arXiv subjects

Nathan R. Newbury

Publications and source records attributed to Nathan R. Newbury.

26 records · Page 2Linked to original sources

arXiv2017

Self-referenced frequency combs using high-efficiency silicon-nitride waveguides

We utilize silicon-nitride waveguides to self-reference a telecom-wavelength fiber frequency comb through supercontinuum generation, using 11.3 mW of optical power incident on the chip. This is approximately ten times lower than conventional approaches using nonlinear fibers and is enabled by low-loss (<2 dB) input coupling and the high nonlinearity of silicon nitride, which can provide two octaves of spectral broadening with incident energies of only 110 pJ. Following supercontinuum generation, self-referencing is accomplished by mixing 780-nm dispersive-wave light with the frequency-doubled output of the fiber laser. In addition, at higher optical powers, we demonstrate f-to-3f self-referencing directly from the waveguide output by the interference of simultaneous supercontinuum and third harmonic generation, without the use of an external doubling crystal or interferometer. These hybrid comb systems combine the performance of fiber-laser frequency combs with the high nonlinearity and compactness of photonic waveguides, and should lead to low-cost, fully stabilized frequency combs for portable and space-borne applications.

physics.optics↗

arXiv2016

Accurate frequency referencing for fieldable dual-comb spectroscopy

A fieldable dual-comb spectrometer is described based on a "bootstrapped" frequency referencing scheme in which short-term optical phase coherence between combs is attained by referencing each to a free-running diode laser, whilst high frequency resolution and long-term accuracy is derived from a stable quartz oscillator. This fieldable dual-comb spectrometer was used to measure spectra with full comb-tooth resolution spanning from 140 THz (2.14 um, 4670 cm^-1) to 184 THz (1.63 um, 6140 cm^-1) in the near infrared with a frequency sampling of 200 MHz (0.0067 cm^-1), ~ 120 kHz frequency resolution, and ~ 1 MHz frequency accuracy. High resolution spectra of water and carbon dioxide transitions at 1.77 um, 1.96 um and 2.06 um show that the molecular transmission acquired with this fieldable system did not deviate from those measured with a laboratory-based system (referenced to a maser and cavity-stabilized laser) to within 5.6x10^-4. Additionally, the fieldable system optimized for carbon dioxide quantification at 1.60 um, demonstrated a sensitivity of 2.8 ppm-km at 1 s integration time, improving to 0.10 ppm-km at 13 minutes of integration time.

physics.ins-det↗

arXiv2016

A versatile, inexpensive integrated photonics platform

We present an approach to fabrication and packaging of integrated photonic devices that utilizes waveguide and detector layers deposited at near-ambient temperature. All lithography is performed with a 365 nm i-line stepper, facilitating low cost and high scalability. We have shown low-loss SiN waveguides, high-$Q$ ring resonators, critically coupled ring resonators, 50/50 beam splitters, Mach-Zehnder interferometers (MZIs) and a process-agnostic fiber packaging scheme. We have further explored the utility of this process for applications in nonlinear optics and quantum photonics. We demonstrate spectral tailoring and octave-spanning supercontinuum generation as well as the integration of superconducting nanowire single photon detectors with MZIs and channel-dropping filters. The packaging approach is suitable for operation up to 160 \degree C as well as below 1 K. The process is well suited for augmentation of existing foundry capabilities or as a stand-alone process.

physics.optics↗

arXiv2015

Synchronization of Distant Optical Clocks at the Femtosecond Level

The use of optical clocks/oscillators in future ultra-precise navigation, gravitational sensing, coherent arrays, and relativity experiments will require time comparison and synchronization over terrestrial or satellite free-space links. Here we demonstrate full unambiguous synchronization of two optical timescales across a free-space link. The time deviation between synchronized timescales is below 1 fs over durations from 0.1 s to 6500 s, despite atmospheric turbulence and kilometer-scale path length variations. Over several days, the time wander is 40 fs peak-to-peak. Our approach relies on the two-way reciprocity of a single-spatial-mode optical link, valid to below 225 attoseconds across a turbulent 4-km path. This femtosecond level of time-frequency transfer should enable optical networks using state-of-the-art optical clocks/oscillators.

physics.optics↗

arXiv2014

Frequency Comb-Based Remote Sensing of Greenhouse Gases over Kilometer Air Paths

We demonstrate coherent dual frequency-comb spectroscopy for detecting variations in greenhouse gases. High signal-to-noise spectra are acquired spanning 5990 to 6260 cm^-1 (1600 to 1670 nm) covering ~700 absorption features from CO2, CH4, H2O, HDO, and 13CO2, across a 2-km open-air path. The transmission of each frequency comb tooth is resolved, leading to spectra with <1 kHz frequency accuracy, no instrument lineshape, and a 0.0033-cm^-1 point spacing. The fitted path-averaged concentrations and temperature yield dry-air mole fractions. These are compared with a point sensor under well-mixed conditions to evaluate current absorption models for real atmospheres. In heterogeneous conditions, time-resolved data demonstrate tracking of strong variations in mole fractions. A precision of <1 ppm for CO2 and <3 ppb for CH4 is achieved in 5 minutes in this initial demonstration. Future portable systems could support regional emissions monitoring and validation of the spectral databases critical to global satellite-based trace gas monitoring.

physics.optics↗

arXiv2013

Operation of an optically coherent frequency comb outside the metrology lab

We demonstrate a self-referenced fiber frequency comb that can operate outside the well-controlled optical laboratory. The frequency comb has residual optical linewidths of < 1 Hz, sub-radian residual optical phase noise, and residual pulse-to-pulse timing jitter of 2.4 - 5 fs, when locked to an optical reference. This fully phase-locked frequency comb has been successfully operated in a moving vehicle with 0.5 g peak accelerations and on a shaker table with a sustained 0.5 g rms integrated acceleration, while retaining its optical coherence and 5-fs-level timing jitter. This frequency comb should enable metrological measurements outside the laboratory with the precision and accuracy that are the hallmarks of comb-based systems. Work of the U.S. government, not subject to copyright

physics.optics↗

arXiv2012

Optical two-way time and frequency transfer over free space

The transfer of high-quality time-frequency signals between remote locations underpins a broad range of applications including precision navigation and timing, the new field of clock-based geodesy, long-baseline interferometry, coherent radar arrays, tests of general relativity and fundamental constants, and the future redefinition of the second [1-7]. However, present microwave-based time-frequency transfer [8-10] is inadequate for state-of-the-art optical clocks and oscillators [1,11-15] that have femtosecond-level timing jitter and accuracies below 1E-17; as such, commensurate optically-based transfer methods are needed. While fiber-based optical links have proven suitable [16,17], they are limited to comparisons between fixed sites connected by a specialized bidirectional fiber link. With the exception of tests of the fundamental constants, most applications instead require more flexible connections between remote and possibly portable optical clocks and oscillators. Here we demonstrate optical time-frequency transfer over free-space via a two-way exchange between coherent frequency combs, each phase-locked to the local optical clock or oscillator. We achieve femtosecond-scale timing deviation, a residual instability below 1E-18 at 1000 s and systematic offsets below 4E-19, despite frequent signal fading due to atmospheric turbulence or obstructions across the 2-km link. This free-space transfer would already enable terrestrial links to support clock-based geodesy. If combined with satellite-based free-space optical communications, it provides a path toward global-scale geodesy, high-accuracy time-frequency distribution, satellite-based relativity experiments, and "optical GPS" for precision navigation.

physics.optics↗

arXiv2007

Coherent, multi-heterodyne spectroscopy using stabilized optical frequency combs

The broadband, coherent nature of narrow-linewidth fiber frequency combs is exploited to measure the full complex spectrum of a molecular gas through multi-heterodyne spectroscopy. We measure the absorption and phase shift experienced by each of 155,000 individual frequency comb lines, spaced by 100 MHz and spanning from 1495 nm to 1620 nm, after passing through a hydrogen cyanide gas. The measured phase spectrum agrees with Kramers-Kronig transformation of the absorption spectrum. This technique can provide a full complex spectrum rapidly, over wide bandwidths, and with hertz-level accuracy.

physics.optics↗