arXiv subjects
Publications and source records attributed to Nikolay Nikolaev.
In this paper, we apply the recently developed generalized parameter estimation-based observer design technique for state-affine systems to the practically important case of linear time-varying descriptor systems with uncertain parameters. We give simulation results of benchmark examples that illustrate the performance of the proposed adaptive observer.
In this paper an adaptive state observer and parameter identification algorithm for a linear time-varying system are developed under condition that the state matrix of the system contains unknown time-varying parameters of a known form. The state vector is observed using only output and input measurements without identification of the unknown parameters. When the state vector estimate is obtained, the identification algorithm is applied to find unknown parameters of the system.
The article investigates an algorithm for identifying an unknown constant parameter for a scalar regression model using a nonlinear operator that allows us to obtain a new regression equation (with an expanded number of unknown parameters) for which the influence of interference in measurement or disturbance will be minimal.
The article is devoted to the problem of synthesis of observers of state variables for linear stationary objects operating under conditions of noise or disturbances in the measurement channel. The paper considers a fully observable linear stationary system with known parameters. It is assumed that the state variables are not measured, and the measured output variable contains a small amplitude (in general, modulo less than one) additive noise or disturbance. It is also assumed that there is no a priori information about the disturbance or noise in the measurement channel (for example, frequency spectrum, covariance, etc.). It is well known that a large number of methods of observer synthesis have been obtained for this type of objects, including the Kalman filter, which has proven itself in practice. Under the condition of complete observability and the presence of some a priori information about the process (which is typical for the case when a disturbance in the measurement channel can be represented as white noise), approaches based on Kalman filtering demonstrate the highest quality of convergence of estimates of state variables to true values. Without taking into account the numerous results obtained using the application of the Kalman filter, an alternative idea of constructing an observer of state variables is considered in this paper. The alternative of the new approach is primarily due to the fact that there is no need to use the usual approaches based on the Luenberger observer. The paper proposes an approach based on the evaluation of unknown parameters (in this case, an unknown vector of initial conditions of the variables of the object state) of a linear regression model.
The paper proposes an adaptive observer of the state vector of a nonlinear time varying system based on measurements of the output variable. The problem is solved under the assumption that the control matrix (vector) and the nonlinear component of the equation of state of the system contain unknown constant parameters. When developing an adaptive observer, the GPEBO (generalized parameter estimation based observer) method was used, also known as a generalized observer based on parameter estimation, which was proposed in [1]. During the synthesis of the observer, a preliminary parametrization of the original nonlinear system is carried out. Then the resulting system is reduced to a linear regression model. At the next stage, unknown constant regression parameters are estimated using the least squares method with the forgetting factor [2, 3]. The article suggests the development of the result proposed by the authors in [4]. In [4], a linear non-stationary system containing unknown parameters in a control matrix (vector) was considered. This result is an extension of the result obtained in [4] for the case when the equation of state of the system contains a partially unknown nonlinearity.
In this paper we address the challenging problem of designing globally convergent estimators for the parameters of nonlinear systems containing a non-separable exponential nonlinearity. This class of terms appears in many practical applications, and none of the existing parameter estimators is able to deal with them in an efficient way. The proposed estimation procedure is illustrated with two modern applications: fuel cells and human musculoskeletal dynamics. The procedure does not assume that the parameters live in known compact sets, that the nonlinearities satisfy some Lipschitzian properties, nor rely on injection of high-gain or the use of complex, computationally demanding methodologies. Instead, we propose to design a classical on-line estimator whose dynamics is described by an ordinary differential equation given in a compact precise form. A further contribution of the paper is the proof that parameter convergence is guaranteed with the extremely weak interval excitation requirement.
Problem of an adaptive state observer design for nonlinear system with unknown time-varying parameters and under condition of delayed measurements is considered. State observation problem was raised by many researchers (see for example Sanx et al. (2019)). In this paper the results proposed in Bobtsov et al. (2021b), Bobtsov et al. (2021a), Bobtsov et al. (2022a), Bobtsov et al. (2022b) are developed. The problem is solved under assumption that the state matrix can be represented as sum of known and unknown parts. The output vector is measured with a known constant delay. An adaptive observer which reconstructs unknown state and unknown time-varying parameter is proposed.
Problem of adaptive state observer synthesis for linear time-varying (LTV) system with unknown time-varying parameter and delayed output measurements is considered. State observation problem has attracted the attention of many researchers $[4]$. In this paper the results proposed in the $[2]$, $[9]$, $[10]$ are developed. It is supposed that the state matrix can be represented as sum of known and unknown parts. Output vector is measured with known constant delay. An adaptive identification algorithm which reconstructs unknown state and unknown time varying parameter is proposed.
The article deals with the problem of synthesis of an adaptive observer of state variables of a linear time-varying SISO dynamic system. It is assumed that the control signal and the output variable are measurable. It is assumed that the state matrix of the plant contains known variables and unknown constant parameters, and the control matrix (vector) is unknown. The synthesis of the observer is based on the GPEBO method (generalized parameter based observer) proposed in $[1]$. Synthesis of adaptive provides for preliminary parametrization of the initial system and its transformation to a linear regression model with further identification of unknown parameters. To identify unknown constant parameters a classical estimation algorithm was used (the least squares method with a forgetting factor). This approach has proven itself well in cases where the known regressor is frequency poor (that is, the spectral composition of the regressor contains less than $r/2$ harmonics, where r is the number of unknown parameters) or does not satisfy the so-called undamped excitation condition. To illustrate the efficiency of the proposed method an example is presented in the article. A time-varying second-order object with four unknown parameters was considered. Parameterization of the initial dynamic model was performed and a linear static regression containing six unknowns parameters was obtained (including the vector of unknown initial conditions of system state variables). An adaptive observer was synthesized and the results of computer modeling illustrating the achievement of a given goal were presented. The main difference from the results published earlier in $[2]$ is the new assumption that the linear a time-varing system contains not only unknown parameters in the state matrix, but also the matrix (vector) for control contains unknown constant coefficients.
In this paper we are interested in the problem of adaptive synchronization of a voltage source converter with a possibly weak grid with unknown angle and frequency, but knowledge of its parameters. To guarantee a suitable synchronization with the angle of the three-phase grid voltage we design an adaptive observer for such a signal requiring measurements only at the point of common coupling. Then we propose two alternative certainty-equivalent, adaptive phase-locked loops that ensure the angle estimation error goes to zero for almost all initial conditions. Although well-known, for the sake of completeness, we also present a PI controller with feedforward action that ensures the converter currents converge to an arbitrary desired value. Relevance of the theoretical results and their robustness to variation of the grid parameters are thoroughly discussed and validated in the challenging scenario of a converter connected to a grid with low short-circuit-ratio.
In this paper we address the problem of adaptive state observation of affine-inthe-states time-varying systems with delayed measurements and unknown parameters. The development of the results proposed in the [Bobtsov et al. 2021a] and in the [Bobtsov et al. 2021c] is considered. The case with known parameters has been studied by many researchers (see [Sanz et al. 2019, Bobtsov et al. 2021b] and references therein) where, similarly to the approach adopted here, the system is treated as a linear time-varying system. We show that the parameter estimation-based observer (PEBO) design proposed in [Ortega et al. 2015, 2021] provides a very simple solution for the unknown parameter case. Moreover, when PEBO is combined with the dynamic regressor extension and mixing (DREM) estimation technique [Aranovskiy et al. 2016, Ortega et al. 2019], the estimated state converges in fixed-time with extremely weak excitation assumptions.
In this brief note we present two new parameter identifiers whose estimates converge in finite time under weak interval excitation assumptions. The main novelty is that, in contrast with other finite-convergence time (FCT) estimators, our schemes preserve the FCT property when the parameters change. The previous versions of our FCT estimators can track the parameter variations only asymptotically. Continuous-time and discrete-time versions of the new estimators are presented
In this paper we propose a new state observer design technique for nonlinear systems. It consists of an extension of the recently introduced parameter estimation-based observer, which is applicable for systems verifying a particular algebraic constraint. In contrast to the previous observer, the new one avoids the need of implementing an open loop integration that may stymie its practical application. We give two versions of this observer, one that ensures asymptotic convergence and the second one that achieves convergence in finite time. In both cases, the required excitation conditions are strictly weaker than the classical persistent of excitation assumption. It is shown that the proposed technique is applicable to the practically important examples of multimachine power systems and chemical-biological reactors.
We propose a novel decentralized mixed algebraic and dynamic state observation method for multi-machine power systems with unknown inputs and equipped with Phasor Measurement Units (PMUs). More specifically, we prove that for the third-order flux-decay model of a synchronous generator, the local PMU measurements give enough information to reconstruct algebraically the load angle and the quadrature-axis internal voltage. Due to the algebraic structure a high numerical efficiency is achieved, which makes the method applicable to large scale power systems. Also, we prove that the relative shaft speed can be globally estimated combining a classical Immersion and Invariance (I&I) observer with - the recently introduced - dynamic regressor and mixing (DREM) parameter estimator. This adaptive observer ensures global convergence under weak excitation assumptions that are verified in applications. The proposed method does not require the measurement of exogenous inputs signals such as the field voltage and the mechanical torque nor the knowledge of mechanical subsystem parameters.
In this paper we address the problem of state observation of linear time-varying systems with delayed measurements, which has attracted the attention of many researchers|see [7] and references therein. We show that, adopting the parameter estimationbased approach proposed in [3,4], we can provide a very simple solution to the problem with reduced prior knowledge.
We present the first solution to the problem of estimation of the state of multimachine power systems with lossy transmission lines. We consider the classical three-dimensional \fluxdecay" model of the power system and assume that the active and reactive power as well as the rotor angle and excitation voltage at each generator is available for measurement|a scenario that is feasible with current technology. The design of the observer relies on two recent developments proposed by the authors: a parameter estimation based approach to the problem of state estimation and the use of the dynamic regressor extension and mixing technique to estimate these parameters. Thanks to the combination of these techniques it is possible to overcome the problem of lack of persistent excitation that stymies the application of standard observer designs. Simulation results illustrate the performance of the proposed observer.
In this paper we propose a PI passivity-based controller, applicable to a large class of switched power converters, that ensures global state regulation to a desired equilibrium point. A solution to this problem was reported in \cite{HERetal} but it requires full state-feedback, which makes it practically unfeasible. To overcome this limitation we construct a state observer that is implementable with measurements that are available in practical applications. The observer reconstructs the state in finite-time, ensuring global convergence of the PI. The excitation requirement for the observer is very weak and is satisfied in normal operation of the converters. Simulation results illustrate the excellent performance of the proposed PI.
The problem of effective use of Phasor Measurement Units (PMUs) to enhance power systems awareness and security is a topic of key interest. The central question to solve is how to use this new measurements to reconstruct the state of the system. In this paper we provide the first solution to the problem of (globally convergent) state estimation of multimachine power systems equipped with PMUs and described by the fourth order flux-decay model. This work is a significant extension of our previous result, where this problem was solved for the simpler third order model, for which it is possible to recover algebraically part of the unknown state. Unfortunately, this property is lost in the more accurate fourth order model, significantly complicating the state observation task. The design of the observer relies on two recent developments proposed by the authors, a parameter estimation based approach to the problem of state estimation and the use of the Dynamic Regressor Extension and Mixing (DREM) technique to estimate these parameters. The use of DREM allows us to overcome the problem of lack of persistent excitation that stymies the application of standard parameter estimation designs. Simulation results illustrate the latter fact and show the improved performance of the proposed observer with respect to a locally stable gradient-descent based observer.