arXiv subjects

Olaf Reimann

Publications and source records attributed to Olaf Reimann.

7 recordsLinked to original sources

arXiv2026

EON-SII: Design of a transportable picosecond stellar intensity interferometer for compact-star astrophysics

Stellar intensity interferometry (SII) measures correlations in photon-arrival fluctuations recorded by telescopes observing bright celestial sources. It can resolve angular scales far smaller than those accessible to a single optical telescope and is largely insensitive to atmospheric turbulence. After the first demonstration of SII on Sirius in 1956, Hanbury Brown and Twiss used the technique to measure the diameters of 32 stars. More recently, VERITAS, MAGIC, H.E.S.S., and CTAO's LST-1 have revived the method, although observations remain restricted to bright targets because of their optical design, optimized for gamma-ray astrophysics, rather than SII. We present EON-SII, the design and performance of a two-telescope intensity interferometer intended to extend the SII technique to compact targets at magnitudes of about V=8.5 up to V=10.7. Each transportable telescope has a 4-m diameter mirror, approximately 9m2 collecting area, an actively aligned 18-panel primary mirror, and Cassegrain optics specified to concentrate at least 90% of the light within 3 arcsec. A fibre-free spectrograph covers 400-550 nm at R~7000-8000 and is designed to provide of order 1000 statistically independent spectral channels.

astro-ph.IM↗

arXiv2026

Direct comparison of SiPMs and PMTs in operation with a bright background and prospects of using SPADs as truly digital sensors

The use of silicon photomultipliers (SiPMs) alongside conventional photomultiplier tubes (PMTs) is a remarkable technological development in modern ground-based very high energy gamma-ray astronomy. SiPMs exhibit comparable or even higher photon detection efficiencies (PDEs) than PMTs. The sensitivity of a PMT matches well the spectral shape of Cherenkov radiation from extended air showers. In contrast to a PMT, the sensitivity of a SiPM is shifted toward longer wavelengths, where the intensity of light of night sky (LoNS), considered as unwanted noise, increases significantly. It is obvious that a SiPM with a higher PDE will indeed measure more Cherenkov light than a PMT, but it will also detect significantly higher LoNS noise; the question is which factor will predominate in the signal-to-noise-ratio (SNR). To compare the performance of a PMT with that of a SiPM, we built SiPM-based modules and installed these and operated in parallel in the imaging camera of the 17 m diameter MAGIC telescope. Our long-term studies show that SiPM, despite their higher PDE, can deliver only a comparable to PMT performance. As already the name SiPM suggests, we use these semiconductor sensors analogously to classical PMTs: We amplify their small signals, digitize, and calibrate the converted amplitudes. Although SiPM is essentially a digital sensor, its common-anode design does not allow one to directly profit from it. Numerous arrays of single-photon avalanche diodes (SPADs) are being developed in various laboratories worldwide. Unlike SiPM, SPAD arrays digitize the incident photons from the outset and count their number. We will dwell on the potential further developments of SPADs.

astro-ph.IM↗

arXiv2022

T-RAX: Transversely Resonant Axion eXperiment

We propose to use an elongated rectangular waveguide near its cutoff frequency for axionic dark matter searches. The detector's large surface area allows for significant signal power, while its narrow transverse dimension and tapered-waveguide coupling suppress parasitic modes. The proposed system can fit inside a solenoid magnet and is sensitive to the QCD-axion in the axion mass $40-400\,μ$eV. We describe the theoretical principles of the new design, present simulation results, and discuss the implementation.

astro-ph.IM↗

arXiv2020

A first proof of principle booster setup for the MADMAX dielectric haloscope

Axions and axion-like particles are excellent low-mass dark matter candidates. The MADMAX experiment aims to directly detect galactic axions with masses between $40\,μ{\rm eV}$ and $400\,μ{\rm eV}$ by using the axion-induced emission of electromagnetic waves from boundaries between materials of different dielectric constants under a strong magnetic field. Combining many such surfaces, this emission can be significantly enhanced (boosted) using constructive interference and resonances. We present a first proof of principle realization of such a booster system consisting of a copper mirror and up to five sapphire disks. The electromagnetic response of the system is investigated by reflectivity measurements. The mechanical accuracy, calibration process of unwanted reflections and the repeatability of a basic tuning algorithm to place the disks are investigated. We find that for the presented cases the electromagnetic response in terms of the group delay predicted by one-dimensional calculations is sufficiently realized in our setup. The repeatability of the tuning is at the percent level, and would have small impact on the sensitivity of such a booster.

physics.ins-det↗

arXiv2019

A First Look on 3D Effects in Open Axion Haloscopes

We explore finite size 3D effects in open axion haloscopes such as a dish antenna, a dielectric disk and a minimal dielectric haloscope consisting of a mirror and one dielectric disk. Particularly dielectric haloscopes are a promising new method for detecting dark matter axions in the mass range above $40\,μ{\rm eV}$. By using two specialized independent approaches - based on finite element methods and Fourier optics - we compute the electromagnetic fields in these settings expected in the presence of an axion dark matter field. This allows us to study diffraction and near field effects for realistically sized experimental setups in contrast to earlier idealized 1D studies with infinitely extended mirrors and disks. We also study axion velocity effects and disk tiling. Diffraction effects are found to become less relevant towards larger axion masses and for the larger disk radii for example aimed at in full size dielectric haloscopes such as MADMAX. The insights of our study not only provide a foundation for a realistic modelling of open axion dark matter search experiments in general, they are in particular also the first results taking into account 3D effects for dielectric haloscopes.

physics.ins-det↗

arXiv2017

Is the bump significant? An axion-search example

Many experiments in physics involve searching for a localized excess over background expectations in an observed spectrum. If the background is known and there is Gaussian noise, the amount of excess of successive observations can be quantified by the runs statistic taking care of the look-elsewhere effect. The distribution of the runs statistic under the background model is known analytically but the computation becomes too expensive for more than about a hundred observations. This work demonstrates a principled high-precision extrapolation from a few dozen up to millions of data points. It is most precise in the interesting regime when an excess is present. The method is verified for benchmark cases and successfully applied to real data from an axion search. The code that implements our method is available at https://github.com/fredRos/runs .

hep-ex↗

arXiv2017

Dielectric Haloscopes: A New Way to Detect Axion Dark Matter

We propose a new strategy to search for dark matter axions in the mass range of 40--400 $μ$eV by introducing dielectric haloscopes, which consist of dielectric disks placed in a magnetic field. The changing dielectric media cause discontinuities in the axion-induced electric field, leading to the generation of propagating electromagnetic waves to satisfy the continuity requirements at the interfaces. Large-area disks with adjustable distances boost the microwave signal (10--100 GHz) to an observable level and allow one to scan over a broad axion mass range. A sensitivity to QCD axion models is conceivable with 80 disks of 1 m$^2$ area contained in a $10$ Tesla field.

physics.ins-det↗