arXiv subjects

Mitradeep Sarkar

Publications and source records attributed to Mitradeep Sarkar.

9 recordsLinked to original sources

arXiv2025

Mid-IR chirality and chiral thermal emission through twisting

Chirality in the mid-infrared spectral range plays a crucial role across physical, chemical, and biological sciences, yet sources of chiral infrared light do not currently exist. Their development, using principles from the mature field of metamaterials, requires complex three-dimensional architectures that call for high-resolution lithography. We leverage the natural optical anisotropy found in several van der Waals crystals, for example $α$-MoO$_3$, to demonstrate experimentally that its twisted bilayers break inversion-rotation symmetry and are thereby intrinsically chiral. Via direct thermal emission measurements of microscopic twisted bilayers, we demonstrate that these heterostructures generate chiral light through incandescence. Twisted configurations of van der Waals materials do not require any lithography, and offer a platform for large-scale chiral filters and thermal sources beyond conventional meta-architectures.

physics.optics↗

arXiv2024

Coherent Thermal Emission from Large-Scale Suspended Nanomechanical Membranes

Thermal radiation is an abundant form of incoherent light. Generating coherent infrared light through incandescence promises a cheap alternative to the costly and epitaxially complex quantum cascade laser, however it remains a fundamental challenge. Previous approaches leveraged the spatial coherence of polaritonic excitations that occur in the thermal near-field, by diffracting them into the far-field zone via patterned micro- or nano-scatterers. This approach requires high-resolution lithography, is difficult to scale-up, and yields limited outcoupled radiation due to the intrinsically polarized nature of polaritons. We overcome these limitations and report coherent thermal emission through simple wave interference. We show that unpatterned, millimeter-scale, suspended nanomechanical membranes of SiC operate for both linear polarizations and exhibit antenna-like directionality without relying on the excitation of near-field polaritons. The ability to generate polarization-insensitive, narrowband and spatially coherent incandescent light without lithography at large scales paves the way towards democratizing thermal infrared technologies.

physics.optics↗

arXiv2024

Design of narrowband infrared emitters by hybridizing guided-mode resonance structures with van der Waals materials

In this paper, narrowband emitters have been designed using particle swarm optimization (PSO) in the 10-20 μm infrared range. The device structure consists of an anisotropic α-MoO3 layer combined with the one- and two-dimensional guided-mode resonance structures. Well-defined absorption lines are present in the reflection spectrum for both TE and TM polarizations, thereby yielding narrowband emissivity at desired wavelengths. The band structure of the designed emitters under TM polarization demonstrates distinct features unlike its TE counterpart. These features are attributed to the interaction between guided-mode resonances and phonon polaritons. The results are relevant for applications in active and passive photonic elements in mid- and long-wave IR bands.

physics.optics↗

arXiv2023

Motion rejection and spectral unmixing for accurate estimation of in vivo oxygen saturation using multispectral optoacoustic tomography

Multispectral Optoacoustic Tomography (MSOT) uniquely enables spatial mapping in high resolution of oxygen saturation (SO$_2$), with potential applications in studying pathological complications and therapy efficacy. MSOT offers seamless integration with ultrasonography, by using a common ultrasound detector array. However, MSOT relies on multiple successive acquisitions of optoacoustic (OA) images at different optical wavelengths and the low frame rate of OA imaging makes the MSOT acquisition sensitive to body/respiratory motion. Moreover, estimation of SO$_2$ is highly sensitive to noise, and artefacts related to the respiratory motion of the animal were identified as the primary source of noise in MSOT.In this work, we propose a two-step image processing method for SO$_2$ estimation in deep tissues. First, to mitigate motion artefacts, we propose a method of selection of OA images acquired only during the respiratory pause of the animal, using ultrafast ultrasound images (USIs) acquired immediately after each OA acquisition (USI acquisition duration of 1.4 ms and a total delay of 7 ms). We show that gating is more effective using USIs than OA images at different optical wavelengths. Secondly, we propose a novel method which can estimate directly the SO$_2$ value of a pixel and at the same time evaluate the amount of noise present in that pixel. Hence, the method can efficiently eliminate the pixels dominated by noise from the final SO$_2$ map. Our post-processing method is shown to outperform conventional methods for SO$_2$ estimation, and the method was validated by in vivo oxygen challenge experiments.

physics.med-ph↗

arXiv2023

Deep-subwavelength Phase Retarders at Mid-Infrared Frequencies with van der Waals Flakes

Phase retardation is a cornerstone of modern optics, yet, at mid-infrared (mid-IR) frequencies, it remains a major challenge due to the scarcity of simultaneously transparent and birefringent crystals. Most materials resonantly absorb due to lattice vibrations occurring at mid-IR frequencies, and natural birefringence is weak, calling for hundreds of microns to millimeters-thick phase retarders for sufficient polarization rotation. We demonstrate mid-IR phase retardation with flakes of $α$-molybdenum trioxide ($α$-MoO$_3$) that are more than ten times thinner than the operational wavelength, achieving 90 degrees polarization rotation within one micrometer of material. We report conversion ratios above 50% in reflection and transmission mode, and wavelength tunability by several micrometers. Our results showcase that exfoliated flakes of low-dimensional crystals can serve as a platform for mid-IR miniaturized integrated polarization control.

physics.optics↗

arXiv2023

Retrieving optical parameters of emerging van der Waals flakes

High-quality low-dimensional layered and van der Waals materials are typically exfoliated, with sample cross sectional areas on the order of tens to hundreds of microns. The small size of flakes makes the experimental characterization of their dielectric properties unsuitable with conventional spectroscopic ellipsometry, due to beam-sample size mismatch and non-uniformities of the crystal axes. Previously, the experimental measurement of the dielectrirc permittivity of such microcrystals was carried out with near-field tip-based scanning probes. These measurements are sensitive to external conditions like vibrations and temperature, and require non-deterministic numerical fitting to some a priori known model. We present an alternative method to extract the in-plane dielectric permittivity of van der Waals microcrystals, based on identifying reflectance minima in spectroscopic measurements. Our method does not require complex fitting algorithms nor near field tip-based measurements and accommodates for small-area samples. We demonstrate the robustness of our method using hexagonal boron nitride and {\alpha}-MoO3, and recover their dielectric permittivities that are close to literature values.

physics.optics↗

arXiv2023

Design rules for active control of narrowband thermal emission using phase-change materials

We propose an analytical framework to design actively tunable narrowband thermal emitters at infrared frequencies. We exemplify the proposed design rules using phase-change materials (PCM), considering dielectric-to-dielectric PCMs (e.g. GSST) and dielectric-to-metal PCMs (e.g. $\mathrm{VO_2}$). Based on these, we numerically illustrate near-unity ON-OFF switching and arbitrarily large spectral shifting between two emission wavelengths, respectively. The proposed systems are lithography-free and consist of one or several thin emitter layers, a spacer layer which includes the PCM, and a back reflector. Our model applies to normal incidence, though we show that the behavior is essentially angle-independent. The presented formalism is general and can be extended to \textit{any} mechanism that modifies the optical properties of a material, such as electrostatic gating or thermo-optical modulation.

physics.optics↗

arXiv2022

Lithography-free directional control of thermal emission

Blackbody thermal emission is spatially diffuse. Achieving highly directional thermal emission typically requires nanostructuring the surface of the thermally emissive medium. The most common configuration is a subwavelength grating that scatters surface polaritonic modes from the near-field to the far-field and produces antenna-like lobes of thermal emission. This concept, however, is typically limited to a particular linear polarization, and requires sophisticated lithography. Here, we revisit the simple motif of a planar Salisbury screen. We show analytically how the interplay between the real and imaginary part of the dielectric permittivity of the emitter layer defines the directional characteristics of emission, which can range from diffuse to highly directional. We propose a realistic configuration and show that hexagonal Boron Nitride thin films can enable grating-like thermal emission lobes in a lithography-free platform.

physics.optics↗

arXiv2022

Calibrated photoacoustic spectrometer based on a conventional imaging system for in vitro characterization of contrast agents

Photoacoustic (PA) imaging systems are spreading in the biomedical community, and the de-velopment of new PA contrast agents is an active area of research. However, PA contrast agents are usually characterized with spectrophotometry or uncalibrated PA imaging systems, leading to partial assessment of their PA efficiency. To enable quantitative PA spectroscopy of contrast agents in vitro with conventional PA imaging systems, we have developed an adapted calibration method. Contrast agents in solution are injected in a dedicated non-scattering tube phantom imaged at different optical wavelengths. The calibration method uses a reference solu-tion of cupric sulfate to simultaneously correct for the spectral energy distribution of excitation light at the tube location and perform a conversion of the tube amplitude in the image from ar-bitrary to spectroscopic units. The method does not require any precise alignment and provides quantitative PA spectra, even with non-uniform illumination and ultrasound sensitivity. It was implemented on a conventional imaging setup based on a tunable laser operating between 680 nm and 980 nm and a 5 MHz clinical ultrasound array. We demonstrated robust calibrated PA spectroscopy with sample volumes as low as 15 μL of known chromophores and commonly used contrast agents. The validated method will be an essential and accessible tool for the de-velopment of new and efficient PA contrast agents by improving their quantitative characterization.

physics.ins-det↗