SearcharxivSearch

arXiv subjects

Nengwen Wang

Publications and source records attributed to Nengwen Wang.

3 recordsLinked to original sources

Polarized electron-beam acceleration driven by vortex laser pulses

We propose a new approach based on an all-optical set-up for generating relativistic polarized electron beams via vortex Laguerre-Gaussian (LG) laser-driven wakefield acceleration. Using a pre-polarized gas target, we find that the topology of the vortex wakefield resolves the depolarization issue of the injected electrons. In full three-dimensional particle-in-cell simulations, incorporating the spin dynamics via the Thomas-Bargmann Michel Telegdi equation, the LG laser preserves the electron spin polarization by more than 80% at high beam charge and flux. The method releases the limit on beam flux for polarized electron acceleration and promises more than an order of magnitude boost in peak flux, as compared to Gaussian beams. These results suggest a promising table-top method to produce energetic polarized electron beams.

physics.plasm-ph

Second harmonic generation in a high-Q lithium niobate microresonator fabricated by femtosecond laser micromachining

We report on fabrication of high Q lithium niobate (LN) whispering-gallery-mode (WGM) microresonators suspended on silica pedestals by femtosecond laser microfabrication. The micrometer-scale (diameter ~82 μm) LN resonator possesses a Q factor of 2.5x10^5 around 1550 nm wavelength range. Moreover, second harmonic generation with a continuous-wave tunable single-longitudinal-mode pump laser in the on-chip LN microresonator is demonstrated in the on-chip LN microresonator. A fiber taper is employed to couple the pump laser into the microresonator, showing a normalized conversion efficiency of 1.35x10^-5/mW.

physics.optics

Fabrication of three-dimensional microdisk resonators in calcium fluoride by femtosecond laser micromachining

We report on fabrication of on-chip calcium fluoride (CaF2) microdisk resonators using water-assisted femtosecond laser micromachining. Focused ion beam (FIB) milling is used to create ultra-smooth sidewalls. The quality (Q)-factors of the fabricated microresonators are measured to be 4.2x10^4 at wavelengths near 1550 nm. The Q factor is mainly limited by the scattering from the bottom surface of the disk whose roughness remains high due to the femtosecond laser micromachining process. This technique facilitates formation of on-chip microresonators on various kinds of bulk crystalline materials, which can benefit a wide range of applications such as nonlinear optics, quantum optics, and chip-level integration of photonic devices.

physics.optics