SearcharxivSearch

arXiv subjects

P. D. Smith

Publications and source records attributed to P. D. Smith.

7 recordsLinked to original sources

Methods for Measuring the Cosmic-Ray Proton Spectrum With the Fermi LAT

The Fermi Gamma-Ray Space Telescope was launched in June 2008 and the onboard Large Area Telescope (LAT) has been collecting data since August of that same year. The LAT is currently being used to study a wide range of science topics in high-energy astrophysics, one of which is the study of high-energy cosmic rays. The LAT has recently demonstrated its ability to measure cosmic-ray electrons, and the Fermi LAT Collaboration has published a measurement of the high-energy cosmic-ray electron spectrum in the 20 GeV to 1 TeV energy range. Some methods for performing a similar analysis to measure the cosmic-ray proton spectrum using the LAT will be presented with emphasis on unfolding the reconstructed proton energy.

astro-ph.HE

Prospects for Measuring the Cosmic-Ray Proton Spectrum Using the LAT Instrument on the Fermi Gamma-Ray Space Telescope

The Fermi Gamma-Ray Space Telescope was launched in June 2008 and the onboard Large Area Telescope (LAT) has been collecting data since August of that same year. The LAT is currently being used to study a wide range of science topics in high-energy astrophysics, one of which is the study of high-energy cosmic rays. The LAT has recently demonstrated its ability to measure cosmic-ray electrons, and the Fermi LAT Collaboration has published a measurement of the high-energy cosmic-ray electron spectrum in the 20 GeV to 1 TeV energy range. This talk will discuss the prospects for using the LAT to perform a similar analysis to measure cosmic-ray proton events. The instrument response for cosmic-ray protons will be characterized and an assessment of the potential to measure the cosmic-ray proton energy spectrum will be presented.

astro-ph.HE

Prospects for GRB Science with the Fermi Large Area Telescope

The LAT instrument on the Fermi mission will reveal the rich spectral and temporal gamma-ray burst phenomena in the > 100 MeV band. The synergy with Fermi's GBM detectors will link these observations to those in the well explored 10-1000 keV range; the addition of the > 100 MeV band observations will resolve theoretical uncertainties about burst emission in both the prompt and afterglow phases. Trigger algorithms will be applied to the LAT data both onboard the spacecraft and on the ground. The sensitivity of these triggers will differ because of the available computing resources onboard and on the ground. Here we present the LAT's burst detection methodologies and the instrument's GRB capabilities.

astro-ph.HE

Pre-launch estimates for GLAST sensitivity to Dark Matter annihilation signals

We investigate the sensitivity of the Gamma-ray Large Area Space Telescope (GLAST) to indirectly detect weakly interacting massive particles (WIMPs) through the $γ$-ray signal that their pair annihilation produces. WIMPs are among the favorite candidates to explain the compelling evidence that about 80% of the mass in the Universe is non-baryonic dark matter (DM). They are serendipitously motivated by various extensions of the standard model of particle physics such as Supersymmetry and Universal Extra Dimensions (UED). With its unprecedented sensitivity and its very large energy range (20 MeV to more than 300 GeV) the main instrument on board the GLAST satellite, the Large Area Telescope (LAT), will open a new window of discovery. As our estimates show, the LAT will be able to detect an indirect DM signature for a large class of WIMP models given a cuspy profile for the DM distribution. Using the current state of the art Monte Carlo and event reconstruction software developed within the LAT collaboration, we present preliminary sensitivity studies for several possible sources inside and outside the Galaxy. We also discuss the potential of the LAT to detect UED via the electron/positron channel. Diffuse background modeling and other background issues that will be important in setting limits or seeing a signal are presented.

astro-ph

Chromospheric magnetic reconnection: Two-fluid simulations of coalescing current loops

Aims: To investigate magnetic reconnection rates during the coalescence of two current loops in the solar chromosphere, by altering the neutral-hydrogen to proton density ratio, ioniziation/recombination coefficients, collision frequency and relative helicity of the loops. Methods: 2.5D numerical simulations of the chromosphere were conducted using a newly developed two-fluid (ion-neutral) numerical code. Developed from the Artificial Wind scheme, the numerical code includes the effects of ion-neutral collisions, ionization/recombination, thermal/resistive diffusivity and collisional/resistive heating. Results: It was found that the rates of magnetic reconnection strongly depend on the neutral-hydrogen to proton density ratio; increasing the density ratio by a thousand-fold decreased the rate of magnetic reconnection by twenty-fold. This result implies that magnetic reconnection proceeds significantly faster in the upper chromosphere, where the density of ions (protons) and neutral-hydrogen is comparable, than in the lower chromosphere where the density of neutral-hydrogen is over a thousand times the ion density. The inclusion of ionization/recombination, an important physics effect in the chromosphere, increases the total reconnected magnetic flux, but does not alter the rate of magnetic reconnection. Reductions in the ion-neutral collision frequency, result in small increases to the rates of magnetic reconnection. The relative helicity of the two current loops was not observed to have any significant effect on the rates of magnetic reconnection. Conclusions: The magnetic reconnection rates of coalescing current loops are strongly affected by the inclusion of neutral-hydrogen particles.

astro-ph

Enhanced phase mixing of Alfvén waves propagating in stratified and divergent coronal structures

Corrected analytical solutions describing the enhanced phase mixing of Alfven waves propagating in divergent stratified coronal structures are presented. These show that the enhanced phase mixing mechanism can dissipate Alfven waves at heights less than half that is predicted by the previous analytical solutions. The enhanced phase mixing of 0.1 Hz harmonic Alfven waves propagating in strongly divergent, H_b=5 Mm, stratified coronal structures, H_rho=50 Mm, can fulfill 100% of an active region heating requirement, by generating viscous heating fluxes of F_H~2100 J /m^2 /s. The Alfven waves in this configuration are fully dissipated within 20 Mm, which is six times lower than would occur as a result of standard phase mixing in uniform magnetic fields. This results in the heating scale height, s_H, being lowered by a factor of six, to less than half of an active regions density scale height. Using the corrected analytical solutions it was found that, for a given wave frequency, the generation of a heating scale height of s_H<=50 Mm, by enhanced phase mixing in strongly divergent magnetic fields, requires a shear viscosity eight orders of magnitude lower, than required by standard phase mixing in uniform magnetic fields. It was also found that the enhanced phase mixing of observable, 0.01 rads /s Alfven waves, in strongly divergent magnetic fields, H_b=5 Mm, can generate heating scale heights within a density scale height, H_rho=50 Mm, using classical Braginskii viscosity. It is therefore not necessary to invoke anomalous viscosity in corona, if phase mixing takes place in strongly divergent magnetic fields. This study shows that the importance of enhanced phase mixing as a mechanism for dissipating Alfven waves in the solar corona (a stratified and divergent medium), has been seriously underestimated.

astro-ph

Studies of Coupled Cavity Linac (CCL) Accelerating Structures with 3-D Codes

The cw CCL being designed for the Accelerator Production of Tritium (APT) project accelerates protons from 96MeV to 211MeV. It consists of 99 segments each containing up to seven accelerating cavities. Segments are coupled by intersegment coupling cavities and grouped into supermodules. The design method needs to address not only basic cavity sizing for a given coupling and pi/2 mode frequency, but also the effects of high power densities on the cavity frequency, mechanical stresses, and the structure's stop band during operation. On the APT project, 3-D RF (Ansoft Corp.'s HFSS) and coupled RF/structural (Ansys Inc.'s ANSYS) codes are being used to develop tools to address the above issues and guide cooling channel design. The code's predictions are being checked against available low power Aluminum models. Stop band behavior under power will be checked once the tools are extended to CCDTL structures that have been tested at high power. A summary of calculations made to date and agreement with measured results will be presented.

physics.acc-ph