arXiv subjects

Nicolas Zapata

Publications and source records attributed to Nicolas Zapata.

10 recordsLinked to original sources

arXiv2026

Probing the memory of a superconducting qubit environment

Achieving fault tolerance with superconducting quantum processors requires qubits to operate within the regime of threshold theorems based on the Born-Markov approximation. This approximation, which models dissipation as constant energy decay into a memoryless environment, breaks down when qubits couple to long-lived two-level systems (TLSs) that become polarized during operation and retain memory of past qubit states. Here, we show that non-Poissonian quantum jump traces carry the information required to distinguish long-lived TLSs from the standard Markovian bath. By fitting the Solomon equations to measured quantum jumps dynamics arising naturally due to thermal fluctuations, we can disentangle the coupling of the qubit to the two environments. Sweeping the qubit frequency reveals distinct peaks, each associated with a TLS that outlives the qubit, providing a handle to understand their microscopic origin.

quant-ph↗

arXiv2025

Double-Pumped Kerr Parametric Amplifier Beyond the Gain-Bandwidth Limit

Superconducting standing$-$wave parametric amplifiers are crucial for the readout of microwave quantum devices. Despite significant improvements in recent years, the need to operate near an instability point imposes a fundamental constraint: the instantaneous bandwidth decreases with increasing amplifier gain. Here we show that it is possible to obtain parametric amplification without instability by using two simultaneous drives that activate phase-preserving gain and frequency conversion. Realized in a granular aluminum dimer with Kerr nonlinearity, our method demonstrates a sixfold bandwidth increase at 20 dB gain, surpasses the conventional gain$-$bandwidth scaling up to 25 dB, and remains near the quantum limit.

quant-ph↗

arXiv2025

Liquid metal printing for superconducting circuits

Superconducting circuits are a promising platform for implementing fault-tolerant quantum computers, quantum limited amplifiers, ultra-low power superconducting electronics, and sensors with ultimate sensitivity. Typically, circuit fabrication is realized by standard nanolithography, generally associated with a high level of control over defects and contaminants. Additive approaches have not been used so far since they are expected to be inferior in terms of superconducting properties or quantum coherence. This work shows that liquid-metal based micro-pipette printing is suited for fabricating superconducting lumped-element resonators with high internal quality factors. The applicability of our technique for low-loss superconducting device fabrication and the possibility to locally add metal structures, without affecting any preexisting circuit elements, is a further advantage. Our results open up new avenues in the hardware implementation of scaled-up superconducting quantum computers.

quant-ph↗

arXiv2025

Quantum Coherence in Superconducting Vortex States

Abrikosov vortices, where the superconducting gap is completely suppressed in the core, are dissipative, semi-classical entities that impact applications from high-current-density wires to superconducting quantum devices. In contrast, we present evidence that vortices trapped in granular superconducting films can behave as two-level systems, exhibiting microsecond-range quantum coherence and energy relaxation times that reach fractions of a millisecond. These findings support recent theoretical modeling of superconductors with granularity on the scale of the coherence length as tunnel junction networks, resulting in gapped vortices. Using the tools of circuit quantum electrodynamics, we perform coherent manipulation and quantum non-demolition readout of vortex states in granular aluminum microwave resonators, heralding new directions for quantum information processing, materials characterization, and sensing.

quant-ph↗

arXiv2025

On-chip stencil lithography for superconducting qubits

Improvements in circuit design and more recently in materials and surface cleaning have contributed to a rapid development of coherent superconducting qubits. However, organic resists commonly used for shadow evaporation of Josephson junctions (JJs) pose limitations due to residual contamination, poor thermal stability and compatibility under typical surface-cleaning conditions. To provide an alternative, we developed an inorganic SiO$_2$/Si$_3$N$_4$ on-chip stencil lithography mask for JJ fabrication. The stencil mask is resilient to aggressive cleaning agents and it withstands high temperatures up to 1200{\deg}C, thereby opening new avenues for JJ material exploration and interface optimization. To validate the concept, we performed shadow evaporation of Al-based transmon qubits followed by stencil mask lift-off using vapor hydrofluoric acid, which selectively etches SiO$_2$. We demonstrate average $T_1 \approx 75 \pm 11 \mu$s over a 200 MHz frequency range in multiple cool-downs for one device, and $T_1 \approx 44\pm 8 \mu$s for a second device. These results confirm the compatibility of stencil lithography with state-of-the-art superconducting quantum devices and motivate further investigations into materials engineering, film deposition and surface cleaning techniques.

quant-ph↗

arXiv2025

High Impedance Granular Aluminum Ring Resonators

Superconducting inductors with impedance surpassing the resistance quantum, i.e., superinductors, are important for quantum technologies because they enable the development of protected qubits, enhance coupling to systems with small electric dipole moments, and facilitate the study of phase-slip physics. We demonstrate superinductors with densely packed meandered traces of granular aluminum (grAl) with inductances up to $4\,\mu\mathrm{H}$, achieving impedances exceeding $100\,\mathrm{k}\Omega$ in the $4-8\,\mathrm{GHz}$ range. Ring resonators made with grAl meandered superinductors exhibit quality factors on the order of $10^5$ in the single-photon regime and low non-linearity on the order of tens of $\mathrm{Hz}$. Depending on the grAl resistivity, at $10\,\mathrm{Hz}$, we measure frequency noise spectral densities in the range of $10^2$ to $10^3\,\mathrm{Hz}/\sqrt{\mathrm{Hz}}$. In some devices, in the single-photon regime, we observe a positive Kerr coefficient of unknown origin. Using more complex fabrication, the devices could be released from the substrate, either freestanding or suspended on a membrane, thereby further improving their impedance by a factor of three.

quant-ph↗

arXiv2025

Simultaneous sweet-spot locking of gradiometric fluxonium qubits

Efforts to scale up superconducting processors that employ flux-qubits face numerous challenges, among which is the crosstalk created by neighboring flux lines, which are necessary to bias the qubits at the zero-field and $\Phi_0/2$ sweet spots. A solution to this problem is to use symmetric gradiometric loops, which incorporate a flux locking mechanism that, once a fluxon is trapped during cooldown, holds the device at the sweet spot and limits the need for active biasing. We demonstrate this technique by simultaneously locking multiple gradiometric fluxonium qubits in which an aluminum loop retains the trapped fluxon indefinitely. By compensating the inductive asymmetry between the two loops of the design, we are able to lock the effective flux-bias within $\Phi_{eff} = -3 \times 10^{-4} \Phi_0$ from the target, corresponding to only 15 % degradation in $T_{2,E}$ when operated in zero external field. The design strategy demonstrated here reduces integration complexity for flux qubits by minimizing cross-talk and potentially eliminating the need for local flux bias.

quant-ph↗

arXiv2025

Low crosstalk modular flip-chip architecture for coupled superconducting qubits

We present a flip-chip architecture for an array of coupled superconducting qubits, in which circuit components reside inside individual microwave enclosures. In contrast to other flip-chip approaches, the qubit chips in our architecture are electrically floating, which guarantees a simple, fully modular assembly of capacitively coupled circuit components such as qubit, control, and coupling structures, as well as reduced crosstalk between the components. We validate the concept with a chain of three nearest neighbor coupled generalized flux qubits in which the center qubit acts as a frequency-tunable coupler. Using this coupler, we demonstrate a transverse coupling on/off ratio $\approx$ 50, zz-crosstalk $\approx$ 0.7 kHz between resonant qubits and isolation between the qubit enclosures > 60 dB.

quant-ph↗

arXiv2024

Pure kinetic inductance coupling for cQED with flux qubits

We demonstrate a qubit-readout architecture where the dispersive coupling is entirely mediated by a kinetic inductance. This allows us to engineer the dispersive shift of the readout resonator independent of the qubit and resonator capacitances. We validate the pure kinetic coupling concept and demonstrate various generalized flux qubit regimes from plasmon to fluxon, with dispersive shifts ranging from 60 kHz to 2 MHz at the half-flux quantum sweet spot. We achieve readout performances comparable to conventional architectures with quantum state preparation fidelities of 99.7 % and 92.7 % for the ground and excited states, respectively, and below 0.1 % leakage to non-computational states.

quant-ph↗

arXiv2024

Granular Aluminum Parametric Amplifier for Low-Noise Measurements in Tesla Fields

Josephson junction parametric amplifiers have become essential tools for microwave quantum circuit readout with minimal added noise. Even after improving at an impressive rate in the last decade, they remain vulnerable to magnetic field, which limits their use in many applications such as spin qubits, Andreev and molecular magnet devices, dark matter searches, etc. Kinetic inductance materials, such as granular aluminum (grAl), offer an alternative source of non-linearity with innate magnetic field resilience. We present a non-degenerate amplifier made of two coupled grAl resonators resilient to in-plane magnetic field up to 1 T. It offers 20 dB of gain close to the quantum limit of added noise, with a gain-bandwidth product of 28 MHz and -110 dBm input saturation power.

quant-ph↗