SearcharxivSearch

arXiv subjects

Murat Bayraktar

Publications and source records attributed to Murat Bayraktar.

10 recordsLinked to original sources

Fuse-then-Detect for Passive UAV Localization Using Multi-UE 5G Uplink Signals

Low-altitude uncrewed aerial vehicles (UAVs) can pose growing risks to airspace safety, security, and privacy. Cellular infrastructure can passively sense them without dedicated radar hardware by exploiting integrated sensing and communication (ISAC) technology. Most prior work exploits monostatic sensing or bistatic/multistatic configurations based on downlink measurements. To the best of our knowledge, this paper presents the first uplink framework, where multiple user equipments (UEs) transmit sounding reference signal (SRS) pilots and the base station (BS) receives the UAV-scattered echoes. Sensing from uplink SRS, however, introduces new challenges. Each UE has its own oscillator and timing loop, so the channel estimate at the BS carries residual timing, frequency, and amplitude impairments that corrupt the UAV delay and Doppler. Moreover, the UAV echo is weaker than both the line-of-sight (LOS) path and urban clutter, so detection from a single UE transmission is not reliable. We address these challenges by designing a LOS-referenced synchronization scheme and a joint detector. The synchronization reuses the existing timing advance (TA) command and an adjacent-occasion conjugate product to remove the residuals without additional signaling. Then the detector searches a shared 3D state space and accumulates evidence across UEs. It leverages a normalized contrast that exploits the bistatic geometry. We evaluate the framework in a cluttered urban scene at frequency range 1 (FR1) with four pedestrian UEs and a 100 MHz 5G New Radio (NR) waveform. The proposed pipeline achieves sub-nanosecond synchronization and a 4.84 m median 3D position error.

eess.SP

Joint UE positioning and distributed sensing in the upper mid-band exploiting virtual apertures

Networks exploiting distributed integrated sensing and communication (DISAC) nodes can provide enhanced localization and sensing performance, further emphasized when operating with large arrays and bandwidths available in the upper mid-band (also known as FR3). In this paper, we consider a DISAC system operating at FR3 where a single base station (BS) acts as the transmitter and several vehicular user equipments (UEs) act as the receivers. We tackle the design of the signal processing chain at the UE side to enable joint UE positioning and target localization. The system model exploits a multiple-input-multiple-output orthogonal frequency division multiplexing (MIMO-OFDM) waveform, and incorporates practical effects such as inter-node timing offsets (TOs), extended targets, dense multipath, and realistic uniform planar arrays (UPAs) at both ends. The proposed design includes a multipath estimation stage at each UE, clutter removal, a novel clustering and association scheme, and a final joint estimator of UE positions and target locations. The estimator solves a weighted least squares (WLS) problem to jointly compute clock offsets and localize UEs and targets. Numerical results considering two UEs and two targets show that for 80\% of the cases the target localization error is below 32cm, while the UE positioning error is below 44cm.

eess.SP

Interference-Aware Multiuser Hybrid Precoding for Coexistence with LEO Satellite Communication

Interference from terrestrial networks can reduce the communication rate for low Earth orbit (LEO) satellites in the upper mid-band. To coexist in frequency, MIMO precoding can be used to reduce the signal that impinges on the LEO satellite. We present a beamforming algorithm designed for the hybrid architecture that incorporates a satellite interference penalty while optimizing the analog and digital precoders. Our algorithm optimizes the precoding at the base station (BS) within the set of precoders that null the interference to the satellite. Simulations demonstrate that our algorithm reduces the interference at the satellites and lowers the probability of violating prescribed LEO satellite protection thresholds, outperforming prior hybrid nulling algorithms. Results indicate that the algorithm maintains sum-rate within 3\% of the existing hybrid solutions, while effectively improving interference to noise power by 22.4 dB.

eess.SP

Integrated Monostatic Sensing and Full-Duplex Multiuser Communication for mmWave Systems

In this paper, we propose a hybrid precoding/combining framework for communication-centric integrated sensing and full-duplex (FD) communication operating at mmWave bands. The designed precoders and combiners enable multiuser (MU) FD communication while simultaneously supporting monostatic sensing in a frequency-selective setting. The joint design of precoders and combiners involves the mitigation of self-interference (SI) caused by simultaneous transmission and reception at the FD base station (BS). Additionally, MU interference needs to be handled by the precoder/combiner design. The resulting optimization problem involves non-convex constraints since hybrid analog/digital architectures utilize networks of phase shifters. To solve the proposed problem, we separate the optimization of each precoder/combiner, and design each one of them while fixing the others. The precoders at the FD BS are designed by reformulating the communication and sensing constraints as signal-to-leakage-plus-noise ratio (SLNR) maximization problems that consider SI and MU interference as leakage. Furthermore, we design the frequency-flat analog combiner such that the residual SI at the FD BS is minimized under communication and sensing gain constraints. Finally, we design an interference-aware digital combining stage that separates MU signals and target reflections. The communication performance and sensing results show that the proposed framework efficiently supports both functionalities simultaneously.

eess.SP

The Integrated Sensing and Communication Revolution for 6G: Vision, Techniques, and Applications

Future wireless networks will integrate sensing, learning and communication to provide new services beyond communication and to become more resilient. Sensors at the network infrastructure, sensors on the user equipment, and the sensing capability of the communication signal itself provide a new source of data that connects the physical and radio frequency environments. A wireless network that harnesses all these sensing data can not only enable additional sensing services, but also become more resilient to channel-dependent effects like blockage and better support adaptation in dynamic environments as networks reconfigure. In this paper, we provide a vision for integrated sensing and communication (ISAC) networks and an overview of how signal processing, optimization and machine learning techniques can be leveraged to make them a reality in the context of 6G. We also include some examples of the performance of several of these strategies when evaluated using a simulation framework based on a combination of ray tracing measurements and mathematical models that mix the digital and physical worlds.

eess.SP

Hybrid Precoding and Combining for mmWave Full-Duplex Joint Radar and Communication Systems under Self-Interference

In the context of integrated sensing and communication (ISAC), a full-duplex (FD) transceiver can operate as a monostatic radar while maintaining communication capabilities. This paper investigates the design of precoders and combiners for a joint radar and communication (JRC) system at mmWave frequencies. The primary goal of the design is to guarantee certain performance in terms of some sensing and communication metrics while minimizing the self-interference (SI) caused by FD operation and taking into account the hardware limitations coming from a hybrid MIMO architecture. Specifically, we introduce a generalized eigenvalue-based precoder design that considers the downlink user rate, the radar gain, and the SI suppression. Since the hybrid analog/digital architecture degrades the SI mitigation capability of the precoder, we further enhance SI suppression with the analog combiner. Our numerical results demonstrate that the proposed architecture achieves the required radar gain and SI mitigation while incurring a small loss in downlink spectral efficiency. Additionally, the numerical experiments also show that the use of orthogonal frequency division multiplexing (OFDM) radar with the proposed beamforming architecture results in highly accurate range and velocity estimates for the detected targets.

eess.SP

Autoregressive Attention Neural Networks for Non-Line-of-Sight User Tracking with Dynamic Metasurface Antennas

User localization and tracking in the upcoming generation of wireless networks have the potential to be revolutionized by technologies such as the Dynamic Metasurface Antennas (DMAs). Commonly proposed algorithmic approaches rely on assumptions about relatively dominant Line-of-Sight (LoS) paths, or require pilot transmission sequences whose length is comparable to the number of DMA elements, thus, leading to limited effectiveness and considerable measurement overheads in blocked LoS and dynamic multipath environments. In this paper, we present a two-stage machine-learning-based approach for user tracking, specifically designed for non-LoS multipath settings. A newly proposed attention-based Neural Network (NN) is first trained to map noisy channel responses to potential user positions, regardless of user mobility patterns. This architecture constitutes a modification of the prominent vision transformer, specifically modified for extracting information from high-dimensional frequency response signals. As a second stage, the NN's predictions for the past user positions are passed through a learnable autoregressive model to exploit the time-correlated channel information and obtain the final position predictions. The channel estimation procedure leverages a DMA receive architecture with partially-connected radio frequency chains, which results to reduced numbers of pilots. The numerical evaluation over an outdoor ray-tracing scenario illustrates that despite LoS blockage, this methodology is capable of achieving high position accuracy across various multipath settings.

eess.SP

Multidimensional Orthogonal Matching Pursuit-based RIS-aided Joint Localization and Channel Estimation at mmWave

RIS-aided millimeter wave wireless systems benefit from robustness to blockage and enhanced coverage. In this paper, we study the ability of RIS to also provide enhanced localization capabilities as a by-product of communication. We consider sparse reconstruction algorithms to obtain high resolution channel estimates that are mapped to position information. In RIS-aided mmWave systems, the complexity of sparse recovery becomes a bottleneck, given the large number of elements of the RIS and the large communication arrays. We propose to exploit a multidimensional orthogonal matching pursuit strategy for compressive channel estimation in a RIS-aided millimeter wave system. We show how this algorithm, based on computing the projections on a set of independent dictionaries instead of a single large dictionary, enables high accuracy channel estimation at reduced complexity. We also combine this strategy with a localization approach which does not rely on the absolute time of arrival of the LoS path. Localization results in a realistic 3D indoor scenario show that RIS-aided wireless system can also benefit from a significant improvement in localization accuracy.

eess.SP

An Efficient Interference-Aware Constrained Massive MIMO Beamforming for mm-Wave JSDM

Low-complexity beamformer design with practical constraints is an attractive research area for hybrid analog/digital systems in mm-wave massive multiple-input multiple-output (MIMO). This paper investigates interference-aware pre-beamformer (analog beamformer) design for joint spatial division and multiplexing (JSDM) which is a user-grouping based two-stage beamforming method. Single-carrier frequency domain equalization (SC-FDE) is employed in uplink frequency-selective channels. First, unconstrained slowly changing statistical analog beamformer of each group, namely, generalized eigenbeamformer (GEB) which has strong interference suppression capability is designed where the mutual information in reduced dimension is maximized. Then, constant-modulus constrained approximations of unconstrained beamformer are obtained by utilizing alternating minimization algorithms for fully connected arrays and fixed subarrays. In addition, a dynamic subarray algorithm is proposed where the connections between radio frequency (RF) chains and antennas are changed with changing channel statistics. Convergence of the proposed alternating minimization-based algorithms are provided along with their complexity analysis. It is observed that additional complexity of proposed algorithms is insignificant for the overall system design. Although most of the interference is suppressed with the help of proposed constrained beamformers, there may be some residual interference after the analog beamforming stage. Therefore, linear minimum mean square error (LMMSE) type digital beamformers, which take the residual interference in reduced dimension into account, are proposed instead of zero-forcing (ZF) type. Simulation results verify the superiority of the proposed interference-aware constrained design over existing approaches in terms of beampattern, spectral efficiency, outage capacity and channel estimation accuracy.

cs.IT

An Efficient Code-Domain NOMA Transceiver for mm-Wave Hybrid Massive MIMO Architectures

Massive MIMO and non-orthogonal multiple access (NOMA) are crucial methods for future wireless systems as they provide many advantages over conventional systems. Power-domain NOMA methods are investigated in massive MIMO systems, whereas there is little work on integration of code-domain NOMA and massive MIMO which is the subject of this study. We propose a general framework employing user-grouping based hybrid beamforming architecture for mm-wave massive MIMO systems where NOMA is considered as an intra-group process. It is shown that classical receivers of sparse code multiple access (SCMA) and multi-user shared access (MUSA) can be directly adapted. Additionally, a novel receiver architecture which is an improvement over classical one is proposed for uplink MUSA. This receiver makes MUSA preferable over SCMA for uplink transmission with lower complexity. We provide a lower bound on achievable information rate (AIR) as a performance measure. We show that code-domain NOMA schemes outperform conventional methods with very limited number of radio frequency (RF) chains where users are spatially close to each other. Furthermore, we provide an analysis in terms of bit-error rate and AIR under different code length and overloading scenarios for uplink transmission where flexible structure of MUSA is exploited.

cs.IT