arXiv subjects

Nobuyasu Shiga

Publications and source records attributed to Nobuyasu Shiga.

10 recordsLinked to original sources

arXiv2026

Leveraging Space-Time Synchronization for Ultra-Spot Detection in mmWave/THz UAV-to-UAV Communications

In UAV-to-UAV communication, airborne UAVs need to detect the location and direction of ultra-high-speed millimeter-wave (mmWave) and Terahertz (THz) coverage areas, referred to as ultra-spots. This predictive capability allows UAVs to optimally adjust their flight paths, altitude, and velocity, thereby maximizing the utilization of ultra-spot services. A space-time synchronization technique employing multiple Wireless Two-way Interferometry devices (multi-Wi-Wi) is proposed in this paper to detect mmWave/THz ultra-spot locations during UAV operations. This paper proposes an algorithm that estimates the likelihood of nearby ultra-spots by considering the UAV flight route and ultra-spot direction, and by sharing location and pose information among UAVs in the network via a 920 MHz wireless communication link. For the first time, this work addresses the problem of optimizing UAV flight routes to maximize ultra-spot utilization. To address the inherent challenges of Wi-Wi, such as phase data unreliability, RSSI attenuation, or packet loss caused by obstructions from the UAV's own body, this study proposes the use of multiple Wi-Wi devices equipped with antennas positioned at different positions around the arms of the UAV to leverage spatial diversity effects. The proposed method's effectiveness is confirmed through experimental data derived from real-world UAV-to-UAV communication tests. An error of 37.16 cm was observed experimentally in ultra-spot location estimation, corresponding to 186 ms error in temporal prediction of ultra-spot entry from an in-flight UAV, demonstrating its effectiveness in addressing ultra-spot detection challenges in mmWave communication.

eess.SY↗

arXiv2022

Experimental Demonstration of Delay-Bounded Wireless Network Based on Precise Time Synchronization

Low latency and reliable information transfer are highly demanded in fifth generation (5G) and beyond 5G wireless communications. A novel delay-bounded wireless media access control (MAC) protocol called Carrier Sense Multiple Access with Arbitration Point (CSMA/AP) was established to strictly ensure the upper boundary of communication delay. CSMA/AP enables collision-free and delay-bounded communications with a simple arbitration mechanism exploiting the precise time synchronization achieved by Wireless Two-Way Interferometry (Wi-Wi). Experimental demonstration and proving the feasibility in wireless environments are among the most critical steps before any further discussion of CSMA/AP and extension to various applications can take in place. In this work described in this paper, we experimentally demonstrated the fundamental principles of CSMA/AP by constructing a star-topology wireless network using software-defined radio terminals combined with precise time synchronization devices. We show that CSMA/AP was successfully operated, even with dynamic changes of the spatial position of the terminal or the capability to accommodate mobility, thanks to the real-time adaption to the dynamically changing environment by Wi-Wi. We also experimentally confirmed that the proposed CSMA/AP principle cannot be executed without Wi-Wi, which validates the importance of precise time synchronization. This study paves the way toward realizing delay-bounded wireless communications for future low-latency and highly reliable critical applications.

cs.NI↗

arXiv2020

Information transfer based on precision time synchronization via wireless interferometry

The growing demand of high-bandwidth and low-latency information transfer in information and communication technologies such as data centres and in-vehicle networks has increased the importance of optical communication networks in recent years. However, complicated arbitration schemes can impose significant overheads in data transfer, which may inhibit the full exploitation of the potential of optical interconnects. Herein, we propose an arbitration protocol based on precision time synchronization via wireless two-way interferometry (Wi-Wi), and numerically validate its efficiency including the ability to impose a strict upper bound on the latency of data transfer. Compared with the conventional carrier sense multiple access/collision detection (CSMA/CD)-based approach, a significant improvement in the data transfer was observed especially in the cases with high traffic flow rate. Furthermore, we conducted a proof-of-principle experiment for Wi-Wi-based data transfer between two electrically connected nodes and confirmed that the skew was less than 300 ns and remained stable over time. Conversely, non-WiWi-based data transfer exhibited huge and unstable skew. These results indicate that precision time synchronization is a promising resource to significantly reduce the communication overheads and ensure low latency for future networks and real-time applications.

cs.NI↗

arXiv2018

Range Variation Monitoring with Wireless Two-Way Interferometry (Wi-Wi)

We demonstrated a simple technique for monitoring range variation with millimeter-precision between two remote sites using off-the-shelf wireless communication modules. The need for the flexible positioning of wireless devices is significantly increasing as more devices are being connected and new services are being developed that require devices to collaborate with one another. We showed that one can monitor the distance variation by analyzing the propagation delay of the wireless communication signal between devices. We previously reported a technique for synchronizing clocks with picosecond precision by monitoring the time variation of two rubidium clocks located at remote sites. Precise measurement of the propagation time variation was necessary for precise synchronization of the clocks, and we used this information to estimate the distance with high precision. In a localized situation, our technique makes it easy to implement a millimeter-precision measurement system. Furthermore, it is less complex in terms of system design and can be a low-cost alternative to existing systems that require precise position measurement. We envision that this demonstrated protocol will be implemented in wireless communication chips and microprocessing units.

eess.SP↗

arXiv2014

Accelerating the Averaging Rate of Atomic Ensemble Clock Stability using Atomic Phase Lock

We experimentally demonstrated that the stability of an atomic clock improves at fastest rate $τ^{-1}$ (where $τ$ is the averaging time) when the phase of a local oscillator is genuinely compared to the continuous phase of many atoms in a single trap (atomic phase lock). For this demonstration, we developed a simple method that repeatedly monitors the atomic phase while retaining its coherence by observing only a portion of the whole ion cloud. Using this new method, we measured the continuous phase over 3 measurement cycles, and thereby improved the stability scaling from $τ^{-1/2}$ to $τ^{-1}$ during the 3 measurement cycles. %Compared with the standard method that initialize phase during each measurement cycle, the long term stability was improved by a factor of $\sqrt{n_{cp}}$ (where $n_{cp}$ is the number of continuous phase measurements). This simple method provides a path by which atomic clocks can approach a quantum projection noise limit, even when the measurement noise is dominated by the technical noise.

quant-ph↗

arXiv2012

Locking Local Oscillator Phase to the Atomic Phase via Weak Measurement

We propose a new method to reduce the frequency noise of a Local Oscillator (LO) to the level of white phase noise by maintaining (not destroying by projective measurement) the coherence of the ensemble pseudo-spin of atoms over many measurement cycles. This scheme uses weak measurement to monitor the phase in Ramsey method and repeat the cycle without initialization of phase and we call, "atomic phase lock (APL)" in this paper. APL will achieve white phase noise as long as the noise accumulated during dead time and the decoherence are smaller than the measurement noise. A numerical simulation confirms that with APL, Allan deviation is averaged down at a maximum rate that is proportional to the inverse of total measurement time, tau^-1. In contrast, the current atomic clocks that use projection measurement suppress the noise only down to the level of white frequency, in which case Allan deviation scales as tau^-1/2. Faraday rotation is one of the possible ways to realize weak measurement for APL. We evaluate the strength of Faraday rotation with 171Yb+ ions trapped in a linear rf-trap and discuss the performance of APL. The main source of the decoherence is a spontaneous emission induced by the probe beam for Faraday rotation measurement. One can repeat the Faraday rotation measurement until the decoherence become comparable to the SNR of measurement. We estimate this number of cycles to be ~100 cycles for a realistic experimental parameter.

physics.atom-ph↗

arXiv2009

Buffer gas induced collision shift for the $^{88}$Sr $\bf{^1S_0-^3P_1}$ clock transition

Precision saturation spectroscopy of the $^{88}{\rm Sr} ^1S_0-^3P_1$ is performed in a vapor cell filled with various rare gas including He, Ne, Ar, and Xe. By continuously calibrating the absolute frequency of the probe laser, buffer gas induced collision shifts of $\sim $kHz are detected with gas pressure of 1-20 mTorr. Helium gave the largest fractional shift of $1.6 \times 10^{-9} {\rm Torr}^{-1}$. Comparing with a simple impact calculation and a Doppler-limited experiment of Holtgrave and Wolf [Phys. Rev. A {\bf 72}, 012711 (2005)], our results show larger broadening and smaller shifting coefficient, indicating effective atomic loss due to velocity changing collisions. The applicability of the result to the $^1S_0-^3P_0$ optical lattice clock transition is also discussed.

physics.atom-ph↗

arXiv2009

High-fidelity quantum control using ion crystals in a Penning trap

We discuss the use of two-dimensional $^{9}$Be$^{+}$ ion crystals for experimental tests of quantum control techniques. Our primary qubit is the 124 GHz ground-state electron spin flip transition, which we drive using microwaves. An ion crystal represents a spatial ensemble of qubits, but the effects of inhomogeneities across a typical crystal are small, and as such we treat the ensemble as a single effective spin. We are able to initialize the qubits in a simple state and perform a projective measurement on the system. We demonstrate full control of the qubit Bloch vector, performing arbitrary high-fidelity rotations ($τ_π\sim$200 $μ$s). Randomized Benchmarking demonstrates an error per gate (a Pauli-randomized $π/2$ and $π$ pulse pair) of $8\pm1\times10^{-4}$. Ramsey interferometry and spin-locking measurements are used to elucidate the limits of qubit coherence in the system, yielding a typical free-induction decay coherence time of $T_{2}\sim$2 ms, and a limiting $T_{1ρ}\sim$688 ms. These experimental specifications make ion crystals in a Penning trap ideal candidates for novel experiments in quantum control. As such, we briefly describe recent efforts aimed at studying the error-suppressing capabilities of dynamical decoupling pulse sequences, demonstrating an ability to extend qubit coherence and suppress phase errors. We conclude with a discussion of future avenues for experimental exploration, including the use of additional nuclear-spin-flip transitions for effective multiqubit protocols, and the potential for Coulomb crystals to form a useful testbed for studies of large-scale entanglement.

quant-ph↗

arXiv2009

Experimental Uhrig Dynamical Decoupling using Trapped Ions

We present a detailed experimental study of the Uhrig Dynamical Decoupling (UDD) sequence in a variety of noise environments. Our qubit system consists of a crystalline array of $^{9}$Be$^{+}$ ions confined in a Penning trap. We use an electron-spin-flip transition as our qubit manifold and drive qubit rotations using a 124 GHz microwave system. We study the effect of the UDD sequence in mitigating phase errors and compare against the well known CPMG-style multipulse spin echo as a function of pulse number, rotation axis, noise spectrum, and noise strength. Our results agree well with theoretical predictions for qubit decoherence in the presence of classical phase noise, accounting for the effect of finite-duration $π$ pulses. Finally, we demonstrate that the Uhrig sequence is more robust against systematic over/underrotation and detuning errors than is multipulse spin echo, despite the precise prescription for pulse-timing in UDD.

quant-ph↗

arXiv2009

Optimized Dynamical Decoupling in a Model Quantum Memory

We present experimental measurements on a model quantum system that demonstrate our ability to dramatically suppress qubit error rates by the application of optimized dynamical decoupling pulse sequences in a variety of experimentally relevant noise environments. We provide the first demonstration of an analytically derived pulse sequence developed by Uhrig, and find novel sequences through active, real-time experimental feedback. These new sequences are specially tailored to maximize error suppression without the need for a priori knowledge of the ambient noise environment. We compare these sequences against the Uhrig sequence, and the well established CPMG-style spin echo, demonstrating that our locally optimized pulse sequences outperform all others under test. Numerical simulations show that our locally optimized pulse sequences are capable of suppressing errors by orders of magnitude over other existing sequences. Our work includes the extension of a treatment to predict qubit decoherence under realistic conditions, including the use of finite-duration, square $π$ pulses, yielding strong agreement between experimental data and theory for arbitrary pulse sequences. These results demonstrate the robustness of qubit memory error suppression through dynamical decoupling techniques across a variety of qubit technologies.

quant-ph↗