arXiv subjects

Neng Ye

Publications and source records attributed to Neng Ye.

10 recordsLinked to original sources

arXiv2026

An Optical Pathway to Movable Rydberg Atomic Quantum Receivers

This paper develops an optically movable Rydberg atomic quantum receiver (RAQR), in which the probe and coupling beams are steered within each vapor cell to dynamically reconfigure the effective radio-frequency (RF) sensing position without mechanical actuation. A closed-form equivalent baseband model is derived by separating the atomic transduction coefficient, optical steering phase, and cell-center array response into distinct factors and the accuracy of the resulting model is validated against numerical solutions of the Lindblad master equation. Based on the derived model, we reveal two complementary channel-shaping mechanisms, including intrinsic beam-pattern shaping through RF-to-optical transduction and per-cell phase control enabled by optical displacement. To further exploit these capabilities, a non-convex sum-rate maximization problem is formulated over the optical positions and local oscillator design and solved via an alternating optimization framework with analytical gradients. Simulation results validate the derived model and demonstrate substantial performance gains enabled by optical movability, highlighting its potential as a programmable receiver architecture for future wireless networks.

eess.AS↗

arXiv2026

Unified Analytical Model for Atomic Receivers Under Typical Quantum Interference Paths

Atomic receivers, which leverage the quantum interference termed electromagnetically induced transparency (EIT) for radio-frequency (RF) to optical signal transduction, offer a revolutionary paradigm for next-generation wireless communications. However, current information-theoretic characterizations are predominantly restricted to the {\Xi}-type of EIT path and rely heavily on the weak-probe approximation, which fails to predict the behavior of the atomic receivers under high signal-to-noise ratio regimes. In this paper, we establish a unified analytical model for atomic receivers, and apply this model to three typical quantum interference paths, i.e., V -type, {\Lambda}-type, and {\Xi}-type configurations. To provide a universal characterization, we propose the quantum coherence transfer coefficient (QCTC) to model the equivalent channel response induced by atomic receivers, using a steady-state perturbation framework built on the three-level EIT solution. The closed-form expressions of equivalent channel gains are then derived for three paths. Our results provide an analytical foundation for future capacity analysis and waveform optimization in atomic radio communication.

eess.SP↗

arXiv2026

Doppler-Resilient Rydberg Atomic Receiver for High-Dynamic Communication Networks via Adaptive Local Oscillator Tracking

Rydberg atomic receiver has emerged as promising candidate for next-generation wireless communication, due to the exceptional sensitivity and ability to overcome the physical limitations of traditional radio frequency antennas. Utilizing the resonant response of atomic energy levels for signal detection, Rydberg atomic receiver is inherently confined to a narrow instantaneous bandwidth. However, in high-mobility scenarios such as satellite communications, the severe Doppler effect induces carrier frequency offsets, which drive the signal beyond the instantaneous bandwidth and result in severe distortion. In this paper, we propose an adaptive local oscillator (LO) tracking Rydberg atomic receiver architecture designed to lock high-dynamic signals within the effective atomic response bandwidth. By employing a cross-product automatic frequency control (CPAFC) algorithm, the system dynamically estimates the instantaneous frequency offset, generates a corresponding error control signal, and adjusts the LO frequency through a feedback loop. Consequently, the intermediate frequency signal can always be locked close to the center of the atomic response bandwidth regardless of dynamics. Simulation results show that the proposed architecture significantly outperforms existing Rydberg atomic receiver, effectively alleviating performance degradation in high-dynamic environments.

eess.SP↗

arXiv2026

Rydberg Atomic Quantum Radio: A Comprehensive Survey From Wireless Communication Perspective

Next-generation space-air-ground-sea integrated networks (SAGSIN) impose unprecedented demands on advanced radio frequency (RF) receivers for full-spectrum agility, ultra-high sensitivity, and anti-jamming resilience, pushing conventional electronic receivers to their physical limits. To address these challenges, the Rydberg atomic quantum (RAQ) radio has emerged as a promising quantum-enabled receiver paradigm that directly maps electromagnetic fields onto atomic quantum states, offering an alternative to alleviate bottlenecks of conventional RF front ends. To provide a clear research roadmap, this survey presents a comprehensive review of RAQ radios by bridging atomic physics and wireless communications. Specifically, we first introduce the underlying quantum mechanisms, representative architectures, and atomic response models of RAQ radio. On this basis, state-of-the-art techniques for enhancing sensitivity, instantaneous bandwidth, and operating frequency are systematically reviewed, with particular emphasis on the inherent trade-offs among these key metrics. To connect quantum response with communication theory, we further analyze equivalent channel modeling frameworks for characterizing systematic performance limits. From the wireless communication perspective, some RAQ-enabled advanced technologies including cognitive, interference-resilient, low-frequency and multiple-input multiple-output (MIMO) communications are reviewed, alongside emerging deployment scenarios such as satellite networks, integrated sensing and communications, and reconfigurable intelligent surface-assisted systems. Finally, we identify open challenges and provide potential future directions of RAQ radio to inspire the further exploration.

eess.SP↗

arXiv2026

Signal-Dependent Shot Noise Modeling of Rydberg Atomic Quantum Receivers: A Design Perspective

In this paper, we develop a communication-oriented complex baseband equivalent model for superheterodyne Rydberg atomic quantum receivers (RAQRs). The model explicitly captures photodetection-induced signal-dependent shot noise and its coupling with the optical operating point. By leveraging an atomic superheterodyne architecture and a strong local oscillator, we construct a complex baseband representation for both the received signal and the signal-dependent shot noise under both direct incoherent optical detection and balanced coherent optical detection. The derived model reveals that the optical operating point jointly determines the normalized effective receive gain and the equivalent noise background, thereby establishing a traceable gain-noise tradeoff governed by system design. More importantly, the proposed model shows that neglecting signal-dependent shot noise may lead to inaccurate operating-point design. Finally, by extending to the multiple-input-multiple-output (MIMO) case, we derive a lower bound on the achievable rate while considering the signal-dependent shot noise. Our analysis \textcolor{black}{reveals} that the non-zero asymptotic rate of RAQ-MIMO and its superiority over conventional RF-MIMO hinge on the normalized noise floor of the RAQ receive chain falling below that of RF MIMO. Simulation results validate our analysis and yield practical, closed-form design guidelines for RAQR front ends, revealing parameter regimes in which RAQ-MIMO outperforms conventional MIMO systems.

eess.SP↗

arXiv2025

From Active to Battery-Free: Rydberg Atomic Quantum Receivers for Self-Sustained SWIPT-MIMO Networks

In this paper, we proposed a hybrid simultaneous wireless information and power transfer (SWIPT)-enabled multiple-input multiple-output (MIMO) architecture, where the base station (BS) uses a conventional RF transmitter for downlink transmission and a Rydberg atomic quantum receiver (RAQR) for receiving uplink signal from Internet of Things (IoT) devices. To fully exploit this integration, we jointly design the transmission scheme and the power-splitting strategy to maximize the sum rate, which leads to a non-convex problem. To address this challenge, we first derive closed-form lower bounds on the uplink achievable rates for maximum ratio combining (MRC) and zero-forcing (ZF), as well as on the downlink rate and harvested energy for maximum ratio transmission (MRT) and ZF precoding. Building upon these bounds, we propose an iterative algorithm relying on the best monomial approximation and geometric programming (GP) to solve the non-convex problem. Finally, simulations validate the tightness of our derived lower bounds and demonstrate the superiority of the proposed algorithm over benchmark schemes. Importantly, by integrating RAQR with SWIPT-enabled MIMO, the BS can reliably detect weak uplink signals from IoT devices powered only by harvested energy, enabling battery-free communication.

eess.SP↗

arXiv2025

On Analysis of Superimposed Pilot in Multi-User Massive MIMO with Massive Connectivity

The simultaneous transmission of numerous users presents substantial challenges due to the inherent trade-off between channel estimation and information transmission in multi-user multiple-input multiple-output (MIMO) system. In this paper, we explore the use of the superimposed pilot (SP) scheme to tackle the large transmitting users, where the number of users may exceed the coherent time. SP scheme incorporates both transmitted data and noise in the channel estimation process, which is significant different from the counterpart of RP scheme. We provide an in-depth analysis of the interaction between interference caused by channel estimation errors and noise. We then derive the explicit expression for the scaling law of the mutual information lower bound (MILB) in relation to the number of users and the levels of transmitted power. Besides, the optimal power allocation between pilots and data transmission is also derived analytically. The analytical results demonstrate that the SP scheme significantly improves performance compared to traditional RP scheme in our consider case. Numerical results are also presented to validate our theoretical derivations.

cs.IT↗

arXiv2024

Processing Load Allocation of On-Board Multi-User Detection for Payload-Constrained Satellite Networks

The rapid advance of mega-constellation facilitates the booming of direct-to-satellite massive access, where multi-user detection is critical to alleviate the induced inter-user interference. While centralized implementation of on-board detection induces unaffordable complexity for a single satellite, this paper proposes to allocate the processing load among cooperative satellites for finest exploitation of distributed processing power. Observing the inherent disparities among users, we first excavate the closed-form trade-offs between achievable sum-rate and the processing load corresponding to the satellite-user matchings, which leads to a system sum-rate maximization problem under stringent payload constraints. To address the non-trivial integer matching, we develop a quadratic transformation to the original problem, and prove it an equivalent conversion. The problem is further simplified into a series of subproblems employing successive lower bound approximation which obtains polynomial-time complexity and converges within a few iterations. Numerical results show remarkably complexity reduction compared with centralized processing, as well as around 20\% sum-rate gain compared with other allocation methods.

cs.IT↗

arXiv2023

Few-Shot Recognition and Classification Framework for Jamming Signal: A CGAN-Based Fusion CNN Approach

Subject to intricate environmental variables, the precise classification of jamming signals holds paramount significance in the effective implementation of anti-jamming strategies within communication systems. In light of this imperative, we propose an innovative fusion algorithm based on conditional generative adversarial network (CGAN) and convolutional neural network (CNN), which aims to deal with the difficulty in applying deep learning (DL) algorithms due to the instantaneous nature of jamming signals in practical communication systems. Compared with previous methods, our algorithm embeds jamming category labels to constrain the range of generated signals in the frequency domain by using the CGAN model, which simultaneously captures potential label information while learning the distribution of signal data thus achieves an 8% improvement in accuracy even when working with a few-sample dataset. Real-world satellite communication scenarios are simulated by adopting hardware platform, and we validate our algorithm by using the resulting time-domain waveform data. The experimental results indicate that our algorithm still performs extremely well, which demonstrates significant potential for practical application in real-world communication scenarios.

eess.SP↗

arXiv2017

Achieve Sustainable Ultra-Dense Heterogeneous Networks for 5G

Due to the exponentially increased demands of mobile data traffic, e.g., a 1000-fold increase in traffic demand from 4G to 5G, network densification is considered as a key mechanism in the evolution of cellular networks, and ultra-dense heterogeneous network (UDHN) is a promising technique to meet the requirements of explosive data traffic in 5G networks. In the UDHN, base station is brought closer and closer to users through densely deploying small cells, which would result in extremely high spectral efficiency and energy efficiency. In this article, we first present a potential network architecture for the UDHN, and then propose a generalized orthogonal/non-orthogonal random access scheme to improve the network efficiency while reducing the signaling overhead. Simulation results demonstrate the effectiveness of the proposed scheme. Finally, we present some of the key challenges of the UDHN.

cs.NI↗