arXiv subjects

P. Studerus

Publications and source records attributed to P. Studerus.

9 recordsLinked to original sources

arXiv2010

Quantum capacitance and density of states of graphene

We report on measurements of the quantum capacitance in graphene as a function of charge carrier density. A resonant LC-circuit giving high sensitivity to small capacitance changes is employed. The density of states, which is directly proportional to the quantum capacitance, is found to be significantly larger than zero at and around the charge neutrality point. This finding is interpreted to be a result of potential fluctuations with amplitudes of the order of 100 meV in good agreement with scanning single-electron transistor measurements on bulk graphene and transport studies on nanoribbons.

cond-mat.mes-hall↗

arXiv2006

Counting statistics and super-Poissonian noise in a quantum dot

We present time-resolved measurements of electron transport through a quantum dot. The measurements were performed using a nearby quantum point contact as a charge detector. The rates for tunneling through the two barriers connecting the dot to source and drain contacts could be determined individually. In the high bias regime, the method was used to probe excited states of the dot. Furthermore, we have detected bunching of electrons, leading to super-Poissonian noise. We have used the framework of the full counting statistics (FCS) to model the experimental data. The existence of super-Poissonian noise suggests a long relaxation time for the involved excited state, which could be related to the spin relaxation time.

cond-mat.mes-hall↗

arXiv2006

Counting statistics of single-electron transport in a quantum dot

We have measured the full counting statistics (FCS) of current fluctuations in a semiconductor quantum dot (QD) by real-time detection of single electron tunneling with a quantum point contact (QPC). This method gives direct access to the distribution function of current fluctuations. Suppression of the second moment (related to the shot noise) and the third moment (related to the asymmetry of the distribution) in a tunable semiconductor QD is demonstrated experimentally. With this method we demonstrate the ability to measure very low current and noise levels.

cond-mat.mes-hall↗

arXiv2006

Design of Q-Band loop-gap resonators at frequencies 34-36 GHz for single electron spin spectroscopy in semiconductor nanostructures

We report on the design of loop-gap resonators (LGR) operating in the frequency range 34-36 GHz with the goal to achieve single electron spin resonance (ESR) in quantum dot nanostructures. We present a comprehensive study of the magnetic field strength and the spatial distribution of the electric and magnetic fields in the resonator by means of experiments and numerical simulations.

cond-mat.mes-hall↗

arXiv2006

Local oxidation of Ga[Al]As heterostructures with modulated tip-sample voltages

Nanolithography based on local oxidation with a scanning force microscope has been performed on an undoped GaAs wafer and a Ga[Al]As heterostructure with an undoped GaAs cap layer and a shallow two-dimensional electron gas. The oxide growth and the resulting electronic properties of the patterned structures are compared for constant and modulated voltage applied to the conductive tip of the scanning force microscope. All the lithography has been performed in non-contact mode. Modulating the applied voltage enhances the aspect ratio of the oxide lines, which significantly strengthens the insulating properties of the lines on GaAs. In addition, the oxidation process is found to be more reliable and reproducible. Using this technique, a quantum point contact and a quantum wire have been defined and the electronic stability, the confinement potential and the electrical tunability are demonstrated to be similar to the oxidation with constant voltage.

cond-mat.mes-hall↗

arXiv2001

Operating a phase-locked loop controlling a high-Q tuning fork sensor for scanning force microscopy

The implementation of a tuning fork sensor in a scanning force microscope operational at 300 mK is described and the harmonic oscillator model of the sensor is motivated. These sensors exhibit very high quality factors at low temperatures. The nested feedback comprising the sensor, a phase locked loop and a conventional $z$-feedback is analyzed in terms of linear control theory and the dominant noise source of the system is identified. It is shown that the nested feedback has a low pass response and that the optimum feedback parameters for the phase-locked loop and the $z$-feedback can be determined from the knowledge of the tuning fork resonance alone regardless of the tip shape. The advantages of this system compared to pure phase control are discussed.

cond-mat.mes-hall↗

arXiv2000

Force-distance studies with piezoelectric tuning forks below 4.2 K

Piezoelectric quartz tuning forks have been employed as the force sensor in a dynamic mode scanning force microscope operating at temperatures down to 1.7 K at He-gas pressures of typically 5 mbar. An electrochemically etched tungsten tip glued to one of the tuning fork prongs acts as the local force sensor. Its oscillation amplitude can be tuned between a few angstroms and tens of nanometers. Quality factors of up to 120000 allow a very accurate measurement of small frequency shifts. Three calibration procedures are compared which allow the determination of the proportionality constant between frequency shift and local force gradient based on the harmonic oscillator model and on electrostatic forces. The calibrated sensor is then used for a study of the interaction between the tip and a HOPG substrate. Force gradient and dissipated power can be recorded simultane-ously. It is found that during approaching the tip to the sample considerable power starts to be dissipated although the force gradient is still negative, i.e. the tip is still in the attractive regime. This observation concurs with experiments with true atomic resolution which seem to require the same tip-sample separation.

cond-mat↗

arXiv2000

Operation characteristics of piezoelectric quartz tuning forks in high magnetic fields at liquid helium temperatures

Piezoelectric quartz tuning forks are investigated in view of their use as force sensors in dynamic mode scanning probe microscopy at temperatures down to 1.5 K and in magnetic fields up to 8 T. The mechanical properties of the forks are extracted from the frequency dependent admittance and simultaneous interferometric measurements. The performance of the forks in a cryogenic environment is investigated. Force-distance studies performed with these sensors at low temperatures are presented.

cond-mat↗

arXiv1999

A low-temperature dynamic mode scanning force microscope operating in high magnetic fields

A scanning force microscope was implemented operating at temperatures below 4.2K and in magnetic fields up to 8T. Piezoelectric quartz tuning forks were employed for non optical tip-sample distance control in the dynamic operation mode. Fast response was achieved by using a phase-locked loop for driving the mechanical oscillator. Possible applications of this setup for various scanning probe techniques are discussed.

cond-mat↗