arXiv subjects

Oskar Painter

Publications and source records attributed to Oskar Painter.

117 records · Page 7Linked to original sources

arXiv2004

Rayleigh scattering, mode coupling, and optical loss in silicon microdisks

High refractive index contrast optical microdisk resonators fabricated from silicon-on-insulator wafers are studied using an external silica fiber taper waveguide as a wafer-scale optical probe. Measurements performed in the 1500 nm wavelength band show that these silicon microdisks can support whispering-gallery modes with quality factors as high as 5.2 x 10^5, limited by Rayleigh scattering from fabrication induced surface roughness. Microdisks with radii as small as 2.5 microns are studied, with measured quality factors as high as 4.7 x 10^5 for an optical mode volume of 5.3 cubic wavelengths in the material.

physics.optics↗

arXiv2004

Experimental demonstration of fiber-accessible metal nanoparticle plasmon waveguides for planar energy guiding and sensing

Experimental evidence of mode-selective evanescent power coupling at telecommunication frequencies with efficiencies up to 75 % from a tapered optical fiber to a carefully designed metal nanoparticle plasmon waveguide is presented. The waveguide consists of a two-dimensional square lattice of lithographically defined Au nanoparticles on an optically thin silicon membrane. The dispersion and attenuation properties of the waveguide are analyzed using the fiber taper. The high efficiency of power transfer into these waveguides solves the coupling problem between conventional optics and plasmonic devices and could lead to the development of highly efficient plasmonic sensors and optical switches.

physics.optics↗

arXiv2004

Optical fiber coupling to planar photonic crystal microcavities

A technique is demonstrated which efficiently transfers light between a tapered standard single-mode optical fiber and a resonant mode of a high-Q photonic crystal cavity with mode volume less than a cubic wavelength in size. Cavity mode quality factors of 4.7 x 10^4 are measured, and a total fiber-to-cavity coupling efficiency of 44% is demonstrated.

physics.optics↗

arXiv2004

Feasibility of detecting single atoms using photonic bandgap cavities

We propose an atom-cavity chip that combines laser cooling and trapping of neutral atoms with magnetic microtraps and waveguides to deliver a cold atom to the mode of a fiber taper coupled photonic bandgap (PBG) cavity. The feasibility of this device for detecting single atoms is analyzed using both a semi-classical treatment and an unconditional master equation approach. Single-atom detection seems achievable in an initial experiment involving the non-deterministic delivery of weakly trapped atoms into the mode of the PBG cavity.

quant-ph↗

arXiv2003

Fabrication-tolerant high quality factor photonic crystal microcavities

A two-dimensional photonic crystal microcavity design supporting a wavelength-scale volume resonant mode with a calculated quality factor (Q) insensitive to deviations in the cavity geometry at the level of Q~2x10^4 is presented. The robustness of the cavity design is confirmed by optical fiber-based measurements of passive cavities fabricated in silicon. For microcavities operating in the lambda = 1500 nm wavelength band, quality factors between 1.3-4.0x10^4 are measured for significant variations in cavity geometry and for resonant mode normalized frequencies shifted by as much as 10% of the nominal value.

physics.optics↗

arXiv2003

Efficient input and output fiber coupling to a photonic crystal waveguide

The efficiency of evanescent coupling between a silica optical fiber taper and a silicon photonic crystal waveguide is studied. A high reflectivity mirror on the end of the photonic crystal waveguide is used to recollect, in the backwards propagating fiber mode, the optical power that is initially coupled into the photonic crystal waveguide. An outcoupled power in the backward propagating fiber mode of 88% of the input power is measured, corresponding to a lower bound on the coupler efficiency of 94%.

physics.optics↗

arXiv2003

Optical-fiber based measurement of an ultra-small volume high-Q photonic crystal microcavity

A two-dimensional photonic crystal semiconductor microcavity with a quality factor Q ~ 40,000 and a modal volume Veff ~ 0.9 cubic wavelengths is demonstrated. A micron-scale optical fiber taper is used as a means to probe both the spectral and spatial properties of the cavity modes, allowing not only measurement of modal loss, but also the ability to ascertain the in-plane localization of the cavity modes. This simultaneous demonstration of high-Q and ultra-small Veff in an optical microcavity is of potential interest in quantum optics, nonlinear optics, and optoelectronics. In particular, the measured Q and Veff values could enable strong coupling to both atomic and quantum dot systems in cavity quantum electrodynamics.

quant-ph↗

arXiv2003

Probing the dispersive and spatial properties of planar photonic crystal waveguide modes via highly efficient coupling from optical fiber tapers

The demonstration of an optical fiber based probe for efficiently exciting the waveguide modes of high-index contrast planar photonic crystal (PC) slabs is presented. Utilizing the dispersion of the PC, fiber taper waveguides formed from standard silica single-mode optical fibers are used to evanescently couple light into the guided modes of a patterned silicon membrane. A coupling efficiency of approximately 95% is obtained between the fiber taper and a PC waveguide mode suitably designed for integration with a previously studied ultra-small mode volume high-Q PC resonant cavity [1]. The micron-scale lateral extent and dispersion of the fiber taper is also used as a near-field spatial and spectral probe to study the profile and dispersion of PC waveguide modes. The mode selectivity of this wafer-scale probing technique, together with its high efficiency, suggests that it will be useful in future quantum and non-linear optics experiments employing planar PCs.

quant-ph↗

arXiv2003

Experimental demonstration of a high quality factor photonic crystal microcavity

Sub-threshold measurements of a photonic crystal (PC) microcavity laser operating at 1.3 microns show a linewidth of 0.10 nm, corresponding to a quality factor Q ~ 1.3x10^4. The PC microcavity mode is a donor-type mode in a graded square lattice of air holes, with a theoretical Q ~ 10^5 and mode volume Veff ~ 0.25 cubic half-wavelengths in air. Devices are fabricated in an InAsP/InGaAsP multi-quantum well membrane and are optically pumped at 830 nm. External peak pump power laser thresholds as low as 100 microWatts are also observed.

quant-ph↗