arXiv subjects

Patrick C. Mende

Publications and source records attributed to Patrick C. Mende.

4 recordsLinked to original sources

arXiv2018

Substitutional mechanism for growth of hexagonal boron nitride on epitaxial graphene

Monolayer-thick hexagonal boron nitride (h-BN) is grown on graphene on SiC(0001), by exposure of the graphene to borazine, (BH)3(NH)3, at 1100 C. The h-BN films form ~2-micrometer size grains with a preferred orientation of 30 degrees relative to the surface graphene. Low-energy electron microscopy is employed to provide definitive signatures of the number and composition of two-dimensional (2D) planes across the surface. These grains are found to form by substitution for the surface graphene, with the C atoms produced by this substitution then being incorporated below the h-BN (at the interface between the existing graphene and the SiC) to form a new graphene plane.

cond-mat.mes-hall↗

arXiv2016

Formation of hexagonal Boron Nitride on Graphene-covered Copper Surfaces

Graphene-covered copper surfaces have been exposed to borazine, (BH)3(NH)3, with the resulting surfaces characterized by low-energy electron microscopy. Although the intent of the experiment was to form hexagonal boron nitride (h-BN) on top of the graphene, such layers were not obtained. Rather, in isolated surface areas, h-BN is found to form micrometer-size islands that substitute for the graphene. Additionally, over nearly the entire surface, the properties of the layer that was originally graphene is observed to change in a manner that is consistent with the formation of a mixed h-BN/graphene alloy, i.e. h-BNC alloy. Furthermore, following the deposition of the borazine, a small fraction of the surface is found to consist of bare copper, indicating etching of the overlying graphene. The inability to form h-BN layers on top of graphene is discussed in terms of the catalytic behavior of the underlying copper surface and the decomposition of the borazine on top of the graphene.

cond-mat.mtrl-sci↗

arXiv2015

Probing critical point energies of transition metal dichalcogenides: surprising indirect gap of single layer $SL-WSe_2$

Understanding quasiparticle band structures of transition metal dichalcogenides (TMDs) is critical for technological advances of these materials for atomic layer electronics and photonics. Although theoretical calculations to date have shown qualitatively similar features, there exist subtle differences which can lead to important consequences in the device characteristics. For example, most calculations have shown that all single layer (SL) TMDs have direct band gaps, while some have shown that $SL-WSe_2$ have an indirect gap. Moreover, there are large variations in the reported quasiparticle gaps, corresponding to large variations in exciton binding energies. By using a comprehensive form of scanning tunneling spectroscopy, we have revealed detailed quasiparticle electronic structures in TMDs, including the quasi-particle gaps, critical point energy locations and their origins in the Brillouin Zones (BZs). We show that $SL-WSe_2$ actually has an indirect quasi-particle gap with the conduction band minimum located at the Q point (instead of K), albeit the two states are nearly degenerate. Its implications on optical properties are discussed. We have further observed rich quasi-particle electronic structures of TMDs as a function of atomic structures and spin-orbital couplings.

cond-mat.mes-hall↗

arXiv2014

Molecular beam epitaxial growth of MoSe2 on graphite, CaF2 and graphene

We report the structural and optical properties of molecular beam epitaxy (MBE) grown 2-dimensional (2D) material molybdenum diselenide (MoSe2) on graphite, CaF2 and epitaxial graphene. Extensive characterizations reveal that 2H- MoSe2 grows by van-der-Waals epitaxy on all 3 substrates with a preferred crystallographic orientation and a Mo:Se ratio of 1:2. Photoluminescence at room temperature (~1.56 eV) is observed in monolayer MoSe2 on both CaF2 and epitaxial graphene. The band edge absorption is very sharp, <60 meV over 3 decades. Overcoming the observed small grains by promoting mobility of Mo atoms would make MBE a powerful technique to achieve high quality 2D materials and heterostructures.

cond-mat.mtrl-sci↗