Searcharxiv⌕ Search

arXiv subjects

Namai Chandra

Publications and source records attributed to Namai Chandra.

6 recordsLinked to original sources

AVD: A Multi-Sensor Teleoperated Wheelchair Platform with Safety-Aware Control

Electric wheelchairs predominantly rely on manual joystick interfaces, which present critical barriers to independent mobility for individuals with severe motor and visual impairments. This paper presents AVD (Autonomous Vehicle Drive), a dependable teleoperation architecture for assistive mobility that unifies perception, communication, embedded control, and remote supervision in a single low-cost platform built entirely from commercially available hardware. The central engineering contribution is a safety-oriented design framework: control authority follows a static hierarchy, a manual emergency stop and the occupant's joystick pre-empt remote commands, and the on-board sensing layer has stop-only authority. The compute design partitions primary and safety functions and specifies a heartbeat-driven safe-state transition for the fault cases considered. The sensing stack this framework depends on is characterized against measured data: per-channel acquisition latency, a 2,025-scan LiDAR degradation campaign spanning five target configurations and a control under water mist, airborne dust, and direct aperture occlusion, and attitude measurements across static inclines to 47 degrees. The lowest pooled environmental-condition mean retained 76.6% of the clear-baseline forward-sector yield, and no scan lost the sector completely. A logged vibration-induced inertial dropout occurred while LiDAR and camera logging continued, illustrating complementary channel behavior. The result is a documented prototype and an explicit validation path for a deployable wheelchair implementation.

cs.RO↗

Enhancing Robotic Perception and Adaptability through Sensor Fusion and Origami-Inspired Designs

Compact mobile robots must recover scene geometry under changing lighting and surface texture while working within tight payload and cost limits. We present a compact mobile robot that uses origami-inspired wheels for locomotion and active control of its sensing geometry. As the wheels move between terrain-adaptive configurations, the changing chassis pitch sweeps a 2D LiDAR through intermediate elevations; held wheel positions provide a chosen viewing angle. An IMU accounts for chassis attitude, and a fusion node projects LiDAR returns into the RGB-D depth stream supplied to RTAB-Map. The arrangement uses the wheel actuation already present on a sub-300 USD, sub-2 kg prototype to extend the scanner's viewing geometry. We assess depth fusion in a textureless indoor corridor and an outdoor sunlit area, with three runs per sensor configuration in each setting. Mean full-frame invalid-depth fractions fell from 21% to 11% indoors and from 48% to 18% outdoors. The prototype combines improved depth coverage with a continuously adjustable LiDAR viewpoint using the same actuation that reconfigures its wheels.

cs.RO↗

From Sky to Soil: A Morphing Aerial-Ground Robot for Seed Deployment

Aerial seed broadcasting can reach remote restoration sites, but provides limited control over seed placement within the soil. This paper presents a geometry-assisted, tri-functional morphing robot that combines aerial access, ground locomotion, and controlled-depth seed embedding in a fly-drive-plant architecture. After landing, the platform reconfigures into a four-wheeled planting configuration: an electronically coupled dual-motor drive folds the rear arms outward to form ground wheels, while a descending front tray engages the propulsion motors with a drill gear train. Reusing the propulsion motors for drilling eliminates a dedicated drill drive. The planting sequence forms a hole, dispenses a seed, and allows the vehicle to reposition on the ground or return to its flight configuration. Ground mobility supports repeated planting without requiring a separate flight between adjacent sites. A companion controller issues reconfiguration, tray, and seed-gate commands, while a dedicated autopilot handles flight control. The morphing and planting mechanisms are validated using a hardware prototype that demonstrates ground repositioning and seed embedding. This proof of concept establishes a hardware basis for aerial-ground seed embedding through coordinated reconfiguration and actuator reuse.

cs.RO↗

ActionGround: Training-Free Runtime Refinement of Frozen VLA Policies

Vision-Language-Action (VLA) models map visual observations and language instructions directly to robot actions, but they do not explicitly represent the phase structure of manipulation tasks or the rigid-body dynamics governing execution. We present ActionGround, a neuro-symbolic, training-free runtime layer that wraps a frozen VLA policy without retraining, fine-tuning, or weight access, adding less than 1 ms of overhead per control step. A symbolic phase-aware finite-state machine identifies the manipulation phase (approach, grasp, transport, or place) and applies a phase-specific rule-based correction. In parallel, an always-on, inertia-weighted Euler-Lagrange term incorporates the robot's equations of motion into each control step, while its dynamics residual is logged as a consistency diagnostic rather than used as a gate. We evaluate ActionGround across OpenVLA, OpenVLA-OFT, Force-VLA, and Generalist-VLA on ten LIBERO-Spatial pick-and-place tasks using a 7-DoF Franka Panda. With fixed parameters across tasks and backbones, ActionGround improves success rate by up to 6 percentage points and stability by up to 19.3 percentage points, while improving trajectory efficiency by up to 15%. In a separate Robosuite noise sweep, ActionGround provides approximately a 10x improvement in trajectory-jerk robustness under injected action noise. In a matched-seed Robosuite simulation companion to a real Agilex Piper trial, simulated baseline success increases from 35% to 95%. The physical-hardware experiment is presented as a qualitative deployment demonstration; quantitative per-trial success on the real arm is left for future work. Our evaluation is limited to rigid-object pick-and-place manipulation.

cs.RO↗

PhysVLA: Towards Physically-Grounded VLA for Embodied Robotic Manipulation

Vision-Language-Action (VLA) models excel at mapping visual inputs and natural language instructions directly to robotic control policies. However, because they are trained primarily to fit behavioural demonstration data, they do not explicitly enforce fundamental physical principles such as rigid-body dynamics or contact constraints. This exposes a critical physics gap: standard temporal smoothing applied on top of single-step or chunked VLAs trades trajectory quality for added failures that short-term memory cannot resolve. To bridge this gap, we introduce PhysVLA (Physics-VLA), a plug-and-play, inference-time framework designed to wrap any frozen VLA backbone without retraining, fine-tuning, or weight access, with less than 1 ms of overhead per control step. PhysVLA intercepts the predicted control action, captures only the simulator or system state, and applies a dual-layered correction: (i) a phase-aware finite-state machine that structures discrete task segments (approach, grasp, transport, and place), and (ii) a selective Euler-Lagrange gate that activates only when a dynamics oracle detects kinodynamic inconsistency. Evaluated across OpenVLA, OpenVLA-OFT, Force-VLA, and Generalist-VLA on LIBERO-Spatial with a 7-DoF Franka Panda, the framework delivers absolute success rate increases of up to 17% and stability increases of up to 19% with no per-task regressions, improves trajectory efficiency by up to 15% across all four backbones, and shows up to a 10x improvement in trajectory jerk robustness on a Robosuite Lift cross-simulator sweep. We further validate the framework on a real Agilex Piper arm with a pick-and-place task, confirming that PhysVLA transfers to physical hardware without retraining, with success-rate improvements of up to 50%, establishing physical awareness as a composable, backbone-agnostic runtime module.

cs.RO↗

Physics-Informed Policy Optimization via Analytic Dynamics Regularization

Reinforcement learning (RL) has achieved strong performance in robotic control; however, state-of-the-art policy learning methods, such as actor-critic methods, still suffer from high sample complexity and often produce physically inconsistent actions. This limitation stems from neural policies implicitly rediscovering complex physics from data alone, despite accurate dynamics models being readily available in simulators. In this paper, we introduce a novel physics-informed RL framework, called PIPER, that seamlessly integrates physical constraints directly into neural policy optimization with analytical soft physics constraints. At the core of our method is the integration of a differentiable Lagrangian residual as a regularization term within the actor's objective. This residual, extracted from a robot's simulator description, subtly biases policy updates towards dynamically consistent solutions. Crucially, this physics integration is realized through an additional loss term during policy optimization, requiring no alterations to existing simulators or core RL algorithms. Extensive experiments demonstrate that our method significantly improves learning efficiency, stability, and control accuracy, establishing a new paradigm for efficient and physically consistent robotic control.

cs.RO↗