arXiv subjects

Paolo Rosi

Publications and source records attributed to Paolo Rosi.

8 recordsLinked to original sources

arXiv2026

Transverse quantum-state characterization of programmable electron optics

Programmable electron optics -- electronically controlled phase plates -- underpin proposals from dose-efficient phase imaging to shaped-electron X-ray sources, nearly all assuming a pure, fully coherent delivered wave whose purity has never been measured. Here we reconstruct the transverse density matrix of a microelectromechanical electrostatic spiral phase plate by mixed-state ptychography, from one four-dimensional STEM scan per state and without added hardware. The delivered beam is substantially mixed: its purity falls from approximately 0.47 to approximately 0.24 as the applied bias grows, inconsistent with a fixed lateral source-blur model, while the real-space coherence width stays near 1 nm. The same scans calibrate the device in situ, allow virtual orbital-angular-momentum sorting and, through a partial-coherence-aware transfer theory, indicate that purifying the output could improve dose efficiency roughly threefold. One acquisition thus becomes a quantum-state acceptance test for programmable electron optics, supplying the purity and coherence that emerging phase-plate and diffractive-imaging schemes assume but leave unquantified.

physics.optics↗

arXiv2026

Quantum tomography of inelastic electron scattering \emph{via} orbital angular momentum states

The physical properties of a quantum system, whether pure or mixed, are described fully by its density matrix. Recovery of the density matrix through projective measurements -- referred to as quantum state tomography -- is a cornerstone of quantum optics and metrology. The implementation of this approach in transmission electron microscopy, in particular for the characterisation of an electron beam after inelastic scattering, has remained a longstanding challenge as a result of the complexity of scanning high-dimensional phase spaces, with the number of required measurements growing quadratically with space dimensionality. Here, we introduce a simplified approach by restricting tomography to the electron orbital angular momentum (OAM) subspace. By using an electron optical device known as an OAM sorter, we discretise the phase space into a finite set of measurable states, thus significantly reducing the experimental and computational burden. The resulting measurements suffice to probe essential features of inelastic scattering. We demonstrate the technique by studying the inelastic scattering of a structured electron probe exciting volume plasmons in a carbon film. The combined use of a structured beams and OAM-resolved quantum tomography reveals symmetry-breaking effects and offers insight into the coherence and evolution of the scattered quantum states. Analysis of the diagonalised density matrices further reveals the nature of the induced state transitions, demonstrating the power of the approach for quantum tomography of electron scattering.

quant-ph↗

arXiv2026

Designing electrostatic MEMS-based electron optics: the case of the spiral phase plate

A new generation of microfabricated MEMS for electron optics is changing electron microscopy for the better. These devices allow operations on the electron beam that are impossible with conventional electron optics. Unprecedented phase landscapes like tunable spiral phase plates and localized strong phase gradients are just some examples of what can be achieved. This work establishes the methodological foundation to design and control MEMS based phase plates. The design strategy is rooted on a novel analytical and numerical modeling of thin electrodes with accurate account of the fringing fields having a major role in the thin-MEMS geometry. We designed, fabricated and characterized experimentally a spiral phase plate, and assessed the quality of the generated vortex beam while discussing the most relevant control parameters and design approaches.

physics.ins-det↗

arXiv2025

Realization of a Pre-Sample Photonic-based Free-Electron Modulator in Ultrafast Transmission Electron Microscopes

Spatial and temporal light modulation is a well-established technology that enables dynamic shaping of the phase and amplitude of optical fields, significantly enhancing the resolution and sensitivity of imaging methods. Translating this capability to electron beams is highly desirable within the framework of a transmission electron microscope (TEM) to benefit from the nanometer spatial resolution of these instruments. In this work, we report on the experimental realization of a photonic-based free-electron modulator integrated into the column of two ultrafast TEMs for pre-sample electron-beam shaping. Electron-photon interaction is employed to coherently modulate both the transverse and longitudinal components of the electron wave function, while leveraging dynamically controlled optical fields and tailored design of electron-laser-sample interaction geometry. Using energy- and momentum-resolved electron detection, we successfully reconstruct the shaped electron wave function at the TEM sample plane. These results demonstrate the ability to manipulate the electron wave function before probing the sample, paving the way for the future development of innovative imaging methods in ultrafast electron microscopy.

physics.optics↗

arXiv2022

Computational ghost imaging for transmission electron microscopy

While transmission electron microscopes (TEM) can achieve a much higher resolution than optical microscopes, they face challenges of damage to samples during the high energy processes involved. Here, we explore using computational ghost imaging techniques in electron microscopy to reduce the total required intensity. The technological lack of the equivalent high-resolution, optical spatial light modulator for electrons means that a different approach needs to be pursued. To this end, we show a beam shaping technique based on the use of a distribution of electrically charged metal needles to structure the beam, alongside a novel reconstruction method to handle the resulting highly non-orthogonal patterns. Second, we illustrate the application of this ghost imaging approach in electron microscopy. To test the full extent of the capabilities of this technique, we realised an analogous optical setup method. In both regimes, the ability to reduce the amount of total illumination intensity is evident in comparison to raster scanning.

physics.optics↗

arXiv2021

Theoretical and practical aspects of the design and production of synthetic holograms for transmission electron microscopy

Beam shaping - the ability to engineer the phase and the amplitude of massive and massless particles - has long interested scientists working on communication, imaging and the foundations of quantum mechanics. In light optics, the shaping of electromagnetic waves (photons) can be achieved using techniques that include, but are not limited to, direct manipulation of the beam source (as in X-ray Free Electron Lasers (XFELs) and Synchrotrons), deformable mirrors, spatial light modulators, mode converters and holograms. The recent introduction of holographic masks for electrons provides new possibilities for electron beam shaping. Their fabrication has been made possible by advances in micrometric and nanometric device production using lithography and focused ion beam patterning. This article provides a tutorial on the generation, production and analysis of synthetic holograms for transmission electron microscopy. It begins with an introduction to synthetic holograms, outlining why they are useful for beam shaping to study material properties. It then focuses on the fabrication of the required devices from theoretical and experimental perspectives, with examples taken from both simulations and experimental results. Applications of synthetic electron holograms as aberration correctors, electron vortex generators and spatial mode sorters are then presented.

physics.optics↗

arXiv2020

Focused Ion Beam fabrication of Janus bimetallic cylinders acting as drift~tube Zernike phase plates

Modern nanotechnology techniques offer new opportunities for fabricating structures and devices at the micron and sub-micron level. Here, we use focused ion beam techniques to realize drift tube Zernike phase plates for electrons, whose operation is based on the presence of contact potentials in Janus bimetallic cylinders, in a similar manner to the electrostatic Aharonov-Bohm effect in bimetallic wires. We use electron Fraunhofer interference to demonstrate that such bimetallic pillar structures introduce phase shifts that can be tuned to desired values by varying their dimensions, in particular their heights.

physics.ins-det↗

arXiv2019

Experimental demonstration of an electrostatic orbital angular momentum sorter for electrons

We report the first experimental demonstration of an electrostatic electron orbital angular momentum (OAM) sorter, which can be used to analyze the OAM states of electrons in a transmission electron microscope. We verify the sorter functionality for several electron beams possessing different superpositions of OAM states, and use it to record the electron beams OAM spectra. Our current electrostatic OAM sorter has an OAM resolution of 2 in the units of h/bar - the reduced Planck constant. It is expected to increase the OAM resolution of the sorter to the optimal resolution of 1 in the future via fine control of the sorting phase elements.

physics.ins-det↗