arXiv subjects

Patrick Godwin

Publications and source records attributed to Patrick Godwin.

30 records · Page 2Linked to original sources

arXiv2021

Point absorbers in Advanced LIGO

Small, highly absorbing points are randomly present on the surfaces of the main interferometer optics in Advanced LIGO. The resulting nano-meter scale thermo-elastic deformations and substrate lenses from these micron-scale absorbers significantly reduces the sensitivity of the interferometer directly though a reduction in the power-recycling gain and indirect interactions with the feedback control system. We review the expected surface deformation from point absorbers and provide a pedagogical description of the impact on power build-up in second generation gravitational wave detectors (dual-recycled Fabry-Perot Michelson interferometers). This analysis predicts that the power-dependent reduction in interferometer performance will significantly degrade maximum stored power by up to 50% and hence, limit GW sensitivity, but suggests system wide corrections that can be implemented in current and future GW detectors. This is particularly pressing given that future GW detectors call for an order of magnitude more stored power than currently used in Advanced LIGO in Observing Run 3. We briefly review strategies to mitigate the effects of point absorbers in current and future GW wave detectors to maximize the success of these enterprises.

physics.ins-det↗

arXiv2021

First demonstration of early warning gravitational wave alerts

Gravitational-wave observations became commonplace in Advanced LIGO-Virgo's recently concluded third observing run. 56 non-retracted candidates were identified and publicly announced in near real time. Gravitational waves from binary neutron star mergers, however, remain of special interest since they can be precursors to high-energy astrophysical phenomena like $γ$-ray bursts and kilonovae. While late-time electromagnetic emissions provide important information about the astrophysical processes within, the prompt emission along with gravitational waves uniquely reveals the extreme matter and gravity during - and in the seconds following - merger. Rapid communication of source location and properties from the gravitational-wave data is crucial to facilitate multi-messenger follow-up of such sources. This is especially enabled if the partner facilities are forewarned via an early-warning (pre-merger) alert. Here we describe the commissioning and performance of such a low-latency infrastructure within LIGO-Virgo. We present results from an end-to-end mock data challenge that detects binary neutron star mergers and alerts partner facilities before merger. We set expectations for these alerts in future observing runs.

astro-ph.HE↗

arXiv2020

Automating the Inclusion of Subthreshold Signal-to-Noise Ratios for Rapid Gravitational-Wave Localization

The accurate localization of gravitational-wave (GW) events in low-latency is a crucial element in the search for further multimessenger signals from these cataclysmic events. The localization of these events in low-latency uses signal-to-noise ratio (SNR) time-series from matched-filtered searches which identify candidate events. Here we report on an improvement to the GstLAL-based inspiral pipeline, the low-latency pipeline that identified GW170817 and GW190425, which automates the use of SNRs from all detectors in the network in rapid localization of GW events. This improvement was incorporated into the detection pipeline prior to the recent third observing run of the Advanced LIGO and Advanced Virgo detector network. Previously for this pipeline, manual intervention was required to use SNRs from all detectors if a candidate GW event was below an SNR threshold for any detector in the network. The use of SNRs from subthreshold events can meaningfully decrease the area of the 90% confidence region estimated by rapid localization. To demonstrate this, we present a study of the simulated detections of $\mathcal{O}(2\times10^4)$ binary neutron stars using a network mirroring the second observational run of the Advanced LIGO and Virgo detectors. When incorporating subthreshold SNRs in rapid localization, we find that the fraction of events that can be localized down to $100~\mathrm{deg}^2$ or smaller increases by a factor 1.18.

astro-ph.IM↗

arXiv2020

Incorporation of Statistical Data Quality Information into the GstLAL Search Analysis

We present updates to GstLAL, a matched filter gravitational-wave search pipeline, in Advanced LIGO and Virgo's third observing run. We discuss the incorporation of statistical data quality information into GstLAL's multi-dimensional likelihood ratio ranking statistic and additional improvements to search for gravitational wave candidates found in only one detector. Statistical data quality information is provided by iDQ, a data quality pipeline that infers the presence of short-duration transient noise in gravitational-wave data using the interferometer's auxiliary state, which has operated in near real-time since before LIGO's first observing run in 2015. We look at the performance and impact on noise rejection by the inclusion of iDQ information in GstLAL's ranking statistic, and discuss GstLAL results in the GWTC-2 catalog, focusing on two case studies; GW190424A, a single-detector gravitational-wave event found by GstLAL and a period of time in Livingston impacted by a thunderstorm.

gr-qc↗

arXiv2020

GstLAL: A software framework for gravitational wave discovery

The GstLAL library, derived from Gstreamer and the LIGO Algorithm Library, supports a stream-based approach to gravitational-wave data processing. Although GstLAL was primarily designed to search for gravitational-wave signatures of merging black holes and neutron stars, it has also contributed to other gravitational-wave searches, data calibration, and detector-characterization efforts. GstLAL has played an integral role in all of the LIGO-Virgo collaboration detections, and its low-latency configuration has enabled rapid electromagnetic follow-up for dozens of compact binary candidates.

astro-ph.IM↗

arXiv2020

An early warning system for electromagnetic follow-up of gravitational-wave events

Binary neutron stars (BNSs) will spend $\simeq 10$ -- 15 minutes in the band of Advanced LIGO and Virgo detectors at design sensitivity. Matched-filtering of gravitational-wave (GW) data could in principle accumulate enough signal-to-noise ratio (SNR) to identify a forthcoming event tens of seconds before the companions collide and merge. Here we report on the design and testing of an early warning gravitational-wave detection pipeline. Early warning alerts can be produced for sources that are at low enough redshift so that a large enough SNR accumulates $\sim 10 - 60\,\rm s$ before merger. We find that about 7% (respectively, 49%) of the total detectable BNS mergers will be detected $60\, \rm s$ ($10\, \rm s$) before the merger. About 2% of the total detectable BNS mergers will be detected before merger and localized to within $100\, \rm \text{deg}^2$ (90% credible interval). Coordinated observing by several wide-field telescopes could capture the event seconds before or after the merger. LIGO-Virgo detectors at design sensitivity could facilitate observing at least one event at the onset of merger.

astro-ph.HE↗

arXiv2020

Improving the background estimation technique in the GstLAL inspiral pipeline with the time-reversed template bank

Background estimation is important for determining the statistical significance of a gravitational-wave event. Currently, the background model is constructed numerically from the strain data using estimation techniques that insulate the strain data from any potential signals. However, as the observation of gravitational-wave signals become frequent, the effectiveness of such insulation will decrease. Contamination occurs when signals leak into the background model. In this work, we demonstrate an improved background estimation technique for the searches of gravitational waves (GWs) from binary neutron star coalescences by time-reversing the modeled GW waveforms. We found that the new method can robustly avoid signal contamination at a signal rate of about one per 20 seconds and retain a clean background model in the presence of signals.

astro-ph.IM↗

arXiv2020

iDQ: Statistical Inference of Non-Gaussian Noise with Auxiliary Degrees of Freedom in Gravitational-Wave Detectors

Gravitational-wave detectors are exquisitely sensitive instruments and routinely enable ground-breaking observations of novel astronomical phenomena. However, they also witness non-stationary, non-Gaussian noise that can be mistaken for astrophysical sources, lower detection confidence, or simply complicate the extraction of signal parameters from noisy data. To address this, we present iDQ, a supervised learning framework to autonomously detect noise artifacts in gravitational-wave detectors based only on auxiliary degrees of freedom insensitive to gravitational waves. iDQ has operated in low latency throughout the advanced detector era at each of the two LIGO interferometers, providing invaluable data quality information about each detection to date in real-time. We document the algorithm, describing the statistical framework and possible applications within gravitational-wave searches. In particular, we construct a likelihood-ratio test that simultaneously accounts for the presence of non-Gaussian noise artifacts and utilizes information from both the observed gravitational-wave strain signal and thousands of auxiliary degrees of freedom. We also present several examples of iDQ's performance with modern interferometers, showing iDQ's ability to autonomously reproduce known data quality monitors and identify noise artifacts not flagged by other analyses.

astro-ph.IM↗

arXiv2020

A self-consistent method to estimate the rate of compact binary coalescences with a Poisson mixture model

The recently published GWTC-1 - a journal article summarizing the search for gravitational waves (GWs) from coalescing compact binaries in data produced by the LIGO-Virgo network of ground-based detectors during their first and second observing runs - quoted estimates for the rates of binary neutron star, neutron star black hole binary, and binary black hole mergers, as well as assigned probabilities of astrophysical origin for various significant and marginal GW candidate events. In this paper, we delineate the formalism used to compute these rates and probabilities, which assumes that triggers above a low ranking statistic threshold, whether of terrestrial or astrophysical origin, occur as independent Poisson processes. In particular, we include an arbitrary number of astrophysical categories by redistributing, via mass-based template weighting, the foreground probabilities of candidate events, across source classes. We evaluate this formalism on synthetic GW data, and demonstrate that this method works well for the kind of GW signals observed during the first and second observing runs.

astro-ph.HE↗

arXiv2019

Fast evaluation of multi-detector consistency for real-time gravitational wave searches

Gravitational waves searches for compact binary mergers with LIGO and Virgo are presently a two stage process. First, a gravitational wave signal is identified. Then, an exhaustive search over possible signal parameters is performed. It is critical that the identification stage is efficient in order to maximize the number of gravitational wave sources that are identified. Initial identification of gravitational wave signals with LIGO and Virgo happens in real-time which requires that less than one second of computational time must be used for each one second of gravitational wave data collected. In contrast, subsequent parameter estimation may require hundreds of hours of computational time to analyze the same one second of gravitational wave data. The real-time identification requirement necessitates efficient and often approximate methods for signal analysis. We describe one piece of real-time gravitational-wave identification: an efficient method for ascertaining a signal's consistency between multiple gravitational wave detectors suitable for real-time gravitational wave searches for compact binary mergers. This technique was used in analyses of Advanced LIGO's second observing run and Advanced Virgo's first observing run.

gr-qc↗

arXiv2019

Sub-threshold binary neutron star search in Advanced LIGO's first observing run

We present a search for gravitational waves from double neutron star binaries inspirals in Advanced LIGO's first observing run. The search considers a narrow range of binary chirp masses motivated by the population of known double neutron star binaries in the nearby universe. This search differs from previously published results by providing the most sensitive published survey of neutron stars in Advanced LIGO's first observing run within this narrow mass range and including times when only one of the two LIGO detectors was in operation in the analysis. The search was sensitive to binary neutron star inspirals to an average distance of ~85 Mpc over 93.2 days. We do not identify any unambiguous gravitational wave signals in our sample of 103 sub-threshold candidates with false-alarm-rates of less than one per day. However, given the expected binary neutron star merger rate of R = 100 - 4000 Gpc^(-3) yr^(-1), we expect O(1) gravitational wave events within our candidate list. This suggests the possibility that one or more of these candidates is in fact a binary neutron star merger. Although the contamination fraction in our candidate list is ~99%, it might be possible to correlate these events with other messengers to identify a potential multi-messenger signal. We provide an online candidate list with the times and sky locations for all events in order to enable multi-messenger searches.

gr-qc↗

arXiv2019

The GstLAL Search Analysis Methods for Compact Binary Mergers in Advanced LIGO's Second and Advanced Virgo's First Observing Runs

After their successful first observing run (September 12, 2015 - January 12, 2016), the Advanced LIGO detectors were upgraded to increase their sensitivity for the second observing run (November 30, 2016 - August 26, 2017). The Advanced Virgo detector joined the second observing run on August 1, 2017. We discuss the updates that happened during this period in the GstLAL-based inspiral pipeline, which is used to detect gravitational waves from the coalescence of compact binaries both in low latency and an offline configuration. These updates include deployment of a zero-latency whitening filter to reduce the over-all latency of the pipeline by up to 32 seconds, incorporation of the Virgo data stream in the analysis, introduction of a single-detector search to analyze data from the periods when only one of the detectors is running, addition of new parameters to the likelihood ratio ranking statistic, increase in the parameter space of the search, and introduction of a template mass-dependent glitch-excision thresholding method.

gr-qc↗