arXiv subjects

Patrick Perrin

Publications and source records attributed to Patrick Perrin.

4 recordsLinked to original sources

arXiv2025

pH-dependent interfacial rheology of polymer membranes assembled at liquid-liquid interfaces using hydrogen bonds

Self-assembly of polymers at liquid interfaces using non-covalent interactions has emerged as a promising technique to reversibly produce self-healing membranes. Besides the assembly process, it is also crucial to control the mechanical properties of these membranes. Here, we measure the interfacial rheological properties of PMAA-PPO (polymethacrylic acid - polypropylene oxide) polymer membranes assembled using hydrogen bonds at the interface between water and a polar oil, Mygliol. Varying the pH enables us to modify the degree of ionization of the PMAA chains, and hence their ability to establish hydrogen interactions with PPO. Frequency sweeps of the interfacial layers show a crossover between a viscous regime at low frequencies and an elastic regime at high frequencies. The crossover elastic modulus, measured one hour after the two phases were put into contact, decreases by a half over the pH range investigated, which can be accounted for by a decrease of the layer thickness as pH increases. Furthermore, we find that the crossover frequency varies exponentially with the degree of ionization of PMAA. To account for these observations, we propose a simple picture where the short PPO chains behave as non-covalent cross-linkers that bridge several PMAA chains. The dissociation rate and hence the crossover frequency are controlled by the number of PO units per PPO chain involved in the hydrogen bonds.

cond-mat.soft↗

arXiv2024

Growth of membranes formed by associating polymers at interfaces

Polymer association at liquid-liquid interfaces is a promising way to spontaneously obtain soft self-healing membranes. In the case of reversible bonding between two polymers, the macromolecules are mobile everywhere within the membrane and they can be absorbed into it at both boundaries due to binding to macromolecules of the other type. In this work, we develop the theoretical model of membrane growth based on these assumptions. The asymptotic dependence of membrane thickness on time as h ~ t^(1/2), as typically observed in experiments in a stationary regime, reveals an interdiffusion-controlled process, where the polymer fluxes sustain the polymer absorption at the membrane boundaries. The membrane growth rate is mainly determined by the difference in equilibrium compositions at the boundaries, the association constant, the polymer lengths and mobilities. This model is further used to describe the growth of hydrogel membranes formed via H-bonding of polymers at the interface between a solution of poly(propylene oxide) (PPO) in isopropyl myristate and an aqueous solution of poly(methacrylic acid) (PMAA). The film thickness is measured by reflectometric methods. The dependence of thickness on time can be approximated by the power law t^(beta), where beta= 1/2 for the PMAA solution at pH=3 and decreases with increasing pH and, hence, ionization degree. The growth rate slows down about 25 times for 500-nm-thick films at pH = 5.1 compared to the case of pH = 3. The ionization degree of PMAA solutions was studied by potentiometric methods. Even a small change in ionization was found to influence the growth rate of the film. A slowdown of the film growth for the ionized polymer can be explained by a drop in the composition gradient in the membrane, as is predicted by the proposed model.

cond-mat.soft↗

arXiv2017

Adsorption dynamics of hydrophobically modified polymers at an air-water interface

Using surface-tension measurements, we study the brush-limited adsorption dynamics of a range of amphiphilic polymers, PAAH-$\alpha$-$\textrm{C}_n$ composed of a poly(acrylic acid) backbone, PAAH, grafted with a fraction $\alpha$ of alkyl moieties, containing either $n=8$ or $n=12$ carbon atoms, at pH conditions where the PAAH backbone is not charged. At short times, the surface tension decreases more sharply as the degree of grafting increases while at long times, the adsorption dynamics becomes logarithmic in time and is slower as the degree of grafting increases. This logarithmic behavior at long times indicates the building of a free-energy barrier which grows over time. To account for the observed surface tension evolution with the degree of grafting we propose a scenario, where the free-energy barrier results from both the deformation of the incoming polymer coils and the deformation of the adsorbed brush. Our model involves only two fitting parameters, the monomer size and the area needed for one molecule during adsorption and is in agreement with the experimental data. We obtain a reasonable value for the monomer size and find an area per adsorbed polymer chain of the order of 1nm$^2$, showing that the polymer chains are strongly stretched as they adsorb.

cond-mat.soft↗

arXiv2017

One-Step Fabrication of pH-Responsive Membranes and Microcapsules through Interfacial H-Bond Polymer Complexation

Biocompatible microencapsulation is of widespread interest for the targeted delivery of active species in fields such as pharmaceuticals, cosmetics and agro-chemistry. Capsules obtained by the self-assembly of polymers at interfaces enable the combination of responsiveness to stimuli, biocompatibility and scaled up production. Here, we present a one-step method to produce in situ membranes at oil-water interfaces, based on the hydrogen bond complexation of polymers between H-bond acceptor and donor in the oil and aqueous phases, respectively. This robust process is realized through different methods, to obtain capsules of various sizes, from the micrometer scale using microfluidics or rotor-stator emulsification up to the centimeter scale using drop dripping. The polymer layer exhibits unique self-healing and pH-responsive properties. The membrane is viscoelastic at pH = 3, softens as pH is progressively raised, and eventually dissolves above pH = 6 to release the oil phase. This one-step method of preparation paves the way to the production of large quantities of functional capsules.

cond-mat.soft↗