arXiv subjects

Muir Kumph

Publications and source records attributed to Muir Kumph.

7 recordsLinked to original sources

arXiv2025

Distilled remote entanglement between superconducting qubits across optical channels

A promising quantum computing architecture comprises modules of superconducting quantum processors linked via optical channels using quantum transducers. As quantum transducer hardware improves, a need has arisen to understand the quantitative relationship between transducer-device characteristics and the strength of the resulting remote entanglement. Using Monte Carlo simulations that incorporate 2-to-1 and 3-to-1 entanglement distillation methods, our model maps transducer device performance up to system-level channel performance, thereby allowing the performance of remote entanglement approaches to be compared and optimized. We find the extreme photon loss (EPL) distillation protocol to be particularly high performing. Moreover, even without distillation, present-day transducers with added noise of photons are at the threshold of enabling remote Bell pairs with fidelities exceeding 50%. If the next generation of transducers can improve by 3 orders of magnitude in added noise, efficiency, and repetition rates, then they would allow for remote two-qubit gates achieving 99.7% fidelities at MHz rates. These results set practical targets for transducers to be ready for deployment into modular quantum computing systems.

quant-ph↗

arXiv2024

Demonstration of RIP gates in a quantum processor with negligible transverse coupling

Here, we report the experimental demonstration of a novel multi-mode linear bus interferometer (LBI) coupler in a six qubit superconducting quantum processor. A key feature of this coupler is an engineered multi-path interference which eliminates transverse coupling between qubits over a wide frequency range. This negligible static coupling is achieved without any flux bias tuning, and greatly reduces the impact of qubit frequency collisions. We achieve good simultaneous single qubit gate operation and low ZZ rates (below 600 Hz) across the device without staggering qubit frequencies, even in cases where qubits are as close as 10 MHz. Multi-qubit interactions are still possible through the coupler using microwave-driven resonator induced phase gates, which we utilize to demonstrate simultaneous two qubit gates with fidelities as high as 99.4%

quant-ph↗

arXiv2019

An Experimental Study of Shor's Factoring Algorithm on IBM Q

We study the results of a compiled version of Shor's factoring algorithm on the ibmqx5 superconducting chip, for the particular case of $N=15$, $21$ and $35$. The semi-classical quantum Fourier transform is used to implement the algorithm with only a small number of physical qubits and the circuits are designed to reduce the number of gates to the minimum. We use the square of the statistical overlap to give a quantitative measure of the similarity between the experimentally obtained distribution of phases and the predicted theoretical distribution one for different values of the period. This allows us to assign a period to the experimental data without the use of the continued fraction algorithm. A quantitative estimate of the error in our assignment of the period is then given by the overlap coefficient.

quant-ph↗

arXiv2015

Electric-Field Noise above a Thin Dielectric Layer on Metal Electrodes

The electric-field noise above a layered structure composed of a planar metal electrode covered by a thin dielectric is evaluated and it is found that the dielectric film considerably increases the noise level, in proportion to its thickness. Importantly, even a thin (mono) layer of a low-loss dielectric can enhance the noise level by several orders of magnitude compared to the noise above a bare metal. Close to this layered surface, the power spectral density of the electric field varies with the inverse fourth power of the distance to the surface, rather than with the inverse square, as it would above a bare metal surface. Furthermore, compared to a clean metal, where the noise spectrum does not vary with frequency (in the radio-wave and microwave bands), the dielectric layer can generate electric-field noise which scales in inverse proportion to the frequency. For various realistic scenarios, the noise levels predicted from this model are comparable to those observed in trapped-ion experiments. Thus, these findings are of particular importance for the understanding and mitigation of unwanted heating and decoherence in miniaturized ion traps.

cond-mat.mtrl-sci↗

arXiv2015

Cryogenic silicon surface ion trap

Trapped ions are pre-eminent candidates for building quantum information processors and quantum simulators. They have been used to demonstrate quantum gates and algorithms, quantum error correction, and basic quantum simulations. However, to realise the full potential of such systems and make scalable trapped-ion quantum computing a reality, there exist a number of practical problems which must be solved. These include tackling the observed high ion-heating rates and creating scalable trap structures which can be simply and reliably produced. Here, we report on cryogenically operated silicon ion traps which can be rapidly and easily fabricated using standard semiconductor technologies. Single $^{40}$Ca$^+$ ions have been trapped and used to characterize the trap operation. Long ion lifetimes were observed with the traps exhibiting heating rates as low as $\dot{\bar{n}}=$ 0.33 phonons/s at an ion-electrode distance of 230 $μ$m. These results open many new avenues to arrays of micro-fabricated ion traps.

quant-ph↗

arXiv2014

Operation of a planar-electrode ion-trap array with adjustable RF electrodes

One path to realizing systems of trapped atomic ions suitable for large-scale quantum computing and simulation is to create a two-dimensional array of ion traps. Interactions between nearest-neighbouring ions could then be turned on and off by tuning the ions' relative positions and frequencies. We demonstrate and characterize the operation of a planar-electrode ion-trap array. Driving the trap with a network of phase-locked radio-frequency (RF) resonators which provide independently variable voltage amplitudes we vary the position and motional frequency of a 40Ca+ ion in two dimensions within the trap array. With suitable miniaturization of the trap structure, this provides a viable architecture for large-scale quantum simulations.

quant-ph↗

arXiv2011

Two-Dimensional Arrays of RF Ion Traps with Addressable Interactions

We describe the advantages of 2-dimensional, addressable arrays of spherical Paul traps. They would provide for the ability to address and tailor the interaction strengths of trapped objects in 2D and could establish a valuable new tool for quantum information processing. Simulations of trapping ions are compared to first tests using printed circuit board trap arrays loaded with dust particles. Pair-wise interactions in the array are addressed by means of an adjustable radio-frequency (RF) electrode shared between trapping sites. By attenuating this RF electrode potential, neighboring pairs of trapped objects have their interaction strength increase and are moved closer to one another. In the limit of the adjustable electrode being held at RF ground, the two formerly spherical traps are merged into one linear Paul trap.

quant-ph↗