Temperature Flips the Sign of the Hydrogen Response in Nanogranular Palladium Networks
In nanogranular palladium networks, hydrogen uptake has two opposing effects on electrical resistance. Absorbed hydrogen scatters electrons within the particles, raising their resistance, while particle expansion narrows the gaps between them and lowers the junction resistance. Such networks are widely studied as resistive hydrogen sensors, and the sign of their net response is usually treated as a fixed property of the architecture. In networks grown by atomic layer deposition on macroporous silicon, we show that changing the operating temperature can reverse this sign at a fixed hydrogen concentration. A thermodynamic model indicates that scattering contributes less as temperature rises, allowing sub-angstroem changes in gap width to dominate. Where the two effects cancel, the network absorbs hydrogen yet gives the same reading as in hydrogen-free gas, so a leak could escape detection. Between 25 and 40 degrees Celsius, this cancellation point is predicted to rise over tenfold, crossing reported leak-alarm setpoints. At 55 degrees Celsius, the measured response stays negative but passes through a minimum, so a concentration above a setpoint can mimic one below it. Annealing at 200 degrees Celsius alters the calibration and turns the room-temperature response negative at the lowest concentration tested. Quantitative sensing therefore requires a defined thermal pretreatment and an operating temperature giving distinct signals across the intended concentration range. Response polarity becomes an operating parameter rather than a fixed property. More broadly, any nanoparticle network whose particles deform on sorption may show the same temperature-dependent competition between transport within and between particles, with implications for sensors and switches beyond palladium-hydrogen.