Searcharxiv⌕ Search

arXiv subjects

Pål Frenger

Publications and source records attributed to Pål Frenger.

11 recordsLinked to original sources

Leveraging Slowly Time-Varying AP-AP Channels for Interference Mitigation in Dynamic TDD

We address the challenge of cross-link interference in dynamic time-division duplexing (TDD) systems. Specifically, we focus on mitigating the interference caused by access points (APs) operating in downlink to APs operating in uplink. To this end, we exploit that channels between APs typically vary much more slowly over time than channels between users and APs. This observation allows us to jointly estimate the uplink user data and the AP-AP channels using a least-squares formulation over multiple coherence intervals, during which the AP-AP channels stay constant. We derive conditions for unique solvability of this least-squares problem by analyzing the rank of the regression matrix. For cases where a unique solution does not exist, we propose to transform the problem into a uniquely solvable one by sacrificing a subset of the uplink data samples. Numerical results demonstrate that our proposed methods achieve substantial gains over baseline algorithms. Further, we observe that one of our proposed algorithms achieves almost perfect AP-AP interference mitigation when the AP-AP channels vary very slowly over time.

eess.SP↗

User-to-User Interference Mitigation in Dynamic TDD MIMO Systems with Multi-Antenna Users

We propose a novel method for user-to-user interference (UUI) mitigation in dynamic time-division duplex multiple-input multiple-output communication systems with multi-antenna users. Specifically, we consider the downlink data transmission in the presence of UUI caused by a user that simultaneously transmits in uplink. Our method introduces an overhead for estimation of the user-to-user channels by transmitting pilots from the uplink user to the downlink users. Each downlink user obtains a channel estimate that is used to design a combining matrix for UUI mitigation. We analytically derive an achievable spectral efficiency for the downlink transmission in the presence of UUI with our mitigation technique. Through numerical simulations, we show that our method can significantly improve the spectral efficiency performance in cases of heavy UUI.

eess.SP↗

Joint Optimization of Switching Point and Power Control in Dynamic TDD Cell-Free Massive MIMO

We consider a cell-free massive multiple-input multiple-output (CFmMIMO) network operating in dynamic time division duplex (DTDD). The switching point between the uplink (UL) and downlink (DL) data transmission phases can be adapted dynamically to the instantaneous quality-of-service (QoS) requirements in order to improve energy efficiency (EE). To this end, we formulate a problem of optimizing the DTDD switching point jointly with the UL and DL power control coefficients, and the large-scale fading decoding (LSFD) weights for EE maximization. Then, we propose an iterative algorithm to solve the formulated challenging problem using successive convex approximation with an approximate stationary solution. Simulation results show that optimizing switching points remarkably improves EE compared with baseline schemes that adjust switching points heuristically.

eess.SP↗

Reciprocity Calibration of Dual-Antenna Repeaters

We present a reciprocity calibration method for dual-antenna repeaters in wireless networks. The method uses bi-directional measurements between two network nodes, A and B, where for each bi-directional measurement, the repeaters are configured in different states. The nodes A and B could be two access points in a distributed MIMO system, or they could be a base station and a mobile user terminal, for example. From the calibration measurements, the differences between the repeaters' forward and reverse gains are estimated. The repeaters are then (re-)configured to compensate for these differences such that the repeaters appear, transparently to the network, as reciprocal components of the propagation environment, enabling reciprocity-based beamforming in the network.

eess.SP↗

Self-Learning Detector for the Cell-Free Massive MIMO Uplink: The Line-of-Sight Case

The precoding in cell-free massive multiple-input multiple-output (MIMO) technology relies on accurate knowledge of channel responses between users (UEs) and access points (APs). Obtaining high-quality channel estimates in turn requires the path losses between pairs of UEs and APs to be known. These path losses may change rapidly especially in line-of-sight environments with moving blocking objects. A difficulty in the estimation of path losses is pilot contamination, that is, simultaneously transmitted pilots from different UEs that may add up destructively or constructively by chance, seriously affecting the estimation quality (and hence the eventual performance). A method for estimation of path losses, along with an accompanying pilot transmission scheme, is proposed that works for both Rayleigh fading and line-of-sight channels and that significantly improves performance over baseline state-of-the-art. The salient feature of the pilot transmission scheme is that pilots are structurally phase-rotated over different coherence blocks (according to a pre-determined function known to all parties), in order to create an effective statistical distribution of the received pilot signal that can be efficiently exploited by the proposed estimation algorithm.

cs.IT↗

Scalability Aspects of Cell-Free Massive MIMO

Ubiquitous cell-free massive MIMO (multiple-input multiple-output) combines massive MIMO technology and user-centric transmission in a distributed architecture. All the access points (APs) in the network cooperate to jointly and coherently serve a smaller number of users in the same time-frequency resource. However, this coordination needs significant amounts of control signalling which introduces additional overhead, while data co-processing increases the back/front-haul requirements. Hence, the notion that the "whole world" could constitute one network, and that all APs would act as a single base station, is not scalable. In this study, we address some system scalability aspects of cell-free massive MIMO that have been neglected in literature until now. In particular, we propose and evaluate a solution related to data processing, network topology and power control. Results indicate that our proposed framework achieves full scalability at the cost of a modest performance loss compared to the canonical form of cell-free massive MIMO.

cs.IT↗

Downlink Training in Cell-Free Massive MIMO: A Blessing in Disguise

Cell-free Massive MIMO (multiple-input multiple-output) refers to a distributed Massive MIMO system where all the access points (APs) cooperate to coherently serve all the user equipments (UEs), suppress inter-cell interference and mitigate the multiuser interference. Recent works demonstrated that, unlike co-located Massive MIMO, the \textit{channel hardening} is, in general, less pronounced in cell-free Massive MIMO, thus there is much to benefit from estimating the downlink channel. In this study, we investigate the gain introduced by the downlink beamforming training, extending the previously proposed analysis to non-orthogonal uplink and downlink pilots. Assuming single-antenna APs, conjugate beamforming and independent Rayleigh fading channel, we derive a closed-form expression for the per-user achievable downlink rate that addresses channel estimation errors and pilot contamination both at the AP and UE side. The performance evaluation includes max-min fairness power control, greedy pilot assignment methods, and a comparison between achievable rates obtained from different capacity-bounding techniques. Numerical results show that downlink beamforming training, although increases pilot overhead and introduces additional pilot contamination, improves significantly the achievable downlink rate. Even for large number of APs, it is not fully efficient for the UE relying on the statistical channel state information for data decoding.

cs.IT↗

Ubiquitous Cell-Free Massive MIMO Communications

Since the first cellular networks were trialled in the 1970s, we have witnessed an incredible wireless revolution. From 1G to 4G, the massive traffic growth has been managed by a combination of wider bandwidths, refined radio interfaces, and network densification, namely increasing the number of antennas per site. Due its cost-efficiency, the latter has contributed the most. Massive MIMO (multiple-input multiple-output) is a key 5G technology that uses massive antenna arrays to provide a very high beamforming gain and spatially multiplexing of users, and hence, increases the spectral and energy efficiency. It constitutes a centralized solution to densify a network, and its performance is limited by the inter-cell interference inherent in its cell-centric design. Conversely, ubiquitous cell-free Massive MIMO refers to a distributed Massive MIMO system implementing coherent user-centric transmission to overcome the inter-cell interference limitation in cellular networks and provide additional macro-diversity. These features, combined with the system scalability inherent in the Massive MIMO design, distinguishes ubiquitous cell-free Massive MIMO from prior coordinated distributed wireless systems. In this article, we investigate the enormous potential of this promising technology while addressing practical deployment issues to deal with the increased back/front-hauling overhead deriving from the signal co-processing.

cs.IT↗

Utility-based Downlink Pilot Assignment in Cell-Free Massive MIMO

We propose a strategy for orthogonal downlink pilot assignment in cell-free massive MIMO (multiple-input multiple-output) that exploits knowledge of the channel state information, the channel hardening degree at each user, and the mobility conditions for the users. These elements, properly combined together, are used to define a user pilot utility metric, which measures the user's real need of a downlink pilot for efficient data decoding. The proposed strategy consists in assigning orthogonal downlink pilots only to the users having a pilot utility metric exceeding a predetermined threshold. Instead, users that are not assigned with an orthogonal downlink pilot decode the data by using the statistical channel state information. The utility-based approach guarantees higher downlink net sum throughput, better support both for high-speed users and shorter coherent intervals than prior art approaches.

cs.IT↗

On the Performance of Cell-Free Massive MIMO with Short-Term Power Constraints

In this paper we consider a time-division duplex cell-free massive multiple-input multiple-output (MIMO) system where many distributed access points (APs) simultaneously serve many users. A normalized conjugate beamforming scheme, which satisfies short-term average power constraints at the APs, is proposed and analyzed taking into account the effect of imperfect channel information. We derive an approximate closed-form expression for the per-user achievable downlink rate of this scheme. We also provide, analytically and numerically, a performance comparison between the normalized conjugate beamforming and the conventional conjugate beamforming scheme in [1] (which satisfies long-term average power constraints). Normalized conjugate beamforming scheme reduces the beamforming uncertainty gain, which comes from the users' lack of the channel state information knowledge, and hence, it improves the achievable downlink rate compared to the conventional conjugate beamforming scheme.

cs.IT↗

How Much Do Downlink Pilots Improve Cell-Free Massive MIMO?

In this paper, we analyze the benefits of including downlink pilots in a cell-free massive MIMO system. We derive an approximate per-user achievable downlink rate for conjugate beamforming processing, which takes into account both uplink and downlink channel estimation errors, and power control. A performance comparison is carried out, in terms of per-user net throughput, considering cell-free massive MIMO operation with and without downlink training, for different network densities. We take also into account the performance improvement provided by max-min fairness power control in the downlink. Numerical results show that, exploiting downlink pilots, the performance can be considerably improved in low density networks over the conventional scheme where the users rely on statistical channel knowledge only. In high density networks, performance improvements are moderate.

cs.IT↗