arXiv subjects

Osbel Almora

Publications and source records attributed to Osbel Almora.

6 recordsLinked to original sources

arXiv2024

NiOx passivation in perovskite solar cells: from surface reactivity to device performance

Non-stoichiometric nickel oxide (NiOx) is the only metal oxide successfully used as hole transport material in p-i-n type perovskite solar cells (PSCs). Its favorable opto-electronic properties and facile large-scale preparation methods are potentially relevant for future commercialization of PSCs, though currently low operational stability of PSCs containing NiOx hole transport layers are reported. Poorly understood degradation reactions at the interface to the perovskite are seen as cause for the inferior stability and a variety of interface passivation approaches have been shown to be effective in improving the overall solar cell performance. To gain a better understanding of the processes happening at this interface, we systematically passivated possible specific defects on NiOx with three different categories of organic/inorganic compounds. The effects on the NiOx and the perovskite (MAPbI3) were investigated using x-ray photoelectron spectroscopy (XPS), X-ray diffraction (XRD), and scanning electron microscopy (SEM) where we find that the structural stability and film formation can be significantly affected. In combination with Density Functional Theory (DFT) calculations, a likely origin of NiOx-perovskite degradation interactions is proposed. The surface passivated NiOx was incorporated into MAPbI3 based PSCs and its influence on overall performance, particularly operational stability, was investigated by current-voltage (J-V), impedance spectroscopy (IS), and open circuit voltage decay (OCVD) measurements. Interestingly, we find that a superior structural stability due to an interface passivation must not relate to high operational stability. The discrepancy comes from the formation of excess ions at the interface which negatively impacts all solar cell parameters.

cond-mat.mtrl-sci↗

arXiv2024

Degradation Analysis of Perovskite Solar Cells via Short-Circuit Impedance Spectroscopy: A case study on NiOx passivation

Perovskite solar cells (PSCs) continue to be the front runner technology among emerging photovoltaic devices in terms of power conversion efficiency and application versatility. However, not only the stability but also the understanding of their ionic-electronic transport mechanisms continues to be challenging. In this work, the case study of NiOx-based inverted PSCs and the effect of different interface passivating treatments on the device performance are approached. Our experiments include impedance spectroscopy (IS) measurements in short-circuit under different illumination intensities and operational stability tests under constant illumination intensity. It is found that certain surface treatments lead to more stable performance. However, protic anion donors can induce, both, an initial performance decrease and a subsequent reactivity during light exposure which apparently improves the cells performance. Our drift-diffusion simulations suggest that the modification of the interface with the hole transport material may have decrease the conductivity, as well as the ion and electron mobilities at the perovskite and the NiOx, respectively. Importantly, capacitance and resistance are shown to peak maximum and minimum values, respectively, around specific ranges of mobile ion concentration. Our results introduce a general route for characterization of degradation paths in PSCs via IS in short-circuit.

physics.app-ph↗

arXiv2022

Effective Ion Mobility and Long-Time Dark Current of Metal-Halide Perovskites of Different Crystallinity and Composition

Ion transport properties in metal-halide perovskite still constitute a subject of intense research because of the evident connection between mobile defects and device performance and operation degradation. In the specific case of X-ray detectors, dark current level and instability is regarded to be connected to the ion migration upon bias application. Different compositions (MAPbBr3 and MAPbI3) and structures (single- and micro-crystalline) are checked by the analysis of long-time dark current evolution. In all cases, electronic current increases with time before reaching a steady-state value within a response time (from 10.000 s down to 10 s) that strongly depends on the applied bias. Our findings corroborate the existence of a coupling between electronic transport and ion kinetics that ultimately establishes the time scale of electronic current. Effective ion mobility mui is extracted that exhibits applied electrical field E dependence that varies on the perovskite composition. While ion mobility results field-independent in the case of MAPbI3, a clear field-enhancement is observed for MAPbBr3 (dmui/dE>0), irrespective of the crystallinity. Both perovskite compounds present effective ion mobility in the range of mui = 10-7-10-6 cm-2 V-1 s-1, in accordance with previous analyses. The E-dependence of the ion mobility is related to the lower ionic concentration of the bromide compound. Slower-migrating defect drift is suppressed in the case of MAPbBr3, in opposition to that observed here for MAPbI3.

cond-mat.mtrl-sci↗

arXiv2021

Ballistic-like Space-charge-limited Currents in Halide Perovskites at Room Temperature

The emergence of halide perovskites in photovoltaics has diversified the research on this material family and extended their application towards several fields in the optoelectronics, such as photo- and ionizing-radiation-detectors. One of the most basic characterization protocols consist on measuring the dark current-voltage (J-V) curve of symmetrically contacted samples for identifying the different regimes of space-charge-limited current (SCLC). Customarily, J=C*V^n curves indicate the Mott-Gurney law when n=2, or the Child-Langmuir ballistic regime of SCLC when n=3/2. The latter can be often found in perovskite samples. In this work, we start by discussing the interpretation of currents proportional to V^(3/2) in relation to the masking effect of the dual electronic-ionic conductivity in halide perovskites. However, we do not discard the actual occurrence of SCLC transport with ballistic-like trends. For those cases, we introduce the models of: quasi-ballistic velocity-dependent dissipation (QvD) and the ballistic-like voltage-dependent mobility (BVM) regime of SCLC. The QvD model is shown to better describe electronic kinetics, whereas the BVM model is revealed as suitable for describing electronic or ionic kinetics in halide perovskites. The proposed formulations can be used as characterization tools for the evaluation of effective mobilities, charge carrier concentrations and times-of-flight from J-V curves and impedance spectroscopy spectra.

cond-mat.mtrl-sci↗

arXiv2019

Light Intensity Modulated Impedance Spectroscopy (LIMIS) in All-Solid-State Solar Cells at Open Circuit

Potentiostatic impedance spectroscopy (IS) is a well stablished characterization technique for elucidating the electric resistivity and capacitive features of materials and devices. In the case of solar cells, by applying a small voltage perturbation the current signal is recorded and the recombination processes and defect distributions are among the typical outcomes in IS studies. In this work a photo-impedance approach, named light intensity modulated impedance spectroscopy (LIMIS), is first tested in all-solid-state photovoltaic cells by recording the individual photocurrent (IMPS) and photovoltage (IMVS) responsivity signals due to a small light perturbation at open-circuit (OC), and combining them: LIMIS=IMVS/IMPS. The experimental LIMIS spectra from silicon, organic, and perovskite solar cells are presented and compared with IS. An analysis of the equivalent circuit numerical models for total resistive and capacitive features is discussed. Our theoretical findings show a correction to the lifetimes evaluations by obtaining the total differential resistances and capacitances combining IS and LIMIS measurements. This correction addresses the discrepancies among different techniques, as shown with transient photovoltage. The experimental differences between IS and LIMIS (i) proves the unviability of the superposition principle, (ii) suggest a bias-dependent photo-current correction to the empirical Shockley equation of the steady-state current at different illumination intensities around OC and (iii) are proposed as a potential figure of merit for characterizing performance and stability of solar cells. In addition, new features are reported for the low-frequency capacitance of perovskite solar cells, measured by IS and LIMIS.

physics.app-ph↗

arXiv2019

Analytical Model for Light Modulating Impedance Spectroscopy (LIMIS) in All-Solid-State p-n Junction Solar Cells at Open-Circuit

Non-circuit theory drift-diffusion numerical simulation of standard potentiostatic impedance spectroscopy (IS) is a well-known strategy for characterization of materials and electronic devices. It implies the time-dependent solutions from the continuity and Poisson's equations under small perturbation of the bias boundary condition at the electrodes. But in the case of photo-sensitive devices a small light perturbation can be also taken modulating the generation rate along the absorber bulk. In that focus, this work approaches a set of analytical solutions for the signals of IS and intensity modulated photocurrent and photovoltage spectroscopies, IMPS and IMVS respectively, from one-sided p-n junction solar cells at open-circuit. Subsequently, a photo-impedance signal named light intensity modulated impedance spectroscopy (LIMIS equals IMVS over IMPS) is analytically simulated and its difference with respect to IS suggests a correlation with the surface charge carrier recombination velocity. This is an illustrative result and starting point for future more realistic numerical simulations.

cond-mat.mtrl-sci↗