SearcharxivSearch

arXiv subjects

N. Salovich

Publications and source records attributed to N. Salovich.

4 recordsLinked to original sources

Nodal superconductivity in isovalently substituted SrFe$_2$(As$_{1-x}$P$_{x}$)$_2$ pnictide superconductor at the optimal doping, $x=$0.35

Temperature-dependent London penetration depth, $λ(T)$, was measured in optimally - doped, $x=$0.35, as-grown ($T_c \approx$25 K, RRR=$ρ(300K)/ρ(T_c)$=4.5) and annealed ($T_c \approx$35 K, RRR=6.4) single crystals of SrFe$_2$(As$_{1-x}$P$_{x}$)$_2$ iron - based superconductor. Annealing increases the RRR and decreases the absolute value of the London penetration depth from $λ(0) = 300 \pm 10$ nm in as-grown sample to $λ(0) = 275 \pm 10$ nm. At low temperatures, $λ(T) \sim T$ indicating superconducting gap with line nodes. Analysis of the full - temperature range superfluid density is consistent with the line nodes, but differs from the simple single - gap $d-$wave. The observed behavior is very similar to that of BaFe$_2$(As$_{1-x}$P$_{x}$)$_2$, showing that isovalently substituted pnictides are inherently different from the charge - doped materials.

cond-mat.supr-con

A Sharp Peak of the Zero-Temperature Penetration Depth at Optimal Composition in BaFe2(As1-xPx)2

In a superconductor, the ratio of the carrier density, $n$, to their effective mass, $m^*$, is a fundamental property directly reflecting the length scale of the superfluid flow, the London penetration depth, $λ_L$. In two dimensional systems, this ratio $n/m^*$ ($\sim 1/λ_L^2$) determines the effective Fermi temperature, $T_F$. We report a sharp peak in the $x$-dependence of $λ_L$ at zero temperature in clean samples of BaFe$_2$(As$_{1-x}$P$_x$)$_2$ at the optimum composition $x = 0.30$, where the superconducting transition temperature $T_c$ reaches a maximum of 30\,K. This structure may arise from quantum fluctuations associated with a quantum critical point (QCP). The ratio of $T_c/T_F$ at $x = 0.30$ is enhanced, implying a possible crossover towards the Bose-Einstein condensate limit driven by quantum criticality.

cond-mat.supr-con

Doping evolution of the absolute value of the London penetration depth and superfluid density in single crystals of Ba(Fe$_{1-x}$Co$_x$)$_2$As$_2$

The zero temperature value of the in-plane London penetration depth, $λ_{ab}(0)$, has been measured in single crystals of Ba(Fe$_{1-x}$Co$_x$)$_2$As$_2$ as a function of the Co concentration, $x$, across both the underdoped and overdoped superconducting regions of the phase diagram. For $x\gtrsim0.047$, $λ_{ab}(0)$ has been found to have values between 120 $\pm$ 50~nm and 300 $\pm$ 50~nm. A pronounced increase in $λ_{ab}(0)$, to a value as high as 950 $\pm$ 50~nm, has been observed for $x\lesssim0.047$, corresponding to the region of the phase diagram where the itinerant antiferromagnetic and superconducting phases coexist and compete. Direct determination of the doping-dependent $λ_{ab}(0)$ has allowed us to track the evolution of the temperature-dependent superfluid density, from which we infer the development of a pronounced superconducting gap anisotropy at the edges of the superconducting dome.

cond-mat.supr-con

London penetration depth and superfluid density in single crystals of Fe(Te,Se) and Fe(Te,S) superconductors

The in-plane London penetration depth, $λ(T)$, was measured in single crystals of the iron-chalcogenide superconductors Fe$_{1.03}$(Te$_{0.63}$Se$_{0.37}$) and Fe$_{1.06}$(Te$_{0.88}$S$_{0.14}$) by using a radio-frequency tunnel diode resonator. As is also the case for the iron-pnictides, these iron-chalcogenides exhibit a nearly quadratic temperature variation of $λ(T)$ at low temperatures. The absolute value of the penetration depth in the $T \to 0$ limit was determined for Fe$_{1.03}$(Te$_{0.63}$Se$_{0.37})$ by using an Al coating technique, giving $λ(0)\approx560 \pm 20$ nm. The superfluid density $ρ_s(T)=λ^2(0)/λ^2(T)$ was fitted with a self-consistent two-gap $γ-$model. While two different gaps are needed to describe the full-range temperature variation of $ρ_s(T)$, a non-exponential behavior at low temperatures requires additional factors, such as scattering and/or significant gap anisotropy.

cond-mat.supr-con