arXiv subjects

N. Hitomi

Publications and source records attributed to N. Hitomi.

3 recordsLinked to original sources

arXiv2000

Design, fabrication and measurement of the first rounded damped detuned accelerator structure (RDDS1)

As a joint effort in the JLC/NLC research program, we have developed a new type of damped detuned accelerator structure with optimized round-shaped cavities (RDDS). This paper discusses some important R&D aspects of the first structure in this series (RDDS1). The design aspects covered are the cell design with sub-MHz precision, HOM detuning, coupling and damping technique and wakefield simulation. The fabrication issues covered are ultra-precision cell machining with micron accuracy, assembly and diffusion bonding technologies to satisfactorily meet bookshelf, straightness and cell rotational alignment requirements. The measurements described are the RF properties of single cavities and complete accelerator section, as well as wakefields from the ASSET tests at SLAC. Finally, future improvements are also discussed.

physics.acc-ph↗

arXiv2000

Fabrication Process of Rounded Damped Detuned Structure

Following the successful design and fabrication of Damped Detuned Structures (DDS), the JLC/NLC linear collider project advanced to Rounded Damped Detuned Structures (RDDS) with curved cross section of the cavity shape for increased shunt impedance. Various advanced techniques for fabricating RDDS1 disks comparing to those for DDS were established to satisfy the dimension accuracy of +-1 micron over the entire surface made by ultra-precision turning. These disks were assembled with almost the same stacking and bonding jigs and processes as those of DDS3 assembly. In consequence, the assembly showed little disk-to-disk misalignment within 1 micron before and after the process. Though, it had 200 micron smooth bowing, which was subsequently corrected as DDS3, and flares at both ends.

hep-ex↗

arXiv2000

Meeting Tight Frequency Requirement of Rounded Damped Detuned Structure

Following successful design and fabrication of damped detuned structures, the R&D for the accelerating structures of the NLC/JLC linear collider project proceeded to studies of Rounded Damped Detuned Structure with curved cross section of the cavity shape for increased shunt impedance. The important features of the structure are the accurately tuned accelerating mode frequency and the distribution of the first dipole modes smooth and close to the design distribution. These requirements were met based on the high-accuracy diamond turning with its capability to realize the periphery tolerance of two microns. The lowest dipole mode frequencies scattered by 0.6 MHz RMS. The error in the accelerating mode frequency averaged over a structure was 0.1 MHz by applying a feed-forward method.

hep-ex↗