SearcharxivSearch

arXiv subjects

P. Bougiatioti

Publications and source records attributed to P. Bougiatioti.

4 recordsLinked to original sources

Simultaneous mapping of the ultrafast time and fluence dependence of the laser-induced insulator-to-metal transition in magnetite

Pump-probe methods are a ubiquitous tool in the field of ultrafast dynamic measurements. In recent years, x-ray free-electron laser experiments have gained importance due to their ability to probe with high chemical selectivity and at atomic length scales. Measurements are typically repeated many thousands of times to collect sufficient statistics and vary parameters like delay or fluence, necessitating that initial conditions are restored each time. An alternative is presented by experiments which measure the relevant parameters in a single shot. Here, we present a time-to-space mapping imaging scheme that enables us to record a range of delays and laser fluences in any single shot of the x-ray probe. We demonstrate the use of this scheme by mapping the ultrafast dynamics of the optically induced insulator-to-metal Verwey transition in a magnetite thin film, probed by soft x-ray resonant diffraction. By extrapolating our results toward the conditions found at x-ray free-electron lasers with higher photon energy, we demonstrate that the presented data could be recorded in a single shot.

cond-mat.mtrl-sci

Enhancement in Thermally Generated Spin Voltage at Pd/NiFe$_2$O$_4$ Interfaces by the Growth on Lattice-Matched Substrates

Efficient spin injection from epitaxial ferrimagnetic NiFe$_2$O$_4$ thin films into a Pd layer is demonstrated via spin Seebeck effect measurements in the longitudinal geometry. The NiFe$_2$O$_4$ films (60 nm to 1 $μ$m) are grown by pulsed laser deposition on isostructural spinel MgAl$_2$O$_4$, MgGa$_2$O$_4$, and CoGa$_2$O$_4$ substrates with lattice mismatch varying between 3.2% and 0.2%. For the thinner films ($\leq$ 330 nm), an increase in the spin Seebeck voltage is observed with decreasing lattice mismatch, which correlates well with a decrease in the Gilbert damping parameter as determined from ferromagnetic resonance measurements. High resolution transmission electron microscopy studies indicate substantial decrease of antiphase boundary and interface defects that cause strain-relaxation, i.e., misfit dislocations, in the films with decreasing lattice mismatch. This highlights the importance of reducing structural defects in spinel ferrites for efficient spin injection. It is further shown that angle-dependent spin Seebeck effect measurements provide a qualitative method to probe for in-plane magnetic anisotropies present in the films.

cond-mat.mtrl-sci

Longitudinal spin Seebeck coefficient: heat flux vs. temperature difference method

The determination of the longitudinal spin Seebeck effect (LSSE) coefficient is currently plagued by a large uncertainty due to the poor reproducibility of the experimental conditions used in its measurement. In this work we present a detailed analysis of two different methods used for the determination of the LSSE coefficient. We have performed LSSE experiments in different laboratories, by using different setups and employing both the temperature difference method and the heat flux method. We found that the lack of reproducibility can be mainly attributed to the thermal contact resistance between the sample and the thermal baths which generate the temperature gradient. Due to the variation of the thermal resistance, we found that the scaling of the LSSE voltage to the heat flux through the sample rather than to the temperature difference across the sample greatly reduces the uncertainty. The characteristics of a single YIG/Pt LSSE device obtained with two different setups was $(1.143\pm0.007)\cdot 10^{-7}$ Vm/W and $(1.101\pm0.015)\cdot 10^{-7}$ Vm/W with the heat flux method and $(2.313\pm0.017)\cdot 10^{-7}$ V/K and $(4.956\pm0.005)\cdot 10^{-7}$ V/K with the temperature difference method. This shows that systematic errors can be considerably reduced with the heat flux method.

cond-mat.mes-hall

Nonlocal magnon spin transport in NiFe$_2$O$_4$ thin films

We report magnon spin transport in nickel ferrite (NiFe$_2$O$_4$, NFO)/ platinum (Pt) bilayer systems at room temperature. A nonlocal geometry is employed, where the magnons are excited by the spin Hall effect or by the Joule heating induced spin Seebeck effect at the Pt injector, and detected at a certain distance away by the inverse spin Hall effect at the Pt detector. The dependence of the nonlocal magnon spin signals as a function of the magnetic field is closely related to the NFO magnetization behavior. In contrast, we observe that the magnetoresistance measured locally at the Pt injector does not show a clear relation with the average NFO magnetization. We estimate the magnon spin relaxation length to be 3.1 $\pm$ 0.2 $μ$m in the investigated NFO samples.

cond-mat.mtrl-sci