Searcharxiv⌕ Search

arXiv subjects

Motoaki Nakatsutsumi

Publications and source records attributed to Motoaki Nakatsutsumi.

28 records · Page 2Linked to original sources

Optimizing laser coupling, matter heating, and particle acceleration from solids using multiplexed ultraintense lasers

Realizing the full potential of ultrahigh-intensity lasers for particle and radiation generation will require multi-beam arrangements due to technology limitations. Here, we investigate how to optimize their coupling with solid targets. Experimentally, we show that overlapping two intense lasers in a mirror-like configuration onto a solid with a large preplasma can greatly improve the generation of hot electrons at the target front and ion acceleration at the target backside. The underlying mechanisms are analyzed through multidimensional particle-in-cell simulations, revealing that the self-induced magnetic fields driven by the two laser beams at the target front are susceptible to reconnection, which is one possible mechanism to boost electron energization. In addition, the resistive magnetic field generated during the transport of the hot electrons in the target bulk tends to improve their collimation. Our simulations also indicate that such effects can be further enhanced by overlapping more than two laser beams.

physics.plasm-ph↗

Cylindrical compression of thin wires by irradiation with a Joule-class short pulse laser

Equation of state measurements at Jovian or stellar conditions are currently conducted by dynamic shock compression driven by multi-kilojoule multi-beam nanosecond-duration lasers. These experiments require precise design of the target and specific tailoring of the spatial and temporal laser profiles to reach the highest pressures. At the same time, the studies are limited by the low repetition rate of the lasers. Here, we show that by the irradiation of a thin wire with single beam Joule-class short-pulse laser, a converging cylindrical shock is generated compressing the wire material to conditions relevant for the above applications. The shockwave was observed using Phase Contrast Imaging employing a hard X-ray Free Electron Laser with unprecedented temporal and spatial sensitivity. The data collected for Cu wires is in agreement with hydrodynamic simulations of an ablative shock launched by a highly-impulsive and transient resistive heating of the wire surface. The subsequent cylindrical shockwave travels towards the wire axis and is predicted to reach a compression factor of 9 and pressures above 800 Mbar. Simulations for astrophysical relevant materials underline the potential of this compression technique as a new tool for high energy density studies at high repetition rates.

physics.plasm-ph↗

Visualizing Plasmons and Ultrafast Kinetic Instabilities in Laser-Driven Solids using X-ray Scattering

Ultra-intense lasers that ionize and accelerate electrons in solids to near the speed of light can lead to kinetic instabilities that alter the laser absorption and subsequent electron transport, isochoric heating, and ion acceleration. These instabilities can be difficult to characterize, but a novel approach using X-ray scattering at keV energies allows for their visualization with femtosecond temporal resolution on the few nanometer mesoscale. Our experiments on laser-driven flat silicon membranes show the development of structure with a dominant scale of $~60\unit{nm}$ in the plane of the laser axis and laser polarization, and $~95\unit{nm}$ in the vertical direction with a growth rate faster than $0.1/\mathrm{fs}$. Combining the XFEL experiments with simulations provides a complete picture of the structural evolution of ultra-fast laser-induced instability development, indicating the excitation of surface plasmons and the growth of a new type of filamentation instability. These findings provide new insight into the ultra-fast instability processes in solids under extreme conditions at the nanometer level with important implications for inertial confinement fusion and laboratory astrophysics.

physics.plasm-ph↗

Ultra-fast yttrium hydride chemistry at high pressures via non-equilibrium states induced by x-ray free electron laser

Controlling the formation and stoichiometric content of desired phases of materials has become a central interest for the study of a variety of fields, notably high temperature superconductivity under extreme pressures. The further possibility of accessing metastable states by initiating reactions by x-ray triggered mechanisms over ultra-short timescales is enabled with the development of x-ray free electron lasers (XFEL). Utilizing the exceptionally high brilliance x-ray pulses from the EuXFEL, we report the synthesis of a previously unobserved yttrium hydride under high pressure, along with non-stoichiometric changes in hydrogen content as probed at a repetition rate of 4.5\,MHz using time-resolved x-ray diffraction. Exploiting non-equilibrium pathways we synthesize and characterize a hydride with yttrium cations in an \textit{A}15 structure type at 125\,GPa, predicted using crystal structure searches, with a hydrogen content between 4.0--5.75 hydrogens per cation, that is enthalpically metastable on the convex hull. We demonstrate a tailored approach to changing hydrogen content using changes in x-ray fluence that is not accessible using conventional synthesis methods, and reveals a new paradigm in metastable chemical physics.

cond-mat.mtrl-sci↗

Probing the dynamics of solid density micro-wire targets after ultra-intense laser irradiation using a free-electron laser

In this paper, we present an experiment that explores the plasma dynamics of a 7 micron diameter carbon wire after being irradiated with a near-relativistic-intensity short pulse laser. Using an X-ray Free Electron Laser pulse to measure the small angle X-ray scattering signal, we observe that the scattering surface is bent and prone to instability over tens of picoseconds. The dynamics of this process are consistent with the presence of a sharp, propagating shock front inside the wire, moving at a speed close to the hole boring velocity.

physics.plasm-ph↗

Heating in Multi-Layer Targets at ultra-high Intensity Laser Irradiation and the Impact of Density Oscillation

We present a computational study of isochoric heating in multi-layered targets at ultra-high intensity laser irradiation (approx. 10**20 W/cm**2). Previous studies have shown enhanced ion heating at interfaces, but at the cost of large temperature gradients. Here, we study multi-layered targets to spread this enhanced interface heating to the entirety of the target and find heating parameters at which the temperature distribution is more homogeneous than at a single interface while still exceeding the mean temperature of a non-layered target. Further, we identify a pressure oscillation that causes the layers to alternate between expanding and being compressed with non beneficial effect on the heating. Based on that, we derive an analytical model estimating the oscillation period to find target conditions that optimize heating and temperature homogeneity. This model can also be used to infer the plasma temperature from the oscillation period which can be measured e.g. by XFEL probing.

physics.plasm-ph↗

Amortized Bayesian Inference of GISAXS Data with Normalizing Flows

Grazing-Incidence Small-Angle X-ray Scattering (GISAXS) is a modern imaging technique used in material research to study nanoscale materials. Reconstruction of the parameters of an imaged object imposes an ill-posed inverse problem that is further complicated when only an in-plane GISAXS signal is available. Traditionally used inference algorithms such as Approximate Bayesian Computation (ABC) rely on computationally expensive scattering simulation software, rendering analysis highly time-consuming. We propose a simulation-based framework that combines variational auto-encoders and normalizing flows to estimate the posterior distribution of object parameters given its GISAXS data. We apply the inference pipeline to experimental data and demonstrate that our method reduces the inference cost by orders of magnitude while producing consistent results with ABC.

cs.LG↗

Nanoscale subsurface dynamics of solids upon high-intensity laser irradiation observed by femtosecond grazing-incidence x-ray scattering

Observing ultrafast laser-induced structural changes in nanoscale systems is essential for understanding the dynamics of intense light-matter interactions. For laser intensities on the order of $10^{14} \, \rm W/cm^2$, highly-collisional plasmas are generated at and below the surface. Subsequent transport processes such as heat conduction, electron-ion thermalization, surface ablation and resolidification occur at picosecond and nanosecond time scales. Imaging methods, e.g. using x-ray free-electron lasers (XFEL), were hitherto unable to measure the depth-resolved subsurface dynamics of laser-solid interactions with appropriate temporal and spatial resolution. Here we demonstrate picosecond grazing-incidence small-angle x-ray scattering (GISAXS) from laser-produced plasmas using XFEL pulses. Using multi-layer (ML) samples, both the surface ablation and subsurface density dynamics are measured with nanometer depth resolution. Our experimental data challenges the state-of-the-art modeling of matter under extreme conditions and opens new perspectives for laser material processing and high-energy-density science.

physics.plasm-ph↗

Probing ultrafast laser plasma processes inside solids with resonant small-angle X-ray scattering

Extreme states of matter exist throughout the universe e.g. inside planetary cores, stars or astrophysical jets. Such conditions are generated in the laboratory in the interaction of powerful lasers with solids, and their evolution can be probed with femtosecond precision using ultra-short X-ray pulses to study laboratory astrophysics, laser-fusion research or compact particle acceleration. X-ray scattering (SAXS) patterns and their asymmetries occurring at X-ray energies of atomic bound-bound transitions contain information on the volumetric nanoscopic distribution of density, ionization and temperature. Buried heavy ion structures in high intensity laser irradiated solids expand on the nanometer scale following heat diffusion, and are heated to more than 2 million Kelvin. These experiments demonstrate resonant SAXS with the aim to better characterize dynamic processes in extreme laboratory plasmas.

physics.plasm-ph↗

Observation of ultrafast solid-density plasma dynamics using femtosecond X-ray pulses from a free-electron laser

The complex physics of the interaction between short pulse high intensity lasers and solids is so far hardly accessible by experiments. As a result of missing experimental capabilities to probe the complex electron dynamics and competing instabilities, this impedes the development of compact laser-based next generation secondary radiation sources, e.g. for tumor therapy [Bulanov2002,ledingham2007], laboratory-astrophysics [Remington1999,Bulanov2015], and fusion [Tabak2014]. At present, the fundamental plasma dynamics that occur at the nanometer and femtosecond scales during the laser-solid interaction can only be elucidated by simulations. Here we show experimentally that small angle X-ray scattering of femtosecond X-ray free-electron laser pulses facilitates new capabilities for direct in-situ characterization of intense short-pulse laser plasma interaction at solid density that allows simultaneous nanometer spatial and femtosecond temporal resolution, directly verifying numerical simulations of the electron density dynamics during the short pulse high intensity laser irradiation of a solid density target. For laser-driven grating targets, we measure the solid density plasma expansion and observe the generation of a transient grating structure in front of the pre-inscribed grating, due to plasma expansion, which is an hitherto unknown effect. We expect that our results will pave the way for novel time-resolved studies, guiding the development of future laser-driven particle and photon sources from solid targets.

physics.plasm-ph↗