Searcharxiv⌕ Search

arXiv subjects

Nitin Jonathan Myers

Publications and source records attributed to Nitin Jonathan Myers.

24 records · Page 2Linked to original sources

Message passing-based link configuration in short range millimeter wave systems

Millimeter wave (mmWave) communication in typical wearable and data center settings is short range. As the distance between the transmitter and the receiver in short range scenarios can be comparable to the length of the antenna arrays, the common far field approximation for the channel may not be applicable. As a result, dictionaries that result in a sparse channel representation in the far field setting may not be appropriate for short distances. In this paper, we develop a novel framework to exploit the structure in short range mmWave channels. The proposed method splits the channel into several subchannels for which the far field approximation can be applied. Then, the structure within and across different subchannels is leveraged using message passing. We show how information about the antenna array geometry can be used to design message passing factors that incorporate structure across successive subchannels. Simulation results indicate that our framework can be used to achieve better beam alignment with fewer channel measurements when compared to standard compressed sensing-based techniques that do not exploit structure across subchannels.

eess.SP↗

A Geometry-aided Message Passing Method for AoA-Based Short Range MIMO Channel Estimation

Short range channels commonly arise in millimeter wave (mmWave) wearable settings, where the length of the antenna arrays can be comparable to the distance between the radios. Conventional mmWave MIMO channel estimation techniques based on the far field assumption may perform poorly in short range settings due to the large angular spread and, hence, high available rank. We propose a geometry-aided message passing algorithm that exploits structure in short range line-of-sight (LoS) channels for spatial sub-Nyquist channel estimation. Our approach parametrizes the channel using angle-of-arrivals (AoAs) that are locally defined for subarrays of an antenna array. Furthermore, it leverages the dependencies between the local AoAs using factors based on the array geometry. We show that the LoS MIMO channel can be reconstructed using the derived local AoA estimates and the known transceiver geometry. The proposed approach achieves a reasonable rate with greatly reduced pilot transmissions when compared to exhaustive beam search-based local AoA estimation.

eess.SP↗

Swift-Link: A compressive beam alignment algorithm for practical mmWave radios

Next generation wireless networks will exploit the large amount of spectrum available at millimeter wave (mmWave) frequencies. Design of mmWave systems, however, is challenging due to strict power, cost and hardware constraints at higher bandwidths. To achieve a good SNR for communication, mmWave systems use large antenna arrays. Beamforming with highly directional beams is one way to use the antennas. As the channel changes over time, the beams that maximize the SNR have to be estimated quickly to reduce the training overhead. Prior work has exploited the observation that mmWave channels are sparse to perform compressed sensing (CS) based beam alignment with few channel measurements. Most of the existing CS-based algorithms, however, assume perfect synchronization and fail in the presence of carrier frequency offset (CFO). This paper presents Swift-Link, a fast beam alignment algorithm that is robust against the offset. Swift-Link includes a novel randomized beam training sequence that minimizes the beam alignment errors due to CFO and a low-complexity algorithm that corrects these errors. Even with strict hardware constraints, our algorithm uses fewer channel measurements than comparable CS algorithms and has analytical guarantees. Swift-Link requires a small output dynamic range at the analog-to-digital converter compared to beam-scanning techniques.

cs.IT↗

Message passing-based joint CFO and channel estimation in millimeter wave systems with one-bit ADCs

Channel estimation at millimeter wave (mmWave) is challenging when large antenna arrays are used. Prior work has leveraged the sparse nature of mmWave channels via compressed sensing based algorithms for channel estimation. Most of these algorithms, though, assume perfect synchronization and are vulnerable to phase errors that arise due to carrier frequency offset (CFO) and phase noise. Recently sparsity-aware, non-coherent beamforming algorithms that are robust to phase errors were proposed for narrowband phased array systems with full resolution analog-to-digital converters (ADCs). Such energy based algorithms, however, are not robust to heavy quantization at the receiver. In this paper, we develop a joint CFO and wideband channel estimation algorithm that is scalable across different mmWave architectures. Our method exploits the sparsity of mmWave MIMO channel in the angle-delay domain, in addition to compressibility of the phase error vector. We formulate the joint estimation as a sparse bilinear optimization problem and then use message passing for recovery. We also give an efficient implementation of a generalized bilinear message passing algorithm for the joint estimation in mmWave systems with one-bit ADCs. Simulation results show that our method is able to recover the CFO and the channel compressively, even in the presence of phase noise.

cs.IT↗

Joint CFO and Channel Estimation in Millimeter Wave Systems with One-Bit ADCs

We develop a method to jointly estimate the carrier frequency offset (CFO) and the narrowband channel in millimeter wave (mmWave) MIMO systems operating with one-bit analog-to-digital converters (ADCs). We assume perfect timing synchronization and transform the underlying CFO-channel optimization problem to a higher dimensional space using lifting techniques. Exploiting the sparsity of mmWave MIMO channels in the angle domain, we perform joint estimation by solving a noisy quantized compressed sensing problem of the lifted version, using generalized approximate message passing. Simulation results show that our method is able to recover both the channel and the CFO using one-bit measurements.

cs.IT↗

A compressive channel estimation technique robust to synchronization impairments

Initial access at millimeter wave frequencies is a challenging problem due to hardware non-idealities and low SNR measurements prior to beamforming. Prior work has exploited the observation that mmWave MIMO channels are sparse in the spatial angle domain and has used compressed sensing based algorithms for channel estimation. Most of them, however, ignore hardware impairments like carrier frequency offset and phase noise, and fail to perform well when such impairments are considered. In this paper, we develop a compressive channel estimation algorithm for narrowband mmWave systems, which is robust to such non idealities. We address this problem by constructing a tensor that models both the mmWave channel and CFO, and estimate the tensor while still exploiting the sparsity of the mmWave channel. Simulation results show that under the same settings, our method performs better than comparable algorithms that are robust to phase errors.

cs.IT↗