SearcharxivSearch

arXiv subjects

P. Brunet

Publications and source records attributed to P. Brunet.

11 recordsLinked to original sources

Scratch-induced surface microstructures on the deformed surface of Al-Cu-Fe icosahedral quasicrystals

Scanning electron microscopy (SEM) and transmission electron microscopy (TEM) investigations of sintered Al-Cu-Fe icosahedral quasicrystal (IQC) have been carried out to understand the origin of some ductility previously noticed within tracks produced by standard tribological scratch tests. Transformation of the icosahedral phase to a modulated structure is shown and a transformation of the IQC to a bcc phase has been found beneath the tracks. Twins and dislocations have also been observed.

cond-mat.mtrl-sci

Electron microscopy study of scratch-induced surface microstructures in an Al-Cu-Fe icosahedral quasicrystal

Microstructure modifications induced by sliding a WC-Co indenter in scratch tests on the surface of a single phase AlCuFe icosahedral quasicrystal (IQC) was studied by scanning electron microscopy (SEM) and transmission electron microscopy (TEM). The scratch track was shown tocomprise many smaller tracks. Dislocations were discovered to emerge from the edges of the smaller scratch tracks. Along a small track where shear stress is concentrated, a phase transition from IQC to a body-centered cubic (b.c.c.) phase with lattice parameter a=0.29 nm was pointed out. A modulated quasicrystal state as well as a deformation twin of IQC were determined in the region beneath the scratch.

cond-mat.mtrl-sci

Characterization of microwave absorption in carbon nanotubes using resonance aperture transmission method

A new method to characterize microwave electromagnetic absorption of a bulk carbon nanotube material is proposed and experimentally evaluated in this paper. The method is based on the measurement of microwave transmission through a capacitive-resonator aperture in a conductive screen loaded with a CNT sample under test. This method allows to measure microwave permittivity and absorption of thin samples, several atomic layers to few micrometers thick, with linear dimensions much smaller than the wavelength of radiation in free space. This minimal sample requirement restricts the application of conventional microwave characterization methods such as free-space or waveguide permittivity characterization. It is demonstrated that the resonance E-field enhancement inside the CRA leads to strong EM interaction of the microwave E-field with the CNT sample under test thus enabling high sensitivity and dynamic range of the measurement procedure. Another advantage of the proposed technique over conventional non-resonance characterization methods is that in the resonance transmission band, the CRA operation is reflection-less which leads to a relatively simple qualitative algebraic de-embedding procedure of the material parameters based on the principle of energy conservation. The experimental microwave absorption data of the multiwall CNT samples are presented in the S frequency band (2-4GHz), demonstrating microwave absorption properties of the multiwall CNT ribbons.

physics.app-ph

Droplets displacement and oscillations induced by ultrasonic surface acoustic waves: a quantitative study

We present an experimental study of a droplet interacting with an ultrasonic surface acoustic wave (SAW). Depending on the amplitude of the wave, the drop can either experience an internal flow with its contact-line pinned, or (at higher amplitude) move along the direction of the wave also with internal flow. Both situations appear together with oscillations of the drop free-surface. The physical origins of the internal mixing flow as well as the drop displacement and surface waves are still not well understood. In order to give insights of the underlying physics involved in these phenomena, we carried out an experimental and numerical study. The results suggest that the surface deformation of the drop can be related as a combination between acoustic streaming effect and radiation pressure inside the drop.

physics.flu-dyn

To grate a liquid into tiny droplets by its impact on a hydrophobic micro-grid

We report on experiments of drop impacting a hydrophobic micro-grid, of typical spacing a few tens of $\mu$m. Above a threshold in impact speed, liquid emerges to the other side, forming micro-droplets of size about that of the grid holes. We propose a method to produce either a mono-disperse spray or a single tiny droplet of volume as small as a few picoliters corresponding to a volume division of the liquid drop by a factor of up to 10$^5$. We also discuss the discrepancy of the measured thresholds with that predicted by a balance between inertia and capillarity.

physics.flu-dyn

Vibration-induced climbing of drops

We report an experimental study of liquid drops moving against gravity, when placed on a vertically vibrating inclined plate, which is partially wetted by the drop. The frequency of vibrations ranges from 30 to 200 Hz, and, above a threshold in vibration acceleration, drops experience an upward motion. We attribute this surprising motion to the deformations of the drop, as a consequence of an up or down symmetry breaking induced by the presence of the substrate. We relate the direction of motion to contact angle measurements. This phenomenon can be used to move a drop along an arbitrary path in a plane, without special surface treatments or localized forcing.

physics.flu-dyn

Stabilized Kuramoto-Sivashinsky equation: A useful model for secondary instabilities and related dynamics of experimental one-dimensional cellular flows

We report numerical simulations of one-dimensional cellular solutions of the stabilized Kuramoto-Sivashinsky equation. This equation offers a range of generic behavior in pattern-forming instabilities of moving interfaces, such as a host of secondary instabilities or transition toward disorder. We compare some of these collective behaviors to those observed in experiments. In particular, destabilization scenarios of bifurcated states are studied in a spatially semi-extended situation, which is common in realistic patterns, but has been barely explored so far.

nlin.PS

Extreme resistance of super-hydrophobic surfaces to impalement: reversible electrowetting related to the impacting/bouncing drop test

The paper reports on the comparison of the wetting properties of super-hydrophobic silicon nanowires (NWs), using drop impact impalement and electrowetting (EW) experiments. A correlation between the resistance to impalement on both EW and drop impact is shown. From the results, it is evident that when increasing the length and density of NWs: (i) the thresholds for drop impact and EW irreversibility increase (ii) the contact-angle hysteresis after impalement decreases. This suggests that the structure of the NWs network could allow for partial impalement, hence preserving the reversibility, and that EW acts the same way as an external pressure. The most robust of our surfaces show a threshold to impalement higher than 35 kPa, while most of the super-hydrophobic surfaces tested so far have impalement threshold smaller than 10 kPa.

cond-mat.soft

Sensitivity of the stress response function to packing preparation

A granular assembly composed of a collection of identical grains may pack under different microscopic configurations with microscopic features that are sensitive to the preparation history. A given configuration may also change in response to external actions such as compression, shearing etc. We show using a mechanical response function method developed experimentally and numerically, that the macroscopic stress profiles are strongly dependent on these preparation procedures. These results were obtained for both two and three dimensions. The method reveals that, under a given preparation history, the macroscopic symmetries of the granular material is affected and in most cases significant departures from isotropy should be observed. This suggests a new path toward a non-intrusive test of granular material constitutive properties.

cond-mat.soft

From the stress response function (back) to the sandpile `dip'

We relate the pressure `dip' observed at the bottom of a sandpile prepared by successive avalanches to the stress profile obtained on sheared granular layers in response to a localized vertical overload. We show that, within a simple anisotropic elastic analysis, the skewness and the tilt of the response profile caused by shearing provide a qualitative agreement with the sandpile dip effect. We conclude that the texture anisotropy produced by the avalanches is in essence similar to that induced by a simple shearing -- albeit tilted by the angle of repose of the pile. This work also shows that this response function technique could be very well adapted to probe the texture of static granular packing.

cond-mat.soft

Propagative waves pattern in a falling liquid curtain

We have preformed experiments on a liquid curtain falling from a horizontal, wetted, tube and lateraly constrained by two vertical wires. The fluid motion nearly reduces to a free-fall, with a very low detachment velocity below the tube. Thus, the curtain contains a large subsonic area, i.e. a domain where the sinuous waves travel faster than the fluid. The upper boundary not being constrained in the transverse direction, we have observed the appearance of an up to now unreported instability when the flow rate is progressively reduced: the top of the curtain enters a pendulum-like motion, coupled to a propagative pattern of curtain undulations, structured as a chessboard. Measurements of the phase velocity and frequency of this pattern are reported. Data are in agreement with a simple dimensional argument suggesting that the wave velocity is proportional to the surface tension divided by the mass flux of liquid per unit length. This scaling is also that followed by the fluid velocity at the transonic point, i.e. the point where the fluid velocity equals that of sinuous waves. We finally discuss implications of these results on the global stability of falling curtains.

physics.flu-dyn