arXiv subjects

P. Schoessow

Publications and source records attributed to P. Schoessow.

4 recordsLinked to original sources

arXiv2013

Experimental Demonstration of Energy Chirp Compensation by a Tunable Dielectric Based Structure

A 60 MeV beam at the BNL Accelerator Test Facility (ATF) was manipulated by a planar tunable de-chirper made out of two 10 cm long dielectric slabs with copper plated backs. While the gap was changed from 5.8 mm to 1 mm, the correlated energy chirp of the low charge electron bunch was reduced from approximately 330 keV/mm to zero. This result is in agreement with simulations. Calculations show that similar devices, properly scaled to account for the expected electron bunch charge and length, can be used to remove residual correlated energy spread at the end of the linacs used for free-electron lasers (FEL). Potentially, this technique could significantly simplify linac design and improve FEL performance.

physics.acc-ph↗

arXiv2012

Experimental Observation of Energy Modulation in Electron Beams Passing Through Terahertz Dielectric Wakefield Structures

We report observation of a strong wakefield induced energy modulation in an energy-chirped electron bunch passing through a dielectric-lined waveguide. This modulation can be effectively converted into a spatial modulation forming micro-bunches with a periodicity of 0.5 - 1 picosecond, hence capable of driving coherent THz radiation. The experimental results agree well with theoretical predictions.

physics.acc-ph↗

arXiv2007

Observation of Enhanced Transformer Ratio in Collinear Wakefield Acceleration

One approach to future high energy particle accelerators is based on the wakefield principle: a leading high-charge drive bunch is used to excite fields in an accelerating structure or plasma that in turn accelerates a trailing low-charge witness bunch. The transformer ratio R is defined as the ratio of the maximum energy gain of the witness bunch to the maximum energy loss of the drive bunch. In general, for configurations in which the two beams traverse the accelerator along the same trajectory (collinear wakefield acceleration). A number of techniques have been proposed to overcome the transformer ratio limitation. We report here the first experimental study of the ramped bunch train (RBT) technique in which a dielectric loaded waveguide was used as the accelerating structure. A single drive bunch was replaced by two bunches with charge ratio of 1:2.5 and a separation of 10.5 wavelengths of the fundamental mode. An average measured transformer ratio enhancement by a factor of 1.31 over the single drive bunch case was obtained in this experiment.

physics.acc-ph↗

arXiv2006

Fast Switching Ferroelectric Materials for Accelerator Applications

Fast switching (< 10 nsec) measurement results on the recently developed BST(M) (barium strontium titanium oxide composition with magnesium-based additions) ferroelectric materials are presented. These materials can be used as the basis for new advanced technology components suitable for high-gradient accelerators. A ferroelectric ceramic has an electric field-dependent dielectric permittivity that can be altered by applying a bias voltage. Ferroelectric materials offer significant benefits for linear collider applications, in particular, for switching and control elements where a very short response time of <10 nsec is required. The measurement results presented here show that the new BST(M) ceramic exhibits a high tunability factor: a bias field of 40-50 kV/cm reduces the permittivity by a factor of 1.3-1.5. The recently developed technology of gold biasing contact deposition on large diameter (110 cm) thin wall ferroelectric rings allowed ~few nsec switching times in witness sample experiments. The ferroelectric rings can be used at high pulsed power (tens of megawatts) for X-band components as well as at high average power in the range of a few kilowatts for the L-band phase-shifter, under development for optimization of the ILC rf coupling. Accelerator applications include fast active X-band and Ka-band high-power ferroelectric switches, high-power X-band and L-band phase shifters, and tunable dielectric-loaded accelerating structures.

physics.acc-ph↗