arXiv subjects

Olivier Lambercy

Publications and source records attributed to Olivier Lambercy.

6 recordsLinked to original sources

arXiv2026

Markerless Motion Capture in Routine Clinical Upper Limb Assessments: Validity and Insights Beyond Ordinal Scoring

The Action Research Arm Test (ARAT) is a widely-used upper limb outcome measure in neurorehabilitation, but its ordinal scoring is subjective and suffers from limited sensitivity and specificity. We evaluated whether artificial-intelligence (AI)-based markerless motion capture (MMC), embedded into ARAT assessments during clinical routine, accurately reconstructs upper limb movement and yields valid, objective kinematic metrics carrying clinically meaningful information beyond the ordinal score. Across 47 sessions from 20 mixed-neurological patients (1,174 ARAT tasks), biomechanical reconstruction was accurate and robust across impairment levels, and kinematic metrics showed the discrimination pattern expected of a construct-valid measure. In longitudinal case studies, the metrics added the specificity and sensitivity the ordinal score lacks: a domain decomposition exposed patient-specific recovery profiles underlying equal ARAT gains (specificity), and kinematic improvement continued to be detected after the ARAT had saturated (sensitivity). MMC in clinical routine can thus provide valid, objective, sensitive, and specific kinematic measurement complementing ordinal scoring.

cs.CV↗

arXiv2026

Machine Learning-Based Real-Time Detection of Compensatory Trunk Movements Using Trunk-Wrist Inertial Measurement Units

Compensatory trunk movements (CTMs) are commonly observed after stroke and can lead to maladaptive movement patterns, limiting targeted training of affected structures. Objective, continuous detection of CTMs during therapy and activities of daily living remains challenging due to the typically complex measurements setups required, as well as limited applicability for real-time use. This study investigates whether a two-inertial measurement unit configuration enables reliable, real-time CTM detection using machine learning. Data were collected from ten able-bodied participants performing activities of daily living under simulated impairment conditions (elbow brace restricting flexion-extension, resistance band inducing flexor-synergy-like patterns), with synchronized optical motion capture (OMC) and manually annotated video recordings serving as reference. A systematic location-reduction analysis using OMC identified wrist and trunk kinematics as a minimal yet sufficient set of anatomical sensing locations. Using an extreme gradient boosting classifier (XGBoost) evaluated with leave-one-subject-out cross-validation, our two-IMU model achieved strong discriminative performance (macro-F1 = 0.80 +/- 0.07, MCC = 0.73 +/- 0.08; ROC-AUC > 0.93), with performance comparable to an OMC-based model and prediction timing suitable for real-time applications. Explainability analysis revealed dominant contributions from trunk dynamics and wrist-trunk interaction features. In preliminary evaluation using recordings from four participants with neurological conditions, the model retained good discriminative capability (ROC-AUC ~ 0.78), but showed reduced and variable threshold-dependent performance, highlighting challenges in clinical generalization. These results support sparse wearable sensing as a viable pathway toward scalable, real-time monitoring of CTMs during therapy and daily living.

cs.RO↗

arXiv2024

Differentiable Biomechanics for Markerless Motion Capture in Upper Limb Stroke Rehabilitation: A Comparison with Optical Motion Capture

Marker-based Optical Motion Capture (OMC) paired with biomechanical modeling is currently considered the most precise and accurate method for measuring human movement kinematics. However, combining differentiable biomechanical modeling with Markerless Motion Capture (MMC) offers a promising approach to motion capture in clinical settings, requiring only minimal equipment, such as synchronized webcams, and minimal effort for data collection. This study compares key kinematic outcomes from biomechanically modeled MMC and OMC data in 15 stroke patients performing the drinking task, a functional task recommended for assessing upper limb movement quality. We observed a high level of agreement in kinematic trajectories between MMC and OMC, as indicated by high correlations (median r above 0.95 for the majority of kinematic trajectories) and median RMSE values ranging from 2-5 degrees for joint angles, 0.04 m/s for end-effector velocity, and 6 mm for trunk displacement. Trial-to-trial biases between OMC and MMC were consistent within participant sessions, with interquartile ranges of bias around 1-3 degrees for joint angles, 0.01 m/s in end-effector velocity, and approximately 3mm for trunk displacement. Our findings indicate that our MMC for arm tracking is approaching the accuracy of marker-based methods, supporting its potential for use in clinical settings. MMC could provide valuable insights into movement rehabilitation in stroke patients, potentially enhancing the effectiveness of rehabilitation strategies.

cs.CV↗

arXiv2024

Towards RehabCoach: Design and Preliminary Evaluation of a Conversational Agent Supporting Unsupervised Therapy after Stroke

Unsupervised therapy after stroke is a promising way to boost therapy dose without significantly increasing the workload on healthcare professionals. However, it raises important challenges, such as lower adherence to therapy in the absence of social interaction with therapists. We present the initial prototype of RehabCoach, a novel smartphone-based app with conversational agent to support unsupervised therapy. RehabCoach is designed to increase patients engagement and adherence to therapy and to provide information (e.g., about stroke, health) in an interactive and user-friendly manner. We report on the design and usability evaluation of the first prototype of RehabCoach, assessed by four stroke patients and five healthcare professionals, who interacted with the app in a single testing session. Task completion time and success rates were measured for 15 representative tasks, and participants assessed usability via questionnaires and a semi-structured interview. Results show that it was feasible for stroke patients to successfully interact with RehabCoach (task success $\geq$ 93 $\%$) without requiring extensive training. Participants positively rated the usability of RehabCoach (mean mHealth App Usability Questionnaire score: 1.3 for primary users, 1.4 for healthcare professionals, on a scale from 1 (positive evaluation) to 7). The feedback collected in this work opens the door to further enhance RehabCoach as an interactive digital tool to support unsupervised rehabilitation.

cs.HC↗

arXiv2019

Exoskeleton Knee Compliance Improves Gait Velocity and Stability in a Spinal Cord Injured User: A Case Report

Spinal cord injuries frequently impair the ability to walk. Powered lower limb exoskeletons offer a promising solution to restore walking ability. However, they are currently restricted to even ground. We hypothesized that compliant exoskeleton knees could decrease required effort to maneuver on uneven terrain, and increase gait velocity and stability. We describe a case study of a motor-complete spinal cord injury user (AIS A, Th12) walking with a powered exoskeleton on even and uneven ground over multiple sessions after extensive training. Measurements with compliant or rigid exoskeleton knee joints were performed on three different days for each configuration. Body motion and crutch ground interaction forces were recorded to assess gait performance. We observed higher walking speeds with a compliant exoskeleton knee configuration (mean: 0.116 m/s on uneven and 0.145 m/s on even ground) compared to a rigid configuration (mean: 0.083 m/s and 0.100 m/s). Crutch force impulse was significantly reduced in the compliant configuration. Lastly, gait was more symmetric when the knee joints were compliant. In conclusion, compliant exoskeleton knee joints can help maneuver uneven ground faster and with less user effort than rigid joints. Based on our findings, exoskeleton designers should consider introducing compliance into their design to increase gait robustness and performance, and render exoskeletons more suitable for daily life use.

cs.RO↗

arXiv2019

Knee Compliance Reduces Peak Swing Phase Collision Forces in a Lower-Limb Exoskeleton Leg: A Test Bench Evaluation

Powered lower limb exoskeletons are a viable solution for people with a spinal cord injury to regain mobility for their daily activities. However, the commonly employed rigid actuation and pre-programmed trajectories increase the risk of falling in case of collisions with external objects. Compliant actuation may reduce forces during collisions, thus protecting hardware and user. However, experimental data of collisions specific to lower limb exoskeletons are not available. In this work, we investigated how a variable stiffness actuator at the knee joint influences collision forces transmitted to the user via the exoskeleton. In a test bench experiment, we compared three configurations of an exoskeleton leg with a variable stiffness knee actuator in (i) compliant or (ii) stiff configurations, and with (iii) a rigid actuator. The peak torque observed at the pelvis was reduced from 260.2 Nm to 116.2 Nm as stiffness decreased. In addition, the mechanical impulse was reduced by a factor of three. These results indicate that compliance in the knee joint of an exoskeleton can be favorable in case of collision and should be considered when designing powered lower limb exoskeletons. Overall, this could decrease the effort necessary to maintain balance after a collision and improved collision handling in exoskeletons could result in safer use and benefit their usefulness in daily life.

physics.med-ph↗