Searcharxiv⌕ Search

arXiv subjects

Oswaldo Diéguez

Publications and source records attributed to Oswaldo Diéguez.

12 recordsLinked to original sources

Translational covariance of flexoelectricity at ferroelectric domain walls

Macroscopic descriptions of ferroelectrics have an obvious appeal in terms of efficiency and physical intuition. Their predictive power, however, has often been thwarted by the lack of a systematicp rocedure to extract the relevant materials parameters from the microscopics. Here we address this limitation by establishing an unambiguous two-way mapping between spatially inhomogeneous fields and discrete lattice modes. This yields a natural treatment of gradient couplings in the macroscopic regime via a long-wavelength expansion of the crystal Hamiltonian. Our analysis reveals an inherent arbitrariness in both the flexoelectric and polarization gradient coefficients, which we ascribe to a translational freedom in the definition of the polar distortion pattern. Remarkably, such arbitrariness cancels out in all physically measurable properties (relaxed atomic structure and energetics) derived from the model, pointing to a generalized translational covariance in the continuum description of inhomogeneous ferroelectric structures. We demonstrate our claims with extensive numerical tests on 180-degree domain walls in common ferroelectric perovskites, finding excellent agreement between the continuum model and direct first-principles calculations.

cond-mat.mtrl-sci↗

Polymorphism in Bi-based perovskite oxides: a first-principles study

Under normal conditions, bulk crystals of BiScO$_3$ , BiCrO$_3$, BiMnO$_3$, BiFeO$_3$, and BiCoO$_3$ present three very different variations of the perovskite structure: an antipolar phase, a rhombohedral phase with a large polarization along the space diagonal of the pseudocubic unit cell, and a supertetragonal phase with even larger polarization. With the aim of understanding the causes for this variety, we have used a genetic algorithm to search for minima in the surface energy of these materials. Our results show that the number of these minima is very large when compared to that of typical ferroelectric perovskites like BaTiO$_3$ and PbTiO$_3$ , and that a fine energy balance between them results in the large structural differences seen. As byproducts of our search we have identified charge-ordering structures with low energy in BiMnO$_3$ , and several phases with energies that are similar to that of the ground state of BiCrO$_3$. We have also found that a inverse supertetragonal phase exists in bulk, likely to be favored in films epitaxially grown at large values of tensile misfit strain.

cond-mat.mtrl-sci↗

Multiferroic Bi$_2$NiMnO$_6$ Thin Films: A Computational Prediction

We report first-principles calculations for one of the few materials that is believed to be a ferroelectric ferromagnet, Bi$_2$NiMnO$_6$. Our calculations show that, contrary to what it has been reported so far, bulk Bi$_2$NiMnO$_6$ does not have a polarization. Instead, like BiMnO$_3$, it crystallizes into a centrosymmetric structure with space group $C2/c$. We also predict that Bi$_2$NiMnO$_6$ will indeed be a ferroelectric ferromagnet if it is grown as an epitaxial film on a substrate with in-plane square symmetry and a lattice constant around 4~Å, such as BaTiO$_3$ or PbZr$_{1-x}$Ti$_{x}$O$_{3}$.

cond-mat.mtrl-sci↗

Epitaxial Phases of BiMnO$_3$ from First Principles

Bulk BiMnO$_3$ is the only transition-metal perovskite oxide that is insulating and shows strong ferromagnetism. This distinctive behavior would make it a promising candidate as a magnetoelectric multiferroic if it was also a polar material, but experiments have shown that bulk BiMnO$_3$ has either a very small polarization (below 0.1~$μ$C/cm$^2$) or, most likely, that it is a paraelectric. There is also experimental evidence that the polarization in BiMnO$_3$ {\em films} grown on SrTiO$_3$ can be as high as 20~$μ$C/cm$^2$. Despite of the interest of these behaviors, the diagram of BiMnO$_3$ as a function of epitaxial strain has remained largely unexplored. In this article, we use first-principles to predict that both under enough compressive and tensile epitaxial strain BiMnO$_3$ films are ferroelectric with a giant polarization around 100~$μ$C/cm$^2$. The phases displayed by the films are similar to those experimentally found for BiFeO$_3$ in similar conditions---at compressive strains, the film is supertetragonal with a large component of the polarization pointing out of plane, while at tensile strains the polarization points mostly in plane. Like in BiFeO$_3$ films, these phases are antiferromagnetic---the orbital ordering responsible for ferromagnetism in BiMnO$_3$ is absent in the polar phases. Our calculations also show that the band gap of some of these BiMnO$_3$ films is substantially smaller than gaps typically found in ferroelectric oxides, suggesting it may be a suitable material for photovoltaic applications.

cond-mat.mtrl-sci↗

Domain walls in a perovskite oxide with two primary structural order parameters: first-principles study of BiFeO$_3$

We present a first-principles study of ferroelectric domain walls (FE-DWs) in multiferroic BiFeO$_3$ (BFO), a material in which the FE order parameter coexists with anti-ferrodistortive (AFD) modes involving rotations of the O$_6$ octahedra. We find that the energetics of the DWs are dominated by the capability of the domains to match their O$_6$ octahedra rotation patterns at the plane of the wall, so that the distortion of the oxygen groups is minimized. Our results thus indicate that, in essence, it is the discontinuity in the AFD order parameter, and not the change in the electric polarization, what decides which crystallographic planes are most likely to host BFO's FE-DWs. Such a result clearly suggests that the O$_6$ rotational patterns play a primary role in the FE phase of this compound, in contrast with the usual (implicit) assumption that they are subordinated to the FE order parameter. Our calculations show that, for the most favorable cases in BFO, the DW energy amounts to a several tens of mJ/m$^2$, which is higher than what was computed for other ferroelectric perovskites with no O$_6$ rotations. Interestingly, we find that the structure of BFO at the most stable DWs resembles the atomic arrangements that are characteristic of low-lying (meta)stable phases of the material. Further, we argue that our results for the DWs of bulk BFO are related with the nanoscale-twinned structures that Prosandeev et al. [Adv. Funct. Mats. (2012), doi: 10.1002/adfm.201201467] have recently predicted to occur in this compound, and suggest that BFO can be viewed as a polytypic material. Our work thus contributes to shape a coherent picture of the structural variants that BFO can present and the way in which they are related.

cond-mat.mtrl-sci↗

Strain engineering magnetic frustration in perovskite oxide thin films

Our first-principles results show that geometric frustration can be induced in thin films of multiferroic BiFeO3. We find that competing magnetic interactions occur in the so-called super-tetragonal phase of this material, which can be grown on strongly-compressive substrates. We show that the frustration level can be tuned by appropriately choosing the substrate; in fact, the three-dimensional spin order gets totally annihilated in a narrow range of epitaxial strains. We argue that the effects revealed here are not exclusive to BiFeO3, and predict that they also occur in multiferroic BiCoO3.

cond-mat.mtrl-sci↗

First-principles investigation of morphotropic transitions and phase-change functional responses in BiFeO3-BiCoO3 multiferroic solid solutions

We present an ab initio study of the BFCO solid solution formed by multiferroics BiFeO3 (BFO) and BiCoO3 (BCO). We find that BFCO presents a strongly discontinuous morphotropic transition between BFO-like and BCO-like ferroelectric phases. Further, for all compositions such phases remain (meta)stable and retain well-differentiated properties. Our results thus suggest that an electric field can be used to switch between these structures, and show that such a switching involves large phase-change effects of various types, including piezoelectric, electric, and magnetoelectric ones.

cond-mat.mtrl-sci↗

First-principles predictions of low-energy phases of multiferroic BiFeO3

We used first-principles methods to perform a systematic search for potentially-stable phases of multiferroic BiFeO3. We considered a simulation cell compatible with the atomic distortions that are most common among perovskite oxides, and found a large number of local minima of the energy within 100 meV/f.u. of the ferroelectric ground state. We discuss the variety of low-symmetry structures discovered, as well as the implications of these findings as regards current experimental (e.g., on thin films displaying {\em super-tetragonal} phases) and theoretical (on models for BiFeO3's structural phase transitions) work on this compound.

cond-mat.mtrl-sci↗

A first-principles characterization of the structure and electronic structure of $α$-S and Rh-S chalcogenides

We have used first-principles calculations to study the structural, electronic, and thermodynamic properties of the three known forms of Rh-S chalcogenides: Rh$_2$S$_3$, Rh$_3$S$_4$, and Rh$_{17}$S$_{15}$. Only the first of these materials of interest for catalysis had been studied previously within this approach. We find that Rh$_{17}$S$_{15}$ crystallizes in a {\em Pm}\={3}{\em m} centrosymmetric structure, as believed experimentally but never confirmed. We show band structures and densities of states for these compounds. Finally, we also investigated the ground state structure of solid sulfur ($α$-S), one of the few elements that represents a challenge for full first-principles calculations due to its demanding 128-atom unit cell and dispersion interactionis between S$_8$ units.

cond-mat.mtrl-sci↗

First-principles modeling of strain in perovskite ferroelectric thin films

We review the role that first-principles calculations have played in understanding the effects of substrate-imposed misfit strain on epitaxially grown perovskite ferroelectric films. We do so by analyzing the case of BaTiO$_3$, complementing our previous publications on this subject with unpublished data to help explain in detail how these calculations are done. We also review similar studies in the literature for other perovskite ferroelectric-film materials.

cond-mat.mtrl-sci↗

Wannier-based definition of layer polarizations in perovskite superlattices

In insulators, the method of Marzari and Vanderbilt [Phys. Rev. B {\bf 56}, 12847 (1997)] can be used to generate maximally localized Wannier functions whose centers are related to the electronic polarization. In the case of layered insulators, this approach can be adapted to provide a natural definition of the local polarization associated with each layer, based on the locations of the nuclear charges and one-dimensional Wannier centers comprising each layer. Here, we use this approach to compute and analyze layer polarizations of ferroelectric perovskite superlattices, including changes in layer polarizations induced by sublattice displacements (i.e., layer-decomposed Born effective charges) and local symmetry breaking at the interfaces. The method provides a powerful tool for analyzing the polarization-related properties of complex layered oxide systems.

cond-mat.mtrl-sci↗

First-Principles Calculations at Constant Polarization

We develop an exact formalism for performing first-principles calculations for insulators at fixed electric polarization. As shown by Sai, Rabe, and Vanderbilt (SRV) [N. Sai, K. M. Rabe, and D. Vanderbilt, Phys. Rev. B {\bf 66}, 104108 (2002)], who designed an approximate method to tackle the same problem, such an approach allows one to map out the energy landscape as a function of polarization, providing a powerful tool for the theoretical investigation of polar materials. We apply our method to a system in which the ionic contribution to the polarization dominates (a broken-inversion-symmetry perovskite), one in which this is not the case (a III-V semiconductor), and one in which an additional degree of freedom plays an important role (a ferroelectric phase of KNO$_3$). We find that while the SRV method gives rather accurate results in the first case, the present approach provides important improvements to the physical description in the latter cases.

cond-mat.mtrl-sci↗