arXiv subjects

Nicholas E. Fuhr

Publications and source records attributed to Nicholas E. Fuhr.

3 recordsLinked to original sources

arXiv2026

Reconfigurable Superconducting Quantum Circuits Enabled by Micro-Scale Liquid-Metal Interconnects

Modular architectures are a promising route toward scalable superconducting quantum processors, but finite fabrication yield and the lack of high quality temporary interconnects impose fundamental limitations on system size. Here, we demonstrate chip-scale liquid-metal interconnects that show promise for plug-and-play superconducting quantum circuits by enabling non-destructive module replacement while maintaining high microwave performance. Using gallium-based liquid metals, we realize high-quality inter-module signal and ground interconnects, comparable in performance to conventional coplanar waveguide resonators. We illustrate consistent device characteristics across three thermal cycles between room temperature and 15 mK, as well as the ability to reform superconducting connections following module replacement. A width-dependent resonance frequency shift reveals a significant kinetic inductance fraction, which we attribute to the presence of $β$-phase tantalum as confirmed by X-ray characterization. Finally, we investigate power-dependent loss mechanisms and observe high-power dissipative nonlinearities qualitatively consistent with a readout-power heating model. These results establish liquid metals as viable chip-scale interconnects for reconfigurable, modular superconducting quantum systems.

quant-ph↗

arXiv2022

Tuning the pH Response of Monolayer Hexagonal Boron Nitride/Graphene Field-Effect Transistors

The chemical activity of ionized hydrogen describes the potency of protons in solution and is used to define the pH with wide-ranging applications in biological and materials sciences. Measuring pH with graphene field-effect transistors (FETs) has been described in the past but has yet to be characterized with a monolayer hexagonal boron nitride (hBN) capping layer. hBN capping is hypothesized to lower the chemical affinity of protons to oxidized defects in the graphene crystal and lower the standard deviation of pH measurement via screening charge density. First, the electronic properties of commercial, monolayer graphene and monolayer hBN/graphene, both on four-inch 90 nm SiO2/p-type Si, were contrasted as a function of solutal pH in 10 mM phosphate buffered solution. The two-dimensional (2D) FETs were fabricated with photoresistless metallization followed by microcentrifuge tube-masking and reactive ion etching to define a quasi-pure 2D sensing mesa for pH sensing. Thereafter, the devices were exposed to phosphate buffer of varying pH and the resistance and liquid-transfer characteristics measured. The hBN/graphene/SiO2 FETs had higher linearity, and both lower standard deviation and range of Dirac voltage shifting than monolayer graphene/SiO2. Then, before microcentrifuge tube-masking, freshly metallized devices were coated with 9 nm of Al2O3 by electron beam deposition. The Al2O3/graphene/SiO2 and Al2O3/hBN/graphene/SiO2 devices showed an altered response to the pH of the phosphate buffered solutions before and after basic etching of the Al2O3 with NaOH (pH = 12). This prompted studying the pH-dependencies of the 2D devices as a function of the thickness of Al2O3 via atomic layer deposition. These results show that modifying the surface of monolayer graphene with nanoscale dielectrics enables tuning of the pH-dependent electronic properties of graphene pH sensors.

physics.app-ph↗

arXiv2022

Coronavirus RNA Sensor Using Single-Stranded DNA Bonded to Sub-Percolated Gold Films on Monolayer Graphene Field-Effect Transistors

Electrical detection of messenger ribonucleic acid (mRNA) is a promising approach to enhancing transcriptomics and disease diagnostics because of its sensitivity, rapidity, and modularity. Reported here is a fast SARS-CoV-2 mRNA biosensor (<1 minute) with a limit of detection of 1 aM, and dynamic range of 4 orders of magnitude and a linear sensitivity of 22 mV per molar decade. These figures of merit were obtained on photoresistlessly patterned monolayer graphene field-effect transistors (FETs) derived from commercial four-inch graphene on 90 nm of silicon dioxide on p-type silicon. Then, to facilitate mRNA hybridization, graphene sensing mesa were coated with an ultrathin sub-percolation threshold gold film for bonding 3'-thiolated single-stranded deoxyribonucleic acid (ssDNA) probes complementary to SARS-CoV-2 nucleocapsid phosphoprotein (N) gene. Sub-percolated gold was used to minimize the distance between the graphene material and surface hybridization events. The liquid-transfer characteristics of the graphene FETs repeatedly shows correlation between the Dirac voltage and the copy number of polynucleotide. Ultrathin percolated gold films on graphene FETs facilitate two-dimensional electron gas (2DEG) mRNA biosensors for transcriptomic profiling.

q-bio.BM↗