arXiv subjects

Orion Smedley

Publications and source records attributed to Orion Smedley.

3 recordsLinked to original sources

arXiv2026

Two Strategies to Measure Spin-Orbit-Torque Efficiency Acting on the Insulating Magnet Li$_{0.5}$Al$_{0.7}$Fe$_{1.8}$O$_4$

For insulating magnets, widely-used electrically-based techniques to measure spin-orbit-torque efficiency can suffer from poor signal-to-noise ratios and unwanted artifacts, while optical measurements based on conventional magneto-optical Kerr effect (MOKE) imaging often lack sufficient sensitivity. Here we analyze two strategies for measuring the spin-torque efficiency acting on an insulating magnet, focusing on the torque from Pt acting on thin films of the low-damping magnet lithium aluminum ferrite (LAFO). First, lateral + longitudinal spin-torque ferromagnetic resonance (ST-FMR) allows separation of the spin-torque signal from artifacts due to spin-pumping and resonant heating. With this technique, we measure a spin-torque efficiency $ξ^\text{ST-FMR}_\text{DL}\sim\ 0.07$, comparable to but a bit less than for Pt acting on metallic ferromagnets. Second, we attempted optical measurements of spin-orbit-torque-induced magnetic deflection using Sagnac interferometry. We find that Sagnac interferometry provides sufficient sensitivity to measure signals from 14.4 nm LAFO thin films, but the inferred torque efficiency is much weaker than the result from lateral + longitudinal ST-FMR. We speculate that there may be another contribution to the Sagnac signal other than current-induced magnetic deflection, perhaps an out-of-plane component of itinerant electron spins. This becomes relevant for insulating magnets in which the magneto-optic coupling coefficient is very weak.

cond-mat.mes-hall↗

arXiv2024

Atomic fluorescence collection into planar photonic devices

Fluorescence collection from individual emitters plays a key role in state detection and remote entanglement generation, fundamental functionalities in many quantum platforms. Planar photonics have been demonstrated for robust and scalable addressing of trapped-ion systems, motivating consideration of similar elements for the complementary challenge of photon collection. Here, using an argument from the reciprocity principle, we show that far-field photon collection efficiency can be simply expressed in terms of the fields associated with the collection optic at the emitter position alone. We calculate collection efficiencies into ideal paraxial and fully vectorial focused Gaussian modes parameterized in terms of focal waist, and further quantify the modest enhancements possible with more general beam profiles, establishing design requirements for efficient collection. Towards practical implementation, we design, fabricate, and characterize two diffractive collection elements operating at $λ=397$ nm; a forward emitting design is predicted to offer 0.25% collection efficiency into a single waveguide mode, while a more efficient reverse-emitting design offers $1.14\%$ collection efficiency, albeit with more demanding fabrication requirements. Close agreement between simulated and measured emission for both designs indicates practicality of these collection efficiencies, and we indicate avenues to improved devices approaching the limits predicted for ideal beams. We point out a particularly simple integrated waveguide configuration for polarization-based remote entanglement generation enabled by integrated collection.

physics.optics↗

arXiv2023

Sagnac interferometry for high-sensitivity optical measurements of spin-orbit torque

Sagnac interferometry can provide a significant improvement in signal-to-noise ratio compared to conventional magnetic imaging based on the magneto-optical Kerr effect (MOKE). We show that this improvement is sufficient to allow quantitative measurements of current-induced magnetic deflections due to spin-orbit torque even in thin-film magnetic samples with perpendicular magnetic anisotropy for which the Kerr rotation is second-order in the magnetic deflection. Sagnac interfermometry can also be applied beneficially for samples with in-plane anisotropy, for which the Kerr rotation is first order in the deflection angle. Optical measurements based on Sagnac interferometry can therefore provide a cross-check on electrical techniques for measuring spin-orbit torque. Different electrical techniques commonly give quantitatively inconsistent results, so that Sagnac interferometry can help to identify which techniques are affected by unidentified artifacts.

cond-mat.mes-hall↗