atomic force microscopy and scanning transmission electron microscopy confirmed atomically smooth surfaces and abrupt heterointerfaces. The films exhibit critical temperatures approaching bulk values, establishing a materials platform for scalable, high-coherence superconducting qubits.

quant-ph↗

arXiv2025

In situ Al$_2$O$_3$ passivation of epitaxial tantalum and aluminum films enables long-term stability in superconducting microwave resonators

Long-term stability of superconducting microwave resonators is essential for scalable quantum technologies; however, surface and interface degradation continue to limit device stability. Here, we demonstrate exceptional stability in microstrip resonators fabricated from epitaxial tantalum and aluminum films, protected by in situ deposited Al$_2$O$_3$ under ultra-high vacuum. These resonators initially exhibit internal quality factors (Qi) exceeding one million and maintain high performance with minimal degradation after up to fourteen months of air exposure. In contrast, devices relying on native surface oxides show substantial declines in Qi over time, indicating increased microwave losses. X-ray photoelectron spectroscopy reveals that the in situ Al$_2$O$_3$ effectively suppresses interfacial oxidation and preserves the chemical integrity of the underlying superconducting films, whereas native oxides permit progressive oxidation, leading to device degradation. These findings establish a robust, scalable passivation strategy that addresses a longstanding materials challenge in the development of superconducting quantum circuits.

quant-ph↗

arXiv2025

1/ f noise and two-level systems in MBE-grown Al thin films

Aluminum thin films are essential to the functionalities of electronic and quantum devices, where two-level systems (TLS) can degrade device performance. MBE-grown Al films may appeal to these applications due to their low TLS densities. We studied the energy distributions of TLS densities, g(E), in 10-nm-thick MBE-grown and electron-beam evaporated Al films through 1/f noise measurements between 80 and 360 K. At 300 K, the noise magnitudes in MBE-grown films are about three times lower than in the electron-beam evaporated films, corresponding to the g(E) values about ten times lower in the former than in the latter. Compared with previously established observations, we identified that the 1/f noise was generated by thermally activated TLS at grain boundaries.

cond-mat.mtrl-sci↗

arXiv2022

Electrically Sign-Reversible Topological Hall Effect in a Top-Gated Topological Insulator (Bi,Sb)2Te3 on a Ferrimagnetic Insulator Europium Iron Garnet

Topological Hall effect (THE), an electrical transport signature of systems with chiral spin textures like skyrmions, has been observed recently in topological insulator (TI)-based magnetic heterostructures. However, the intriguing interplay between the topological surface state and THE is yet to be fully understood. In this work, we report a large THE of ~10 ohm (~4 micro-ohm*cm) at 2 K with an electrically reversible sign in a top-gated 4 nm TI (Bi0.3Sb0.7)2Te3 (BST) grown on a ferrimagnetic insulator (FI) europium iron garnet (EuIG). Temperature, external magnetic field angle, and top gate bias dependences of magnetotransport properties were investigated and consistent with a skyrmion-driven THE. Most importantly, a sign change in THE was discovered as the Fermi level was tuned from the upper to the lower parts of the gapped Dirac cone and vice versa. This discovery is anticipated to impact technological applications in ultralow power skyrmion-based spintronics.

cond-mat.mes-hall↗

arXiv2021

Enormous Berry-Curvature-Driven Anomalous Hall Effect in Topological Insulator (Bi,Sb)2Te3 on Ferrimagnetic Europium Iron Garnet beyond 400 K

To realize the quantum anomalous Hall effect (QAHE) at elevated temperatures, the approach of magnetic proximity effect (MPE) was adopted to break the time-reversal symmetry in the topological insulator (Bi0.3Sb0.7)2Te3 (BST) based heterostructures with a ferrimagnetic insulator europium iron garnet (EuIG) of perpendicular magnetic anisotropy. Here we demonstrate phenomenally large anomalous Hall resistance (RAHE) exceeding 8 Ω (\r{ho}AHE of 3.2 μΩ*cm) at 300 K and sustaining to 400 K in 35 BST/EuIG samples, surpassing the past record of 0.28 Ω (\r{ho}AHE of 0.14 μΩ*cm) at 300 K. The remarkably large RAHE as attributed to an atomically abrupt, Fe-rich interface between BST and EuIG. Importantly, the gate dependence of the AHE loops shows no sign change with varying chemical potential. This observation is supported by our first-principles calculations via applying a gradient Zeeman field plus a contact potential on BST. Our calculations further demonstrate that the AHE in this heterostructure is attributed to the intrinsic Berry curvature. Furthermore, for gate-biased 4 nm BST on EuIG, a pronounced topological Hall effect (THE) coexisting with AHE is observed at the negative top-gate voltage up to 15 K. Interface tuning with theoretical calculations has opened up new opportunities to realize topologically distinct phenomena in tailored magnetic TI-based heterostructures.

cond-mat.mes-hall↗