arXiv subjects

P. A. Cassak

Publications and source records attributed to P. A. Cassak.

32 records · Page 2Linked to original sources

arXiv2015

Fast Magnetic Reconnection Due to Anisotropic Electron Pressure

A new regime of fast magnetic reconnection with an out-of-plane (guide) magnetic field is reported in which the key role is played by an electron pressure anisotropy described by the Chew-Goldberger-Low gyrotropic equations of state in the generalized Ohm's law, which even dominates the Hall term. A description of the physical cause of this behavior is provided and two-dimensional fluid simulations are used to confirm the results. The electron pressure anisotropy causes the out-of-plane magnetic field to develop a quadrupole structure of opposite polarity to the Hall magnetic field and gives rise to dispersive waves. In addition to being important for understanding what causes reconnection to be fast, this mechanism should dominate in plasmas with low plasma beta and a high in-plane plasma beta with electron temperature comparable to or larger than ion temperature, so it could be relevant in the solar wind and some tokamaks.

physics.plasm-ph↗

arXiv2014

Electron Heating During Magnetic Reconnection: A Simulation Scaling Study

Electron bulk heating during magnetic reconnection with symmetric inflow conditions is examined using kinetic particle-in-cell (PIC) simulations. The degree of electron heating is well correlated with the inflowing Alfvén speed $c_{Ar}$ based on the reconnecting magnetic field through the relation $ΔT_e = 0.033 \,m_i\,c_{Ar}^2$, where $ΔT_{e}$ is the increase in electron temperature. For the range of simulations performed, the heating shows almost no correlation with inflow total temperature $T_{tot} = T_i + T_e$ or plasma $β$. An out-of-plane (guide) magnetic field of similar magnitude to the reconnecting field does not affect the total heating, but it does quench perpendicular heating, with almost all heating being in the parallel direction. These results are qualitatively consistent with a recent statistical survey of electron heating in the dayside magnetopause, which also found that $ΔT_e$ was proportional to the inflowing Alfvén speed. The net electron heating varies very little with distance downstream of the x-line. The simulations show at most a very weak dependence of electron heating on the ion to electron mass ratio. In the antiparallel reconnection case, the largely parallel heating is eventually isotropized downstream due a scattering mechanism such as stochastic particle motion or instabilities. The study highlights key properties that must be satisfied by an electron heating mechanism: (1) Preferential heating in the parallel direction; (2) Heating proportional to $m_i\,c_{Ar}^2$; (3) At most a weak dependence on electron mass; and (4) An exhaust electron temperature that varies little with distance from the x-line.

physics.plasm-ph↗

arXiv2014

On the 3-D structure and dissipation of reconnection-driven flow-bursts

The structure of magnetic reconnection-driven outflows and their dissipation are explored with large-scale, 3-D particle-in-cell (PIC) simulations. Outflow jets resulting from 3-D reconnection with a finite length x-line form fronts as they propagate into the downstream medium. A large pressure increase ahead of this ``reconnection jet front'' (RJF), due to reflected and transmitted ions, slows the front so that its velocity is well below the velocity of the ambient ions in the core of the jet. As a result, the RJF slows and diverts the high-speed flow into the direction perpendicular to the reconnection plane. The consequence is that the RJF acts as a thermalization site for the ion bulk flow and contributes significantly to the dissipation of magnetic energy during reconnection even though the outflow jet is subsonic. This behavior has no counterpart in 2-D reconnection. A simple analytic model predicts the front velocity and the fraction of the ion bulk flow energy that is dissipated.

physics.plasm-ph↗

arXiv2013

Tracing magnetic separators and their dependence on IMF clock angle in global magnetospheric simulations

A new, efficient, and highly accurate method for tracing magnetic separators in global magnetospheric simulations with arbitrary clock angle is presented. The technique is to begin at a magnetic null and iteratively march along the separator by finding where four magnetic topologies meet on a spherical surface. The technique is verified using exact solutions for separators resulting from an analytic magnetic field model that superposes dipolar and uniform magnetic fields. Global resistive magnetohydrodynamic simulations are performed using the three-dimensional BATS-R-US code with a uniform resistivity, in eight distinct simulations with interplanetary magnetic field (IMF) clock angles ranging from 0 (parallel) to 180 degrees (anti-parallel). Magnetic nulls and separators are found in the simulations, and it is shown that separators traced here are accurate for any clock angle, unlike the last closed field line on the Sun-Earth line that fails for southward IMF. Trends in magnetic null locations and the structure of magnetic separators as a function of clock angle are presented and compared with those from the analytic field model. There are many qualitative similarities between the two models, but quantitative differences are also noted. Dependence on solar wind density is briefly investigated.

physics.plasm-ph↗

arXiv2013

On the Cause of Supra-Arcade Downflows in Solar Flares

A model of supra-arcade downflows (SADs), dark low density regions also known as tadpoles that propagate sunward during solar flares, is presented. It is argued that the regions of low density are flow channels carved by sunward-directed outflow jets from reconnection. The solar corona is stratified, so the flare site is populated by a lower density plasma than that in the underlying arcade. As the jets penetrate the arcade, they carve out regions of depleted plasma density which appear as SADs. The present interpretation differs from previous models in that reconnection is localized in space but not in time. Reconnection is continuous in time to explain why SADs are not filled in from behind as they would if they were caused by isolated descending flux tubes or the wakes behind them due to temporally bursty reconnection. Reconnection is localized in space because outflow jets in standard two-dimensional reconnection models expand in the normal (inflow) direction with distance from the reconnection site, which would not produce thin SADs as seen in observations. On the contrary, outflow jets in spatially localized three-dimensional reconnection with an out-of-plane (guide) magnetic field expand primarily in the out-of-plane direction and remain collimated in the normal direction, which is consistent with observed SADs being thin. Two-dimensional proof-of-principle simulations of reconnection with an out-of-plane (guide) magnetic field confirm the creation of SAD-like depletion regions and the necessity of density stratification. Three-dimensional simulations confirm that localized reconnection remains collimated.

physics.space-ph↗

arXiv2012

Guide Field Dependence of 3D X-Line Spreading During Collisionless Magnetic Reconnection

Theoretical arguments and large-scale two-fluid simulations are used to study the spreading of reconnection X-lines localized in the direction of the current as a func- tion of the strength of the out-of-plane (guide) magnetic field. It is found that the mech- anism causing the spreading is different for weak and strong guide fields. In the weak guide field limit, spreading is due to the motion of the current carriers, as has been pre- viously established. However, spreading for strong guide fields is bi-directional and is due to the excitation of Alfvén waves along the guide field. In general, we suggest that the X-line spreads bi-directionally with a speed governed by the faster of the two mecha- nisms for each direction. A prediction on the strength of the guide field at which the spread- ing mechanism changes is formulated and verified with three-dimensional simulations. Solar, magnetospheric, and laboratory applications are discussed.

physics.plasm-ph↗

arXiv2011

Estimates of Densities and Filling Factors from a Cooling Time Analysis of Solar Microflares Observed with RHESSI

We use more than 4,500 microflares from the Reuven Ramaty High Energy Solar Spectroscopic Imager (RHESSI) microflare data set (Christe et al., 2008, Ap. J., 677, 1385) to estimate electron densities and volumetric filling factors of microflare loops using a cooling time analysis. We show that if the filling factor is assumed to be unity, the calculated conductive cooling times are much shorter than the observed flare decay times, which in turn are much shorter than the calculated radiative cooling times. This is likely unphysical, but the contradic- tion can be resolved by assuming the radiative and conductive cooling times are comparable, which is valid when the flare loop temperature is a maximum and when external heating can be ignored. We find that resultant radiative and con- ductive cooling times are comparable to observed decay times, which has been used as an assumption in some previous studies. The inferred electron densities have a mean value of 10^11.6 cm^-3 and filling factors have a mean of 10^-3.7. The filling factors are lower and densities are higher than previous estimates for large flares, but are similar to those found for two microflares by Moore et al. (Ap. J., 526, 505, 1999).

astro-ph.SR↗

arXiv2010

Three-dimensional simulations of the orientation and structure of reconnection X-lines

This work employs Hall magnetohydrodynamic (MHD) simulations to study the X-lines formed during the reconnection of magnetic fields with differing strengths and orientations embedded in plasmas of differing densities. Although random initial perturbations trigger the growth of X-lines with many orientations, at late time a few robust X-lines sharing an orientation reasonably consistent with the direction that maximizes the outflow speed, as predicted by Swisdak and Drake [Geophys. Res. Lett., 34, L11106, (2007)], dominate the system. The existence of reconnection in the geometry examined here contradicts the suggestion of Sonnerup [J. Geophys. Res., 79, 1546 (1974)] that reconnection occurs in a plane normal to the equilibrium current. At late time the growth of the X-lines stagnates, leaving them shorter than the simulation domain.

physics.plasm-ph↗

arXiv2010

Comparison of secondary islands in collisional reconnection to Hall reconnection

Large-scale resistive Hall-magnetohydrodynamic (Hall-MHD) simulations of the transition from Sweet-Parker (collisional) to Hall (collisionless) magnetic reconnection are presented, the first to separate effects of secondary islands from collisionless effects. Three main results are described. There exists a regime in which secondary islands occur without collisionless effects when the thickness of the dissipation regions exceed ion gyroscales. The reconnection rate with secondary islands is faster than Sweet-Parker but significantly slower than Hall reconnection. This implies that secondary islands are not the cause of the fastest reconnection rates. Because Hall reconnection is much faster, its onset causes the ejection of secondary islands from the vicinity of the X-line. These results imply that most of the energy release occurs during Hall reconnection. Coronal applications are discussed.

physics.plasm-ph↗

arXiv2009

Magnetic Reconnection with Asymmetry in the Outflow Direction

Magnetic reconnection with asymmetry in the outflow direction occurs in the Earth's magnetotail, coronal mass ejections, flux cancellation events, astrophysical disks, spheromak merging experiments, and elsewhere in nature and the laboratory. A control volume analysis is performed for the case of steady antiparallel magnetic reconnection with asymmetric downstream pressure, which is used to derive scaling relations for the outflow velocity from each side of the current sheet and the reconnection rate. Simple relationships for outflow velocity are presented for the incompressible case and the case of symmetric downstream pressure but asymmetric downstream density. Asymmetry alone is not found to greatly affect the reconnection rate. The flow stagnation point and magnetic field null do not coincide in a steady state unless the pressure gradient is negligible at the flow stagnation point.

physics.plasm-ph↗

arXiv2008

Kinetic dissipation and anisotropic heating in a turbulent collisionless plasma

The kinetic evolution of the Orszag-Tang vortex is studied using collisionless hybrid simulations. In the magnetohydrodynamic regime this vortex leads rapidly to broadband turbulence. Significant differences from MHD arise at small scales, where the fluid scale energy dissipates into heat almost exclusively through the magnetic field because the protons are decoupled from the magnetic field. Although cyclotron resonance is absent, the protons heat preferentially in the plane perpendicular to the mean field, as in the corona and solar wind. Effective transport coefficients are calculated.

physics.plasm-ph↗

arXiv2008

From Solar and Stellar Flares to Coronal Heating: Theory and Observations of How Magnetic Reconnection Regulates Coronal Conditions

There is currently no explanation of why the corona has the temperature and density it has. We present a model which explains how the dynamics of magnetic reconnection regulates the conditions in the corona. A bifurcation in magnetic reconnection at a critical state enforces an upper bound on the coronal temperature for a given density. We present observational evidence from 107 flares in 37 sun-like stars that stellar coronae are near this critical state. The model may be important to self-organized criticality models of the solar corona.

astro-ph↗

arXiv2006

A Model for Spontaneous Onset of Fast Magnetic Reconnection

We present a model for the spontaneous onset of fast magnetic reconnection in a weakly collisional plasma, such as the solar corona. When a current layer of macroscopic width undergoes collisional (Sweet-Parker) reconnection, a narrow dissipation region forms around the X-line. This dissipation region naturally becomes narrower during the reconnection process as stronger magnetic fields are convected toward the X-line. When the dissipation region becomes thinner than the ion skin depth, resistive magnetohydrodynamics breaks down as the Hall effect becomes important and the Sweet-Parker solution ceases to exist. A transition to collisionless (Hall) reconnection ensues, increasing the reconnection rate by many orders of magnitude in a very short time. Predictions of the model are consistent with constraints set by observations of solar flares.

physics.plasm-ph↗

arXiv2005

A catastrophe model for fast magnetic reconnection onset

A catastrophe model for the onset of fast magnetic reconnection is presented that suggests why plasma systems with magnetic free energy remain apparently stable for long times and then suddenly release their energy. For a given set of plasma parameters there are generally two stable reconnection solutions: a slow (Sweet-Parker) solution and a fast (Alfvénic) Hall reconnection solution. Below a critical resistivity the slow solution disappears and fast reconnection dominates. Scaling arguments predicting the two solutions and the critical resistivity are confirmed with two-fluid simulations.

physics.plasm-ph↗